Injection mold specification Client Fuji Model Name Fuji_xerox Part Name Hsg-base-fr-250 Part No. 802b089270 DFM Ming L.

Integral Corrective Action List ICAL Page OPEN POINTS SOLUTIONS/ACTION WHO 1 2 3 4 Plastic flow analysis Please confirm? Parting _ line 5 6 Undercut Reduce plastic? 7 Sink mark 8 9 Sharp steel Cancel R? 10 Thin steel 11 12 13 No draft I C A L Integral Corrective Action List 1-Date of opening (all dates in2005) 2-Date of beginning of action 3-Date foreseen for validation 4-Date of validation (closing) DFME Follow-up issue

Plastic Flow Analysis Gate Weld line Recess 0.5mm 3x SECTION A-A

Parting _ line PL PL PL PL PL PL PL PL

Parting _ line Parting line Lifter These ribs surface the most polish.

Original changed OK? Reduce plastic OK? undercut Left&Right sides same Modify-1 Original changed OK? SLIDE Reduce plastic OK? undercut Left&Right sides same

Thick plastic cause sink mark. Reduce plastic like this. Modify-2 Thick plastic cause sink mark. Reduce plastic like this.

Pls Review the detail in the next one page Modify-3 Pls Review the detail in the next one page

Modify-3 Sharp steel Cancel R Original Changed

Thin steel .Reduce plastic like this. Modify-4 Thin steel .Reduce plastic like this. 4mm OK? Left&Right sides same 15mm

Red ribs are too thick.Reduce plastic like that. Modify-5 OK? Red ribs are too thick.Reduce plastic like that. Shell Rib

Red area too thick plastic . They cause sink mark Modify-6 Red area too thick plastic . They cause sink mark

This rib draft like that. All of other no draft surface reduce plastic like that.