TH-57 Fuel System Review.

Slides:

Advertisements

Similar presentations

FUEL SUPPLY SYSTEM.

Advertisements

An Introduction To Marine Steam Propulsion Plant [Source: US Navy]

Steam and Water Accessories

Dennis Fire Appliances Operations & use. PTO Step 1 Move slide cover towards the drivers seat to lock out the gearbox Step 2 Select drive on the gear.

Cooling System Get the engine up to optimum operating Temperature as quickly as possible and maintains it at that temperature. Controls the heat produced.

UL/FM Fire Pump Systems Lunch & Learn 04/18/05

crdi common rail direct injection by: sahal m mansuri and joshi maulik

Pressurized Portable Marine Fuel Tanks Mark Riechers.

Basics of Pump Vigyan Ashram, Pabal.

Dakota Nickerson, Kyle Pflueger, Adam Leschber, Andrew Dahlke M.E. Undergrad 1.

TIMING THE CAM TO THE CRANK u Timing marks facing each other u Timing marks a specified number of links apart u Timing marks aligned with colored links.

Direct Cross-Connection (a) A Clean-In-Place system is used to direct sanitizer from a reservoir to a recently cleaned milk tank. The sanitizer exists.

JET PROPULSION Part 6 Jet Engine Operation Fuel Systems.

TH-57 Transmission / Hydraulic Review

What is going on inside a packed stuffing box?

1 Fuel Pumps. 2 Pumps 1.All oil burners for residential heating have pumps A. They are connected to a motor through a coupling 2.Description A. An oil.

FUEL INJECTION SYSTEM OPERATION

Part F Practical Applications. 29. Flow over a Heat Sink Physical System Pressure drop and heat transfer characteristics of heat sinks are determined.

Heating and Air-Conditioning

Fire Pump Functions The main function of a fire pump is to increase the pressure of the water that flows through it. Inadequate or nonexistent municipal.

Dewatering Equipment.

Automotive Brake Systems, 5/e By James D. Halderman Copyright © 2010, 2008, 2004, 2000, 1995 Pearson Education, Inc., Upper Saddle River, NJ All.

STUDY OF BOILER’S ACCESSORIES

APPROVED TRAINING MANUAL’S LESSON PLANS AND COURSEWARE STAR MARIANAS AIR, INC. Recurrent – Flight Crew Part III – Aircraft Ground Training Section 2 –

Propellers The engines are equipped with four bladed, full

Zagazig University Faculty of Engineering Mechanical power Dept. Zagazig University Faculty of Engineering Mechanical power Dept. DEISEL INJECTION SYSTEM.

Components of 4-stroke Engine Created by:- Prashanth Nair Sawan Makwana Jigar Chauhan Harshil Gohel Saumil Joshi.

CH-47D Auxiliary Power Unit

Chrysler History Logic Module Power Module SMEC 1997 SBEC 1989 SBEC II 1991.

WELCOME TO CRAZYMECHANICAL.COM.

Thrust Augmentation BASIC OPERATION Power Boosting.

Condensers and Evaporators

TH-57 Fuel System Review.

PRESENTED BY : N.SRIKAUSIGARAMAN

© 2011 Pearson Education, Inc. All Rights Reserved Automotive Technology, Fifth Edition James Halderman GASOLINE DIRECT- INJECTION SYSTEMS 79.

Fuel System Carburetor A device that mixes air and fuel in correct proportion for efficient combustion. Stoichiometric Ratio 14.7 : 1 (Air : Fuel)

STBD. BOAT DECK MONITOR HEAVY CORROSION FOUND INSIDE ELECTRICAL MOTORS RENDERING THE MONITOR NON-OPERATIONAL.

1. Gear housing 2. Engine dataplate 3. Air intake 4. Fuel pump 5. Fuel filter 6. Starter 7. Lube oil pan 8. Lube oil drain 9. Crankshaft timing pin port.

Engine Speed Amps Engine Temp. Engine Oil Pr. Trans. Fluid Pr. Battery overheat Engine overheat Exhaust hose overheatExhaust overheat Low oil pressure.

Power Brakes chapter 62. Power Brakes FIGURE 62.1 Typical vacuum brake booster assembly. The vacuum hose attaches to the intake manifold of the engine.

CAR PROBLEMS? BY: KYLE KIMBALL. ALL CARS ARE DIFFERENT. FROM THE FORD MUSTANG TO THE GEO METRO, WE KNOW THAT ALL CARS ARE BUILT DIFFERENTLY. SOME ARE.

FLIGHT CONTROLS AND HYDRAULICS. FLIGHT CONTROLS The flight control systems are mechanical linkages, actuated by conventional controls, and are used to.

Automotive Engine Performance, 3/e By James D. Halderman Copyright © 2010, 2007, 2003 Pearson Education, Inc., Upper Saddle River, NJ All rights.

FUEL SYSTEM The fuel system is comprised of three interconnected crash resistant fuel cells. Two forward fuel cells are located under the aft facing passenger.

By John Templeton.  Definition- the science that deals with the laws governing water or other liquids in motion and their applications in engineering;

Chapter 39 Cooling System Fundamentals.

UH-60A/L Fuel System.

ENGINEERING ADVENTUREwww.BLOODHOUNDSSC.com BLOODHOUND SSC ATSM AIR INLET ASSEMBLY FOR THE AMAD GEARBOX The following explains the ATSM assembly and some.

CW2 Scott Turvey UH-60 IPC UNCLASSIFIED

UNIT III ENGINE SYSTEMS

Fuel Systems The gravity feed fuel system is only suitable for high-wing aircraft. The tanks are mounted in the wings above the engine, with gravity causing.

Fuel-Injection Systems

PNEUMATICS Chapter 3 ROTARY COMPRESSORS

TH-57 Transmission / Hydraulic Review

Figure 36.1 A gasoline direct-injection (GDI) system injects fuel under high pressure directly into the combustion chamber.

Date of download: 10/22/2017 Copyright © ASME. All rights reserved.

Figure 24.1 A gasoline direct-injection (GDI) system injects fuel under high pressure directly into the combustion chamber.

FIGURE Typical vacuum brake booster assembly

PA-28R-201 Systems Andy Philbin.

Effective Methods to Test the Fuel Pressure Regulator in your Car.

SB Packing Automatic Downpuller Power Unit

COMMON RAIL FUEL INJECTION SYSTEM

PCV and EVAP Emission Control Systems

CAFS On-Line Orientation

Automotive Technology Principles, Diagnosis, and Service

Fuel-Injection Systems

Presentation transcript:

TH-57 Fuel System Review

The two electrical boost pumps installed inside the fuel cell are interconnected by a hose so that they can furnish pressurized fuel through a single line to the engine-driven fuel pump. This pressurization prevents in-line vaporization above 6,000 Pressure Altitude.

The engine fuel pump is located on the aft port side of the power accessory gearbox. Fuel enters at the inlet port of the pump and passes through a low pressure inlet at 4 to 30 PSI to the gear element of the fuel pump. The engine driven fuel pump pressurizes fuel at 650-750 psi and passes it to the fuel control unit.

14.10 SUSPECTED FUEL LEAKAGE