AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra Remove seat from vehicle Remove rocker panel covers (both front and rear) Remove B-pillar cover and re-attach seatbelt anchor to B-pillar, remove door panel 4 Tuck OEM wire harness in and pull through carpet by heat duct as shown AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra 5 5 Remove seat risers by drilling out rivets and spot welds. Use ¼” drill. AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra Seat tracks should look like this after drilling 7 AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

8 9 AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra Place ER into vehicle as shown Modify and reinstall B-pillar cover accordingly 9 Tuck OEM wire harness under ER as shown to come out at rear of ER AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra 10 Manually rotate ER out to install OEM seat onto ER seat base 11. Use ¼-20 x ½ button head bolts to bolt seat onto ER. (Two each side at rear of tracks, one each side at front of tracks.) AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra 12 Slide seat all the way back. Manually rotate seat into vehicle as shown. 13 If required cut door panel here and finish AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra

AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra 14. Attach OEM wire harness under seat using cable ties and connect plugs to seat position sensor and seatbelt latch. Be sure that wires do not interfere with the seat sliding forward and backward, nor with the operation of the Easy-Reach. AU Media/ER/Toyota/Tech/Gen 7/06 Toyota Tundra