Humidification systems for high-flow cannulas.

Slides:

Advertisements

Similar presentations

Oxygen Therapy.

Advertisements

Rhonda Contant, BScH, RRT

Oxygen Therapy Equipment.

 H. Arthur Sadhanandham Medical ICU. CMC. Vellore .

Respiratory Therapy Equipment Adnan Mohemmed S6 AE.

Effect of nasal positive expiratory pressure (PEP) on 6-min walk test (6MWT) distance and pre- to post-exercise increase in lung volumes in each individual.

Aerosol Therapy & HFNC Natalie Napolitano, MPH, RRT-NPS, FAARC

Oxygen Therapy.

The changes in peak flow and inspiratory time between a minimum rise time (first 2 breaths) and a maximum rise time (last 2 breaths), with the Servo-i.

Airway pressure and flow waveforms during constant flow volume control ventilation, illustrating the effect of an end-inspiratory breath-hold. Airway pressure.

Example ventilator screen during nasal neurally adjusted ventilatory assist in a premature neonate (23 weeks gestational age, 560 g) with respiratory distress.

Spearman rank correlation between absolute humidity and the patient's core temperature with the Humid-Heat device. Spearman rank correlation between absolute.

A.F. McNarry, A. Patel British Journal of Anaesthesia

HomeLOX liquid oxygen system, which creates oxygen from a concentrator and refrigerates the concentrator gas to a liquid state, which is stored in a small.

The Spectrum mask incorporates the leak port into the circuit, whereas the Mirage mask incorporates the leak port into the mask. The Spectrum mask incorporates.

High-flow nasal oxygen therapy in intensive care and anaesthesia

Picture of bubble PEP devices.

A ventilator and TTL test lung were used to simulate spontaneous breathing. A ventilator and TTL test lung were used to simulate spontaneous breathing.

The high flow nasal cannula (HFNC) system incorporated an air/O2 blender with a flow meter and a heated humidifier. The high flow nasal cannula (HFNC)

Cuff-pressure changes after the addition of 5 mL and 10 mL of air into the cuff of 3 artificial airways, after initial baseline of 30 cm H2O established.

An example of delayed cycling during pressure-support ventilation of a patient with COPD, on a Puritan Bennett 7200 ventilator, which has a flow-termination.

Use of continuous nasal ventilation in a young man with Duchenne muscular dystrophy and excessively weak buccal musculature. Use of continuous nasal ventilation.

Representative example of the use of a fiberoptic bronchoscope (FOB) to guide intubation through a supraglottic airway device. Representative example of.

Example airway pressure and rib-cage impedance in a premature infant supported with the biphasic mode of SiPAP (“sigh” positive airway pressure) from the.

Simulated screenshot of flow starvation in volume control continuous mandatory ventilation. Simulated screenshot of flow starvation in volume control continuous.

A: The Parker Flex-Tip tube (left) has a flexible tip pointing toward the center of the distal lumen. A: The Parker Flex-Tip tube (left) has a flexible.

Classic technique for insertion of a laryngeal mask airway (LMA) device. Classic technique for insertion of a laryngeal mask airway (LMA) device. With.

An example of a technologist proficiency report.

Sensitivity, Specificity, Positive Predictive Value, Negative Predictive Value, Area Under the Curve, and 95% CIs for the 0, 10, 25, 50, and 100 SatSeconds.

In this tracing of 30 seconds, 4 breaths are ineffectively triggered (arrows IT) and 7 are effectively triggered. In this tracing of 30 seconds, 4 breaths.

Effect of respiratory mechanics on cycling of pressure support from inhalation to exhalation. Effect of respiratory mechanics on cycling of pressure support.

Flow, esophageal pressure, airway pressure, and transpulmonary pressure can be used to calculate respiratory system compliance, chest-wall compliance,

We connected the supplemental oxygen supply at 3 places: near the ventilator, near the exhalation valve, and on the nasal mask port. We connected the supplemental.

Changes in PaO2/FIO2 (A) and PaCO2 (B).

The curved Macintosh blade and straight Miller blade in standard adult sizes (Macintosh size 3, Miller size 2), with different handle choices available.

Blom speech cannula. Blom speech cannula. Inspiratory pressure opens the flap valve and closes (expands) the bubble valve, sealing the fenestration so.

The test of change goal was to shorten the time between the last respiratory therapist (RT) assessment/bronchodilator treatment given in the emergency.

The Boussignac continuous positive airway pressure (CPAP) is a small plastic cylinder that attaches to a face mask. The Boussignac continuous positive.

Control circuit for set-point or dual targeting schemes.

Assembly used to convert a standard ventilator to an intermittent mandatory ventilation circuit. Assembly used to convert a standard ventilator to an intermittent.

Blind intubation through a supraglottic airway device (SAD), in this case, the laryngeal mask airway (LMA) Fastrach. Blind intubation through a supraglottic.

Breathing frequency and PaCO2: comparison between high-flow nasal cannula oxygen therapy (HFNC) and comparative therapies in 8 studies. Breathing frequency.

Screen shot of test acceptability and reproducibility for spirometry (upper panel) and diffusion capacity of the lung for carbon monoxide (DLCO) (lower.

Control circuit for a servo targeting scheme (eg, Proportional Assist Ventilation). Control circuit for a servo targeting scheme (eg, Proportional Assist.

Intra-device comparison of albuterol captured at the end of the endotracheal tube (lung dose). Intra-device comparison of albuterol captured at the end.

Inter-device comparison

A novel multi-channeled neonatal patient Y-piece device (AFECTAIR) developed as part of an aerosolized lung surfactant administration system to be used.

A: ECMO circuit tubing with component pieces in place, configured with a centrifugal pump. A: ECMO circuit tubing with component pieces in place, configured.

A: Evolution of clinically observed signs after 38 patients received high-flow nasal cannula oxygen. A: Evolution of clinically observed signs after 38.

SpO2 at baseline, pre- and post-intubation.

Plots of alveolar PO2, hemoglobin saturation, and alveolar PCO2 as a function of alveolar ventilation in a normal subject at sea level (inspired oxygen.

Components of a patient-triggered mechanical breath.

Physical variables affecting FIO2 of nasal cannula with increasing breathing frequency (f), at flows from 1–5 L/min. Physical variables affecting FIO2.

Spirometry test quality, reported as a grade point average, for the pulmonary function technicians, in the first 40 months of the Lung Health Study. Spirometry.

Sequence plot visualizing the development of symptom frequency for the cohort at the individual level between 2006 and Sequence plot visualizing.

The changes in peak flow and inspiratory time between a minimum rise time (first 2 breaths) and a maximum rise time (last 2 breaths), with the Servo-i.

Diametrical differences between percutaneous dilatational tracheostomy loading dilators and percutaneous tracheostomy tubes. Diametrical differences between.

Plot of the surface tension (γ) and area.

Experimental setup. Experimental setup. Each tested ventilator was connected to the TTL test lung via a ventilator circuit. An oxygen analyzer, a pressure.

Boundary graph for prescription flow (Qp) and supply flow (Qs).

For inspiratory load compensation testing, this threshold positive expiratory pressure (PEP) training device was inverted and connected to a respiratory.

Delivery efficiency with different devices, ventilator positions, and ventilator settings. Delivery efficiency with different devices, ventilator positions,

Efficiency of aerosol bronchodilator delivery during continuous high-flow system at different CPAP and flow levels. Efficiency of aerosol bronchodilator.

Lung model expiratory CO2 (or PETOv2) representing simulated alveolar CO2 at baseline (no high-flow nasal cannula) and effect on expiratory CO2 at different.

A: Comparison of pediatric lung transplant survival between different age groups. A: Comparison of pediatric lung transplant survival between different.

Average drug doses in the peripheral lung, central lung, and extrathoracic airway; residual drug left in the device; and residual drug that was exhaled.

Basic setup for high-flow nasal cannula oxygen delivery.

Percent of extremely-low-birth-weight (ELBW) babies alive and off mechanical ventilation at 7 days, and median days on mechanical ventilation for ELBW.

Setup of the BiPAP Synchrony with an inspiratory filter and single-limb passive circuit, with the filter placed over the fixed leak to collect aerosol.

Mean nasopharyngeal pressure during high-flow oxygen therapy, with mouth open or closed. Mean nasopharyngeal pressure during high-flow oxygen therapy,

Presentation transcript:

Humidification systems for high-flow cannulas. Humidification systems for high-flow cannulas. A: High-flow bubble humidifier. (Courtesy of Salter Labs.) B: Vapotherm 2000i heated humidifier with continuous feed system and high-flow air/O2 blender (BL S2001-HF) with click-style flow meter (FM40). (Courtesy of Vapotherm.) C: Fisher & Paykel 850 heated humidifier (Courtesy of Fisher & Paykel) and Maxtec MaxVenturi combination O2/air entrainment device, oxygen analyzer, and flow meter with single-limb heated-wire circuit. D: Comfort Flo humidification system. (Courtesy of Teleflex Medical.) E: Aquinox high-flow humidification system. (Courtesy of Smiths Medical.) F: Pari Hydrate humidification system for high-flow nasal cannula. (Courtesy of Pari Respiratory Equipment.) G: Vapotherm Precision Flow humidification system. (Courtesy of Vapotherm.)‏ Jeffrey J Ward Respir Care 2013;58:98-122 (c) 2012 by Daedalus Enterprises, Inc.