Flip Flop.

Slides:



Advertisements
Similar presentations
RS Flip Flops Benchmark Companies Inc PO Box Aurora CO
Advertisements

Sequential Digital Circuits Dr. Costas Kyriacou and Dr. Konstantinos Tatas.
COE 202: Digital Logic Design Sequential Circuits Part 1 Dr. Ahmad Almulhem ahmadsm AT kfupm Phone: Office: Ahmad Almulhem, KFUPM.
Latches CS370 –Spring 2003 Section 4-2 Mano & Kime.
CENG 241 Digital Design 1 Lecture 8 Amirali Baniasadi
Digital Logic Chapter 5 Presented by Prof Tim Johnson
Sequential Circuits1 DIGITAL LOGIC DESIGN by Dr. Fenghui Yao Tennessee State University Department of Computer Science Nashville, TN.
Sequential circuits The digital circuits considered thus far have been combinational, where the outputs are entirely dependent on the current inputs. Although.
Module 12.  In Module 9, 10, 11, you have been introduced to examples of combinational logic circuits whereby the outputs are entirely dependent on the.
CSCE 211: Digital Logic Design. Chapter 6: Analysis of Sequential Systems.
Digital Logic Design Brief introduction to Sequential Circuits and Latches.
Sequential circuit Digital electronics is classified into combinational logic and sequential logic. In combinational circuit outpus depends only on present.
Latches Module M10.1 Section 7.1. Sequential Logic Combinational Logic –Output depends only on current input Sequential Logic –Output depends not only.
ENGIN112 L20: Sequential Circuits: Flip flops October 20, 2003 ENGIN 112 Intro to Electrical and Computer Engineering Lecture 20 Sequential Circuits: Flip.
Latches Section 4-2 Mano & Kime. Sequential Logic Combinational Logic –Output depends only on current input Sequential Logic –Output depends not only.
CS 151 Digital Systems Design Lecture 20 Sequential Circuits: Flip flops.
Digital Logic Design CHAPTER 5 Sequential Logic. 2 Sequential Circuits Combinational circuits – The outputs are entirely dependent on the current inputs.
Flip Flops. Clock Signal Sequential logic circuits have memory Output is a function of input and present state Sequential circuits are synchronized by.
COE 202: Digital Logic Design Sequential Circuits Part 1
Synchronous Sequential Circuits by Dr. Amin Danial Asham.
1 Lecture #11 EGR 277 – Digital Logic Ch. 5 - Synchronous Sequential Logic There are two primary classifications of logic circuits: 1.Combinational logic.
1 Synchronous Sequential Logic Sequential Circuits Every digital system is likely to have combinational circuits, most systems encountered in practice.
Synchronous Sequential Logic A digital system has combinational logic as well as sequential logic. The latter includes storage elements. feedback path.
Sahar Mosleh PageCalifornia State University San Marcos 1 More on Flip Flop State Table and State Diagram.
Chapter 6 – Digital Electronics – Part 1 1.D (Data) Flip Flops 2.RS (Set-Reset) Flip Flops 3.T Flip Flops 4.JK Flip Flops 5.JKMS Flip Flops Information.
Chapter5: Synchronous Sequential Logic – Part 1
Synchronous Sequential Circuits by Dr. Amin Danial Asham.
 Flip-flops are digital logic circuits that can be in one of two states.  Flip-flops maintain their state indefinitely until an input pulse called a.
A latch is a temporary storage device that has two stable states (bistable). It is a basic form of memory. The S-R (Set-Reset) latch is the most basic.
Synchronous Sequential Circuits by Dr. Amin Danial Asham.
7. Latches and Flip-Flops Digital Computer Logic.
Sequential Logic Circuit Design Eng.Maha Alqubali.
Flip-Flop Flip-flops Objectives Upon completion of this chapter, you will be able to :  Construct and analyze the operation of a latch flip-flop made.
1 The Registers File l Modern digital systems are based on logic with state variables, which are changed according to a clock. – The system consists of.
INTRODUCTION FLIP FLOPS: Flip flop is the basic memory element in a digital computer. It is used to store one bit of information with a 0 (or) 1. It is.
Sequential logic circuits First Class 1Dr. AMMAR ABDUL-HAMED KHADER.
SIGNAL TRAINING SCHOOL – BORDER SECIRITY FORCE - TIGRI
Computer Science 210 Computer Organization
Sequential Circuits.
Sequential Circuits.
FLIP FLOPS Binary unit capable of storing one bit – 0 or 1
Flip Flops.
LATCHED, FLIP-FLOPS,AND TIMERS
Digital Fundamentals Floyd Chapter 7 Tenth Edition
CSCE 211: Digital Logic Design
Flip Flops.
FIGURE 5.1 Block diagram of sequential circuit
Digital Design Lecture 9
Synchronous Sequential Circuits
Overview Introduction Logic Gates Flip Flops Registers Counters
Flip-Flop.
Sequential Circuits Most digital systems like digital watches, digital phones, digital computers, digital traffic light controllers and so on require.
CISE204: Design of Digital Systems Lecture 18 : Sequential Circuits
Computer Science 210 Computer Organization
ECE Digital logic Lecture 16: Synchronous Sequential Logic
Latches and Flip-flops
Sequential logic circuits
LECTURE 15 – DIGITAL ELECTRONICS
Chapter 6 -- Introduction to Sequential Devices
Computer Science 210 Computer Organization
Synchronous Sequential Circuits
Reference: Chapter 5 Sequential Circuits Moris Mano 4th Ediditon
FLIP-FLOPS.
Synchronous sequential
Synchronous Sequential
Flip-Flops.
Flip Flops Unit-4.
Chapter 5 Sequential Circuits.
Sequential Digital Circuits
Week 11 Flip flop & Latches.
Presentation transcript:

Flip Flop

What is a Flip Flop? Flip-Flops "Flip-flop" is the common name given to two-state devices which offer basic memory for sequential logic operations. Flip-flops are heavily used for digital data storage and transfer and are commonly used in banks called "registers" for the storage of binary numerical data.

Sequential Logic In digital circuit theory, sequential logic is a type of logic circuit whose output depends not only on the present value of its input signals but on the past history of its inputs. This is in contrast to combinational logic, whose output is a function of only the present input. That is, sequential logic has state (memory) while combinational logic does not. Or, in other words, sequential logic is combinational logic with memory.

Sequential Logic

Flip Flops The memory elements in a sequential circuit are called flip-flops. A flip-flop circuit has two outputs, one for the normal value and one for the complement value of the stored bit. Binary information can enter a flip-flop in a variety of ways and gives rise to different types of flip-flops.

Flip Flop Chip

Flip Flop Circuit

Types Of Flip Flops

How To Construct Flip Flop? A flip-flop circuit can be constructed from two NAND gates or two NOR gates.

SR Flip Flop (latch) Each flip-flop has two outputs, Q and Q', and two inputs, set and reset. When Q=1 and Q'=0, it is in the set state (or 1-state). When Q=0 and Q'=1, it is in the clear state (or 0-state)

Basic flip-flop circuit with NOR gates

Basic flip-flop circuit with NAND gates

D Flip-Flop The D input goes directly into the S input and the complement of the D input goes to the R input. The D input is sampled during the occurrence of a clock pulse. If it is 1, the flip-flop is switched to the set state (unless it was already set). If it is 0, the flip-flop switches to the clear state.

D FLIP FLOP

JK FLIP FLOPS Inputs J and K behave like inputs S and R to set and clear the flip-flop (note that in a JK flip-flop, the letter J is for set and the letter K is for clear). When logic 1 inputs are applied to both J and K simultaneously, the flip-flop switches to its complement state, ie., if Q=1, it switches to Q=0 and vice versa.

JK FLIP FLOPS

T FLIP FLOP The T flip-flop is a single input version of the JK flip-flop.the T flip-flop is obtained from the JK type if both inputs are tied together. The output of the T flip-flop "toggles" with each clock pulse.

T FLIP FLOP

Triggering of Flip-flops The state of a flip-flop is changed by a momentary change in the input signal. This change is called a trigger and the transition it causes is said to trigger the flip-flop.

Triggering of Flip-flops The clock pulse goes through two signal transitions: from 0 to 1 and the return from 1 to 0. As shown in Figure 8 the positive transition is defined as the positive edge and the negative transition as the negative edge.