Cable and Strand test facility

Slides:



Advertisements
Similar presentations
The HiLumi LHC Design Study (a sub-system of HL-LHC) is co-funded by the European Commission within the Framework Programme 7 Capacities Specific Programme,
Advertisements

3nd KEK-CEA Workshop on Superconducting magnets and cryogenics for accelerator frontier - 24/03/2009 Ceramic insulation for Nb3Sn accelerator magnets F.Rondeaux.
SC Magnets at Fermilab New Collaring and Coil Pre-stress Limit for a Nb3Sn Magnet Alexander Zlobin Technical Division Fermilab.
Sc Magnet test facility Consolidation Project presentation M. Bajko for the TEMB on behalf of the MSC TF section team 31. Aug
Mikko Karppinen Nb3Sn Coil Production for 11 T Dipole Model Magnets.
I)Detailed information specifically relating to the section on superconductivity. Some of this information will be needed for the tutorial work.
September 2007 FP7-IA HFM JRA proposal G. de Rijk (CERN)1 FP7-IA HFM JRA proposal   The proposal is under discussion: we welcome input from potential.
11 September 2007 FP7-IA HFM JRA proposal G. de Rijk (CERN)1 FP7-IA HFM JRA proposal   Outline Motivation General description Proposed Work Packages.
October 30 th Advances in Heat Transfer in High Field Accelerator Magnet B. Baudouy CEA/Saclay - Dapnia/SACM Annual meeting CARE October.
HQ TEST CERN by Marta Bajko CERN TE-MSC TF For Hi Lumi and LARP the 16 th of November 2011 CERN.
Davide Tommasini Nb3Sn versus NbTi in HeII THERMOMAG-07, Paris 19 November 2007 Typical insulations for Rutherford cables Heat transfer model Heat flux.
CERN/CEA Collaboration agreement No. KE2275/TE WP4 – Nb 3 Sn technology development Pré-Kick-off meeting 03/07/2014.
CERN Accelerator School, Erice 2013 Tiepida-2 case-study 3: High field – large aperture magnet for a cable facility TiEpIdA2 design team: I. Mondino: Project.
LMC 30 LPC A. Verweij, TE-MPE. 30 Sept 2009, LMC meeting 1.9 K, 0 T, 7.5 kA run Heat pulse.
1 SIS 300 Dipole Low Loss Wire and Cable J. Kaugerts, GSI TAC, Subcommittee on Superconducting Magnets Nov15-16, 2005.
Technical agreement n 3 New SC Magnets activities P. Fessia (G. De Rijk), D. Reynet, J.M Rifflet.
Review-LHC Interaction Regions - Upgrade Phase I Amalia Ballarino, 31 st July 2008 Cold Powering Options Conceptual Design Review of the LHC Interaction.
Heat management issues A perspective view centered on the design of superconducting devices Opinions of L. Bottura At the mWorkshop on Thermal Modeling.
G.A.Kirby 4th Nov.08 High Field Magnet Fresca 2 Introduction Existing strand designs, PIT and OST’s RRP are being used in the conceptual designs for two.
15 Th November 2006 CARE06 1 Nb 3 Sn conductor development in Europe for high field accelerator magnets L. Oberli Thierry Boutboul, Christian Scheuerlein,
Outline: Main characteristics of the FRESCA2 cable Main characteristics of the strand Strand stability, an issue to avoid magnet quench at low field Procurement.
LARP Meeting April 2006LARP Magnet Program – D.R. Dietderich LARP Cable R&D D.R. Dietderich LBNL.
EuCARD WP 7 – High Field Magnets Task – Radiation certification Status report EuCARD WP 7 – High Field Magnets Task 2 – Support studies Task
New options for the new D1 magnet Qingjin Xu
Design and construction of Nuclotron-based Ion Collider fAcility (NICA) and Mixed Phase Detector (MPD) Design and construction of Nuclotron-based Ion Collider.
Arjan Verweij, AT-MAS, Workshop on test facilities and measurement equipment needed for the LHC exploitation, 12 April 2006 B163 - FRESCA.
FLUKA Meeting Milan Jul 2010 Work in the frame of the LHC Phase II Upgrade Previous work was dedicated to the study of the.
CERN Accelerator School Superconductivity for Accelerators Case study 3 Paolo Ferracin ( ) European Organization for Nuclear Research.
FRESCA2 Technical Meeting 5-Validation of coil winding with Cu coils Françoise Rondeaux 09/06/ CEA-Irfu-SACM-LEAS - 5-Rondeaux- FRESCA2 Technical.
Restoring Komag Yasuhiro Makida Consideration of restoring and modifying Komag for a stand alone operation without the refrigerator. Contents 1.Magnet.
AT-MAS/SC A. Verweij 21 Mar 2003 Present Status and Trends of Cable Properties and Impact on FQ Workshop on Field Quality Steering of the Dipole Production.
HTS for Upgrades: overview of test requirements Amalia Ballarino, CERN Review of superconductors and magnet laboratories, A. Ballarino.
Plan for test station Marta Bajko For the Technical Review of FReSCa2 June 2015 Saclay Paris.
Superconducting Technologies for the Next Generation of Accelerators CERN, Globe of Science and Innovation 4-5 December Superconducting Links for the Hi-Lumi.
A. BallarinoEucard MeetingCERN,20/03/2013 High-Tc Superconducting Links for the LHC WP 7 – Task 5 A.Ballarino, TE-MSC, CERN Task 5 participants : A. Ballarino,
EuCARD WP 7 – High Field Magnets Task 7.2 Status report EuCARD WP 7 – High Field Magnets Task 2 – Support studies Task 7.2 Status report EuCARD HFM collaboration.
29 th September 2009 EuCARD-WP7 HFM Conductor specification and procurement Luc OBERLI CERN, TE-MSC-SCD.
KEK-CEA Superconducting Magnet Co-operation Program The FJPPL workshop LAPP, Annecy-Le-Vieux (France), June LHC-3 Superconducting Magnets.
EuCARD WP 7 – High Field Magnets EuCARD WP 7 – High Field Magnets Task 2 – Support studies Status report after M6 EuCARD HFM collaboration meeting – CERN.
TEST FACILITY STATUS FOR TESTING CERN Marta Bajko WP10. EUCARD 2 Task 4 - HTS Magnet Tests, June 2015.
MQXFS1 Protection heater delays vs. Simulations 9 May 2016 Tiina Salmi, Tampere university of technology Acknowledgement: Guram Chlachidze (FNAL), Emmanuele.
CERN QXF Conductor Procurement and Cable R&D A.Ballarino, B. Bordini and L. Oberli CERN, TE-MSC-SCD LARP Meeting, Napa, 9 April 2013.
CERN Cabling Experience FRESCA 2, 11 T Dipole and MQXF A. Ballarino
C.J. Kovacs M.D. Sumption E.W. Collings
Lessons learnt from CERN experience
Marta Bajko X EUCARD2 Annual Meeting Malta 2016
HFM Test Station Main Cryostat
AEGIS Magnet System.
EPFL-SPC, 5232 Villigen PSI, Switzerland
Development of the Canted Cosine Theta Superconducting Magnet
J.C. Perez on behalf of SMC collaboration team J.C. Perez
CERN Conductor and Cable Development for the 11T Dipole
LARP Vertical Test Facility
Mike Sumption, M. Majoros, C. Myers, and E.W. Collings
Possibility of China to collaborate and modality
B. 163 facility upgrade: work space options in B. 163 and B. 103 F
To be presented at Nb3Al R&D Review,
Procurement of Nb3Sn strand for coils assembled at CERN
11 T Dipole Project Overview and Status
CEA Nb3Sn quadrupole magnet : test results and future
Generic Cryo HX Options
I. Bogdanov, S. Kozub, V. Pokrovsky, L. Shirshov,
FRESCA Cryostats Outer cryostat during pressure test at the manufacturer Top plate and lambda plate for the outer cryostat Inner cryostat during reception.
MQXF coil cross-section status
Using the code QP3 to calculate quench thresholds for the MB
as a prototype for Super c-tau factory
Qingjin XU Institute of High Energy Physics (IHEP),
Optical fiber based sensors for low temperature and superconductors
Review Bloc 4 and SM18 facilities and upgrade
Assessment of stability of fully-excited Nb3Sn Rutherford cable with modified ICR at 4.2 K and 12 T using a superconducting transformer and solenoidal.
Presentation transcript:

Cable and Strand test facility L. Oberli, A. Verweij Outline : Test facilities installed in 103 and 163 Cryogenic equipments to characterize the superconductors in 163 Test program for coming years Workshop on test facilities 12thApril 2006

Workshop on test facilities Map of the Buildings 103 and 163 Control room Cold Box 130 l/h 163 Transpooling zone for cable Furnace Strand sample preparation area Preparation area for cable FRESCA Cryogenic Equipment in 163 : 7 small Cryostats for strand tests FRESCA facility for Ic cable test 1 cold box 6000 l dewar for Fresca operation 103 Workshop on test facilities 12thApril 2006

Workshop on test facilities Building 103 Strand and cable samples characterization “Chemical” room : Cu/Sc and metallography preparation Workshop on test facilities 12thApril 2006

Workshop on test facilities Building 163 Control room Cold Box 130 l/h M Rc RRR 163 Trans-spooling zone for cable Furnace Strand sample preparation area Preparation area for cable FRESCA Cryogenic Equipment in 163 : 7 small cryostats for strand tests FRESCA facility for Ic cable test 1 cold box 6000 l dewar for FRESCA operation LHe consumption : FRESCA ~ 70 % small crysotats ~ 30% 103 Workshop on test facilities 12thApril 2006

163 : Trans-spooling equipment and preparation area for strand samples Workshop on test facilities 12thApril 2006

163 : Cryogenic test facility for strand and cable samples 7 small cryostats for strand samples tests : 2 cryostats for Ic on NbTi strand : 1 kA, B = 11 T at 4.2 K, 13 T at 1.9 K Sample holders for 10 samples 1 cryostat for Ic test on Nb3Sn strand : 4 kA, B = 12.5 T at 4.2 K Sample holder for 2 kA and a single sample 1 cryostat for thermal transfer measurements on insulated cable : 1.8 K < T < 2.1 K 1 cryostat for Rc test on cable samples : 4.2 K 1 cryostat for RRR test on NbTi and Nb3Sn strands 1 cryostat for Magnetisation test on NbTi strands (to be upgraded to measure Nb3Sn strands and electromagnetic instabilities) Workshop on test facilities 12thApril 2006

163 : Test program for coming years Characterization of Nb3Sn strand by Ic and RRR measurements for NED and CERN programs Ic measurements on LHC strands and on strands with very small filament diameter ( ~ 1 mm) Evaluation of the transfer of heat from the coil of the LHC dipole magnet to He II Rc test to qualify different types of coating for AC cables, tests on core cables and on LHC cables Magnetization measurements on LHC strands, Nb3Sn strands, strands for Neuro-spin project, strands for AC applications Workshop on test facilities 12thApril 2006