IBL activities ATLAS Meeting Milano, 14 May 2012 S. Coelli, Servizio Progettazione e Officina Meccanica – INFN MILANO A. Capsoni, M. Monti, F. Tomasi, E. Viscione

IBL project EDMS reports FEM SIMULATION REPORTS FOR THE IBL STAVE Number: ATU-SYS-EA-0007  v.1 THE SUB-DOCUMENTS ATTACHED TO THIS ONE INCLUDE THE REPORT USED FOR THE IBL TDR. THERMAL FIGURE OF MERIT USING A FACEPLATE STAVE DEFORMATIONS UNDER THERMAL AND GRAVITATIONAL LOADS, SEVERAL BOUNDARY CONDITIONS. DYNAMIC ANALYSIS WORK IN PROGRESS => EXPERIMENTAL MEASUREMENT OF THE STAVE DEFORMATION INDUCED BY THE COOLING https://edms.cern.ch/document/1211313/1 IBL STAVE FEM SIMULATIONS REPORTS FOR THE TDR 01 - MECHANICAL SIMULATIONS VALIDATION REPORT 02 - STEADY-STATE THERMAL ANALYSIS OF THE STAVE 03 - STRUCTURAL ANALYSIS OF THE COOLING CARBON PIPE 04 - THERMO-MECHANICAL ANALYSIS OF THE STAVE 05 - STAVE_THERMAL_FIGURE_OF_MERIT 06 - CF-Ti JOINT OVERBRAID OPTIMIZATION 07 - REFINED STAVE THERMAL FIGURE OF MERIT 08 - STAVE DYNAMIC ANALYSIS

RECENTLY MEASURED THERMAL PERFORMANCE OF THE IBL STAVE PROTOTYPE CONFIRMS THE DESIGN ANALYSIS

EXTRACT AS EXAMPLE ..EFFECTS OF DIFFERENT FLEXBUS DESIGN ..EFFECTS OF DIFFERENT FACEPLATE DESIGN

EXPERIMENTAL MEASUREMENT OF THE STAVE DEFORMATION INDUCED BY THE COOLING TEST OF INFRARED TRANSPARENT MATERIALS FOR THERMAL IMAGE TAKEN USING A I.R. CAMERA (FLIR) TEST BOX INSTALLED IN THE LASA METROLOGY LAB. COOLED USING NITROGEN SPILLED FROM A LN2 RANGER OPTICAL MEASUREMENT OF THE STAVE DISPLACEMENT IN SEVERAL POINTS CONSTRAINS ATTACHED TO INVAR REFERENCE BAR TEMPERATURE THERMORESISTANCE PT100 SENSORS

ATLAS PIXEL DETECTOR INTEGRATION AND TESTING TOOL (ITT) SET-UP OF THE TOOL INTO THE CERN CLEAN ROOM (SR-1) ASSEMBLING STARTED IN MARCH 2012 THE SCOPE (TO BE DECIDED) TO MAKE POSSIBLE THE INTEGRATION OF: - NEW SERVICE QUARTER PANELS (nSQP) - NEW BEAM-PIPE - WITH INTEGRATED IBL

ATLAS PIXEL DETECTOR INTEGRATION AND TESTING TOOL (ITT) MARCH 2012 SET-UP INTO CERN CLEAN ROOM SR-1

ATLAS PIXEL DETECTOR INTEGRATION and INSTALLATION 2006 2006