Nonsterile compounding-USP ch 795

Slides:



Advertisements
Similar presentations
Safety in the Pharmacy Health Science Technology.
Advertisements

Common/shared responsibilities between jobs.
Producing a Pharmaceutical or Biopharmaceutical
The Law The law covers only non-injectable medication.
Chapter 5 Veterinary Drug Use, Prescribing, Acquisition, and Pharmacy Management Copyright © 2011 Delmar, Cengage Learning.
Quality control of raw materials In-process control
FIELD COMPLIANCE UPDATE CDR Thomas R. Berry, RPh FDA, Investigator RAL-RP / ATL-DO.
Distributed Manufacturing via the SNM Multicenter FLT IND Part II SNM Midwinter Clinical Trials Network Albuquerque, New Mexico February 2, 2010 Sally.
ISO 9000 Certification ISO 9001 and ISO
World Health Organization
M. Ansari Pharm D, PhD Associate Professor of Pharmaceutics.
Huzairy Hassan School of Bioprocess Engineering UniMAP.
World Health Organization
Current Good Manufacturing Practices (cGMP’s). Biotechnology using living cells and materials produced by cells to create pharmaceutical, diagnostic,
Investigational Drugs DUMC STERILE PREPARATIONS CLEANROOM TRAINING MODULE: 1 DUMC STERILE PREPARATIONS CLEANROOM.
Good Manufacturing Practices
Copyright (c) The McGraw-Hill Companies, Inc. Permission required for reproduction or display. 9-1 Chapter 9 Principles of Pharmacology.
Veterinary Drug Use, Prescribing, Acquisition, and Pharmacy Management L. VanValkenburg, RVT, BASVT.
Dispensing &compounding Prepared by: Kazi Rashidul Azam.
Understanding Drug Labels
Administration Safety PHCL 492. Standards for Medicines Management  ‘When required to administer medication a practitioner is accountable for his or.
Important informations
Assembly Bill #2609 Health and Safety Code Effective January 1,2008 MEDICATION TRAINING FOR DIRECT CARE STAFF.
OR “READ THE FINE PRINT PLEASE!”
Demonstrably Difficult to Compound Drug Products Kathleen Anderson, Pharm. D. Division of Prescription Drug Compliance and Surveillance Office of Compliance.
Calculating Oral Dosage
Compounding Kenneth Schell Pharm. D President, CA State Board of Pharmacy.
Sterile Drug Products Dr. Peter Cooney Associate Director for Microbiology Office of New Drug Chemistry Center for Drug Evaluation and Research.
1.  Chapter 8 covers pages  Objective  Explain need for compounding  Know equipment needed for compounding  Know techniques for compounding.
sterile environment institutional pharmacy--- 18% of CPhT workers.
Compounding. COMPOUNDINGCOMPOUNDING Compounding: the preparation, mixing, assembling and packaging or labeling of a drug or device. Extemporaneous Compounding:
Module 14Slide 1 of 23 WHO - EDM Basic Principles of GMP Active Pharmaceutical Ingredients Part Three, 18.
Solid dosage forms Tablets
Chapter 15: Nonsterile Compounding and Repackaging
Quality Control significance in pharmaceutical industry
Compounding Chapter 9.
Storage, Labeling, Controlled Medications Guidance Training CFR § (b)(2)(3)(d)(e) F431.
Understanding Drug Labels
Patricia C. Kienle, RPh, MPA, FASHP
Safety in the Pharmacy.
Inventory Management Chapter 13.
Pharmacy Technician Compounding.
GOOD MANUFACTURING PRACTICE FOR BIOPROCESS ENGINEERING (ERT 425)
Oral Medication Labels and Dosage Calculation
Quality Control and Assurance
Reconstitution of Powdered Drugs
Nonsterile compounding-USP ch 795
2.4 : Good Compounding Practice (GCP)
sterile environment institutional pharmacy--- 18% of CPhT workers.
Solid dosage forms Tablets
Chapter 11 How to Read Drug Labels.
QUALITY ASSURANCE OF PHARMACEUTICAL PRODUCTS IN RMH
Current Good Manufacturing Practice & Pharmaceutical Quality Control
GOOD MANUFACTURING PRACTICE(GMP): AN OVERVIEW By- Dr. Jill Shukla
Introduction to GMP.
Nonsterile compounding-USP ch 795
GMP Inspection Process
PRESCRIPTIONS Chap. 5.
Intermountain APIC Chapter CIC training questions
Presented by: Ken Glade Director of Engineering
Chapter-3 Current Good Compounding Practices Fifth Stage
Chapter 35 Basic Pharmacology.
Intermountain APIC Chapter CIC training questions
Ch 18: Pharmacy.
Understanding Drug Labels
Compounded Drugs and Lack of Premarket FDA-Approval
Understanding Drug Labels
INTRODUCTION: Medications not being given must be safely stored
A FRIENDLY REMINDER ON OTC DRUGS. DRUG REGULATIONS IN THE PHILIPPINES.
Reading Medication Labels
Presentation transcript:

Nonsterile compounding-USP ch 795 USP <795> outlines the responsibilities of the compounder, which can be summarized as being responsible for compounding preparations of acceptable strength, quality, and purity with appropriate packaging and labeling in compliance with requirements established by applicable laws and agencies (eg, state boards of pharmacy). Specifically, the responsibilities of the compounder include the following general principles: Personnel are capable and qualified to perform their assigned duties. Compounding ingredients of the appropriate identity, quality, and purity are purchased from reliable sources. All equipment used in compounding is clean, properly maintained, an used appropriately. Only authorized personnel are allowed in the immediate vicinity of the drug compounding operations. There is assurance that processes are always carried out as intended or specified and are reproducible. The compounding environment is suitable for its intended purpose and to prevent errors. Adequate procedures and records exist for investigating and correcting failures or problems in compounding, in testing, or in the preparation itself.

USP ch 795 USP 795 carries the force of law. Its provisions can be, and are, enforced by U.S. Food and Drug Administration agents and state board of pharmacy officials. All states have adopted USP 795 as the baseline for safe and legal nonsterile compounding It is the most common kind of drug compounding done by pharmacists and pharmacy technicians in community and hospital pharmacies. Preventing contamination is important when doing nonsterile compounding, but compounders do not have to work in completely sterile environments like cleanrooms. "the production of solutions, suspensions, ointments and creams, powders, suppositories, capsules and tablets."

USP ch 795 extemporaneous compounding----making a drug dosage not made by manufacturer. simple, moderate and complex categories. Simple nonsterile compounding involves mixing medications according to established formulas, or "recipes," and creating liquid versions of drugs usually sold only as tablets or capsules. Used in doses smaller than ones in commercially produced products. 125 simple nonsterile compounds in USP. It gives APIs and nonpharmaceutical ingredients to use, as well as how to measure and mix the ingredients, label the finished drug product and determine an expiration date

USP ch 795 Moderate nonsterile compounding involves making dosages containing potentially harmful medications or preparations that require special handling. Fentanyl troches, which are better known as lollipops, and ointments that can only be safely applied with gloves fall into this category. Mostly from dentists, oncologists and dermatologists Few pharmacies perform complex nonsterile compounding, which requires advanced training and special equipment to make products like extended-release capsules and transdermal patches. Sterile compounding is ---Medication intended for injection, infusion or application to the eye must be compounded according the rules and standards for sterile compounding due to bacteria or fungi.