ILC Value Management Workshop

Slides:

Advertisements

Similar presentations

11/27/2007ILC Power and Cooling VM Workshop Mike Neubauer 1 RF Power and Cooling Requirements Overview from “Main Linac Power and Cooling Information”

Advertisements

Nov. 07 DR-KOM-CFS 1 Damping Rings KOM Conventional Facility & Siting Overview Tom Lackowski Acknowledgment: Atsushi Enomoto, Jean-Luc Baldy, John Osborne,

9/17/07 ILC Detectors 1 Conventional Utilities Tom Lackowski.

Global Design Effort - CFS TILC09 and GDE AAP Review Meeting - Tsukuba, Japan 1 GDE ACCELERATOR ADVISORY PANEL REVIEW CONVENTIONAL FACILITIES.

Nov. 19, 2008 ILC08 Global Design Effort 1 Status Report Alternative Siting and Tunnel Design Tom Lackowski.

Jess Albino CF Breakout April 16, CONVENTIONAL FACILITIES Project Team CF Changes Electrical Engineer - done Mechanical.

Global Design Effort - CFS TILC09 and GDE AAP Review Meeting - Tsukuba, Japan 1 GDE ACCELERATOR ADVISORY PANEL REVIEW CONVENTIONAL FACILITIES.

31, May 2007 ILC DESY 07 1 Surface Building Design Development Tom Lackowski GDE.

- Asian Single Tunnel Design Review – A Review on Design Study of the ILC Conventional Facility in Mountain Region Review Organization and Requirements.

E Huedem, Nov ILC VALUE ENGINEERING SESSION of POWER & COOLING (Focus on Main Shaft 7) November 27, 2007 INFORMATION PHASE Conventional.

Introduction and Charge to the Review of ESS Target building and Instrument Hall design requirements Roland Garoby November 2014, Lund

1 Process Water and Air Treatment 01 June 2007 Emil Huedem, Maurice Ball, Lee Hammond Fermilab.

ILC Energy Efficiency Marc Ross and Ewan Paterson, SLAC CFS-ADI Joint Meeting ICEPP University of Tokyo 9 April 2014 Three examples: 1) higher quality.

Global Design Effort - CFS ILC Global Systems Meeting 1 ILC GLOBAL SYSTEMS MEETING CONVENTIONAL FACILITIES AND SITING GROUP Status and Overview.

Global Design Effort - CFS Baseline Assessment Workshop 2 - SLAC Positron Source Relocation 1 BASELINE ASSESSMENT WORKSHOP 2 CONVENTIONAL FACILITIES.

CLIC-ILC Cost & Schedule Agenda – 8feb08 John Carwardine = secretary & rapporteur this file: & Schedule Sub-Group.

BDS Magnet-Power System-Facility Optimization1 ILC BDS Kickoff Meeting Basis for Magnet, Power System and Cooling Facility Optimization Discussion Paul.

Global Group 4 – Conventional Facilities and Siting V. Kuchler1 of 17 Fermilab R&D Meeting Fermilab R&D Meeting Vic Kuchler Conventional Facilities.

LCFOA Meeting at SLAC Linear Collider Forum of the Americas 1 LINEAR COLLIDER FORUM OF THE AMERICAS CONVENTIONAL FACILITIES OVERVIEW Victor R. Kuchler.

Sept., 2007 European CF&S Kick Off Meeting 1 Plan for a Value Engineering Study T. Lackowski.

Global Design Effort - CFS TILC09 and GDE AAP Review Meeting - Tsukuba, Japan 1 GDE ACCELERATOR ADVISORY PANEL REVIEW CONVENTIONAL FACILITIES.

1 CLIC / ILC Collaboration for CES issues JOHN OSBORNE – CES 8 April 2009.

SLAC_OCT07 BDS-KOM-CFS 1 Beam Delivery System & Interaction Region KOM Conventional Facility & Siting Overview Fred Asiri/SLAC Acknowledgment: Atsushi.

27 Nov 07 VM Workshop Global Design Effort 1 ILC – Superconducting Linear Collider Marc Ross, Project Manager GDE Fermilab.

Global Design Effort - CFS ILC Accelerator Design and Integration Meeting 1 ILC AD&I MEETING CONVENTIONAL FACILITIES AND SITING GROUP UPDATE V.

WBS x.11 Conventional Facilities Americas Region ILC Fermilab ART Meeting1 Conventional Facilities and Siting Global Group Americas Region FY.

Global Design Effort Accelerator System Kick-off Meeting e- source SLAC Marc Ross.

Global Design Effort - CFS Damping Ring Baseline Technical Review 1 DAMPING RING BASELINE TECHNICAL REVIEW CONVENTIONAL FACILITIES AND SITING.

Technical Board: Fuze: 毎週火曜日 22:00 〜 23:00 、臨時： LCWS など – 2013 年〜今までに 28 回開催 – 各 review, workshop, FALC などの報告 – 各国の状況（日本の有識者会議,… ） – X-FEL, LCLS-II, STF,

Global Design Effort - CFS Damping Ring Baseline Technical Review 1 DAMPING RING BASELINE TECHNICAL REVIEW CONVENTIONAL FACILITIES AND SITING.

1 Global Design Effort: Controls & LLRF Controls & LLRF Working Group: Tuesday Session (29 May 07) John Carwardine Kay Rehlich.

Equipment Planning and Project Consulting Technology Management.

Global Design Effort - CFS AD & I Meeting - DESY AD & I Meeting - DESY 1 AD&I Meeting CONVENTIONAL FACILITIES AND SITING GROUP Main Linac Tunnel.

Global Design Effort - CFS ILC Global Systems Meeting 1 ILC GLOBAL SYSTEMS MEETING CONVENTIONAL FACILITIES AND SITING GROUP STATUS REPORT V. Kuchler,

Conventional Facilities and Siting GG Global Design Effort BILCW 07 - Beijing1 Conventional Facilities and Siting Global Group Summary Report.

Global Design Effort: Controls & LLRF Americas Region Team WBS x.2 Global Systems Program Overview for FY08/09.

Conventional Facilities and Siting Global Group Global Design Effort CFS EDR Kick-Off Mtg, FNAL Aug 22 – 24, CFS EDR FNAL Kick-Off Planning.

Summary: Site Discussion Jonathan Dorfan SLAC Plenary Session, June 6, 2008.

Global Design Effort Working Groups A & C Parallel Session Summary IRENG07 A. Herve, T. Markiewicz, T. Sanuki, Y. Sugimoto V. Kuchler, A. Enomoto, J. Osborne.

Global Design Effort - CFS ILC CFS and Global Systems Meeting 1 ILC CFS AND GLOBAL SYSTEMS MEETING CONVENTIONAL FACILITIES AND SITING GROUP CFS.

Fred Asiri1 Conventional Facilities and Siting Global Group (CFS) SLAC Update Conventional Facilities and Siting Global Group (CFS) SLAC Update December.

CFS / Global – 09 June, 2010 PM Report: SB2009: –4 two-day workshops form the core of ‘TOP LEVEL CHANGE CONTROL’ –  as advised by AAP, PAC and etc –Written.

Global Design Effort - CFS ILC CFS & Global Systems Meeting 1 ILC CFS & GLOBAL SYSTEMS MEETING CONVENTIONAL FACILITIES AND SITING GROUP CFS Status.

Main Linac Technology (MLT) Meeting To be held through WebEx July 13, 2007.

June 5, 2008 ILC Conventional Facilities and Siting Workshop1 History of the First ILC Value Engineering Workshop.

Global Design Effort - CFS ILC CFS & Global Systems Meeting 1 ILC CFS & GLOBAL SYSTEMS MEETING CONVENTIONAL FACILITIES AND SITING GROUP CFS Status.

E Huedem, June RDR PROCESS WATER & VALUE ENGINEERING ITEMS June 5, 2008 GDE Meeting-ILC CFS Workshop in Dubna, Russia Emil Huedem, Fermilab.

Global Design Effort - CFS ILC CFS and Global Systems Meeting 1 ILC CFS AND GLOBAL SYSTEMS MEETING CONVENTIONAL FACILITIES AND SITING GROUP CFS.

ILC Power and Cooling VM Workshop

Review of the International Linear Collider (ILC) Electrical and Mechanical System Design to be held at CERN on 21 March, 2012 The purpose of the Review.

Conventional Facilities and Siting Global Group (ARCFS)

Conventional Facility & Siting (CF&S) Overview for the Positron Source

LCWS11 AWG9 PARALLEL SESSION SUMMARY

NPA 709 (Area Code) Relief in Newfoundland and Labrador

Mike PAC Charge & Agenda ALCW15 Plenaries CERN SPC – September 2014

Americas KlyCluster Cost Analysis Overview

Travel Group Consulting

State Hazard Mitigation Plan Advisory Team (SHMPAT)

SCRF Monthly WebEx Meeting Jan. 12, 2010

ILC-EDR Kick-off Meeting, Cryomodule and Cryogenics

CONVENTIONAL FACILITIES presented by Peter H. Garbincius

ILC GLOBAL SYSTEMS MEETING

ILC PROJECT ENGINEERING DESIGN REPORT CFS Europe – KICK OFF MEETING

Conventional Facilities and Siting Global Group (CFS) SLAC Update December 10, 2007 Acknowledgment: Jerry Aarons, Clay Corvin, and Esther Kweon Fred Asiri.

, A. Yamamoto SCRF WebEx Meeting.

Atlanta Control-M User Group Meeting

NPA 506 Relief Planning Committee Meeting – Day 1 Tuesday, September 12, 2017 Delta Hotel - Fredericton 9:00 Registration 9:15 Welcome and introductions.

ILC - Global Design Effort

Executive Project Kickoff

Stakeholder Mapping.

Presentation transcript:

ILC Value Management Workshop Nov. 27, 2007 VM Workshop

Welcome Welcome and Thank-You for your hard work over the next few days. Introduction of participants US Corp of Engineers OVEST Team Richard Lambert, Facilitator, Keith Ellmers, John Mathis Main Linac and High level RF Mike Neubauer (SLAC), Chris Jensen (Fermilab), Shigeki Fukuda (KEK), Keith Jobe (SLAC) Consultants : Larry Hanson PE Burns and Mc Donnell, Robert Knoedler Hanson Engineering Tracy Lundin Hanson, Venkat Kumar, University of Chicago Javier Sevilla, SLAC Conventional Facilities and Siting Vic Kuchler, Marc Ross, Emil Huedem, Lee Hammond, Maurice Ball, Tom Peterson, Tom Lackowski, Observer: Bakul Banerjee Nov. 27, 2007 VM Workshop

Charge Conduct a workshop that will comprehensively examine the power and cooling system requirements and design solutions. Concentrating on the largest power user, the Main Linac, examine all aspects of the technical equipment and conventional equipment as it relates to power and cooling. Nov. 27, 2007 VM Workshop

Product and Process Beyond the charge set forth for VM Workshop we need to understand the VM process, and where this process can best benefit the project. Proper scoping Duration required “Formal” or “Informal” Participants Nov. 27, 2007 VM Workshop

Agenda VM Workshop Nov. 27, 2007 Workshop Agenda: Tuesday Nov. 27, 2007 1:00 to 5:30 1:00 Information Phase Welcome and Introductions Tom Lackowski Opening remarks Vic Kuchler ILC Project Overview Marc Ross ILC Conventional Construction Tom Lackowski VM Process Overview Richard Lambert – OVEST Main Linac Equipment power and Mike Neubauer cooling Criteria 3:00-3:30 Coffee break 3:30-5:30 Function Analysis Phase Shaft 7 CF&S supplied Power and Cooling Emil Huedem HVAC Lee Hammond Power Tom Lackowski FAST Diagram Richard Lambert 5:30 Adjourn Wed. Nov. 28, 2007 9:00 to 5:30 9:00-10:30 Speculation Phase Richard Lambert 10:30-11:00 Coffee Break 12:30-1:30 Lunch 1:30-3:00 Speculation Phase Continued 3:00-3:30 Coffee Break 3:30-5:30 Speculation Phase Continued or Start Analysis Phase Thursday Nov. 29, 2007 9:00 to 5:30 9:00-10:30 Analysis Phase 11:00 -12:30 Development Phase Planning 1:30-3:00 Development Phase Planning Continued Presentation Phase Planning Workshop Close Out Tom Lackowski 3:30-5:30 Development of EDR Work Packages Nov. 27, 2007 VM Workshop