Study of Chinese oil-less chamber

Slides:



Advertisements
Similar presentations
Series/Parallel Circuits Section Concepts Studied So Far Ohms Law: Victory Is Rare Power: P=IV KCL KVL.
Advertisements

Status of test beam data analysis … with emphasis on resistive coating studies Progress and questions 1Meeting at CEA Saclay, 25 Jan 2010Jörg Wotschack,
Muon EDR: Chamber design M2/3 R1/2 16/04/20031T.Schneider/LHCb Muon EDR 1.General description - AW read out -Cathode pad read out -HV supply 2.Details.
Homogeneity of Small Chambers T4, T6, T7, T8 and Gas Gain Measurements of Frascati and Roma Chambers Emmanuel Angulo (CSU Fresno) Weekly Meeting ATLAS.
R&D Plan on Clearing Electrode using the KEKB LER Y. Suetsugu and H. Fukuma, KEKB M. Pivi and L. Wang, SLAC at KEK.
Development of high rate RPCs Lei Xia Argonne National Laboratory.
Micro MEsh GASeous Detectors (MicroMegas)
SQUARE PAD PCB DESIGN Elizabeth Starling, Jerry Collins Florida Institute of Technology High Energy Physics Lab A January 26 th, 2015.
1 Sep. 19, 2006Changguo Lu, Princeton University Induced signal in RPC, Configuration of the double gap RPC and Grouping of the strips Changguo Lu Princeton.
Resistive Plate Chambers for CMS (Pre-assembly Jobs done at BARC) Archana Sharma, Suman B.Beri P.U, Chandigarh & L.M.Pant BARC, Mumbai.
Stations There are six stations of RPCs. They are 1-3 north, and 1-3 south. RPC3SRPC2S RPC1SRPC1N RPC2NRPC3N This document is available at
Status of the LHCb RPC detector Changes with respect to Note cm strips instead of 3 cm (cost optimization) All gaps same size (standardization)
1Daya Bay RPC HV FDR 6/17/2008 RPC HV cable pick-up noise issue C. Lu, Princeton University (6/17/2008)
EPFL, Design and first Prototype for a B eam P ipe D istance M onitoring Safety Switch.
Plan for MRPC Production Yongjie Sun Center of Particle Science and Technology University of Science and Technology of China.
Surface Area Nets & Rectangular Prisms. Rectangular Prisms Made of 6 sides Top & Bottom Front & Back Left & Right.
Warm-up Find the area of the following: show calculations! 1.)2.) 3.) 4 inches 8 ft 12 cm 8ft 3 cm 3 inches.
Large Cell Scope Pictures, Part II HV Gnd 1nF Large Cell Tube Anode signal Phi Cathode signal scope S1 S2 S1 S2 This is a follow-up on Richard’s measurement.
UM PPS Lab Activities - HV Readout Long Run - Single Source Saturation Test PPS meeting April 30, 2012.
Off Axis Collaboration Meeting Feb Richard Talaga, Argonne R&D Common to Monolithic and Container Designs Do we need ~ 98-99% efficient RPCs?
1 Module and stave interconnect Rev. sept. 29/08.
GE1/1 Services and Strips PCB Andrey Marinov On behalf of CMS GEMs collaboration.
Tariq J. Solaija, NCP Forward RPC EDR, Tariq Solaija Forward RPC EDR The Standard RPC for low  regions Tariq J. Solaija National Centre for.
HV connection for a Common GEM foil design Aiwu Zhang
RPC Development in Beijing and Potential for NO A Tianchi Zhao University of Washington May 16, 2005.
Design of a readout system for RPCs Olu Amoda2 The LODEN Group The group is an association of Fermilab scientists who teamed up to build a cosmic ray.
Foundry Characteristics
Prototypes of high rate MRPC for CBM TOF Jingbo Wang Department of Engineering Physics, Tsinghua University, Beijing, China RPC-2010-Darmstadt, Germany.
How to make a 3D Snowflake Using recycled paper. Step 1. Using template cut out 6 additional squares. Using template cut out 6 additional squares. –(Or.
Report on beam test results of high-rate MRPCs Jingbo Wang Department of Engineering Physics, Tsinghua University, Beijing, China.
Front End Board (16 channels) Superlayer Cross Section Frontend Enclosure HV cap board HV cap Board Signals from chamber wires go to HV cap board to be.
High Voltage Components.  Understand the parts and operation of spark plugs  Understand the Kill Switch  How to identify spark plugs.
CMS GRPC detector& cassette I. laktineh. Concepts Two concepts of RE1/1 detectors were developed : 1- One based on gluing glass plates to have large RPC.
1. Take HV harnesses with label (IHV2) and transfer on the Stacking table. 1.1 Inspect HV harnesses visually. 2.1 Insulate HV Flex with 3M™ VHB™ Tape.
Chambers to be installed in ATLAS MSW on Small Wheel MBT0 on front-face of end-cap electromagnetic calorimeter.
SIMPLE/LOW COST ELECTRICITY FOR ELEMENTARY STUDENTS Building Simple Circuits.
Static Electricity. Review: What is inside the atom? The atom is made of 3 kinds of particles. The atom is made of 3 kinds of particles. The electron.
The reading is 7.38 mm. The reading is 7.72 mm.
RE 4/3 RPC Pre-assembly manual 1. HCP case preparation
European DHCAL Meeting 13/06/08
Quality Control Chamber Production
RPC built a new plastic (peek doped with CB)
GRPC activity for EuDHCAL in IHEP-Protvino
Multigap Resistive Plate Chambers (MRPC)
HPS Motherboard Electronic Design
Wire connection instruction
Week 2 Experimentation TS Term 2.
PHENIX RPC R&D EFFORT Beau Meredith
Layer Thickness and Map Width
اختر أي شخصية واجعلها تطير!
High Oil Consumption Engine, # 31
Han Jifeng BESIII MUON GROUP IHEP, CAS
New MWPC for CB Status Report Oct 2004
STAR TOF MRPC Mass Production & Q.C. (USTC)
CONSTRUCTION of TRANSFORMERS
A new type of RPC with very low resistive plates
OIL DISTRIBUTION TRANSFORMERS OIL DISTRIBUTION TRANSFORMERS Presented By 1 Dr. Eng. Adel Abdel-Twab Farag.
construction and tests
Impedance & Bandwidth Measurements of '2-strip anode test plate'
Impedance & Bandwidth Measurements of '2-strip anode test plate'
Impedance & Bandwidth Measurements of '2-strip anode test plate'
Surface Area.

Study of timing properties of single gap high-resistive bakelite RPC
Limited Streamer Tube Project Summary
Back of tub 794 mm (31.25”) 654 mm (25.75”) 06-Jan-06 F.E.Taylor.
Engineering Design Review
A DLC μRWELL with 2-D Readout
Now Buy Best External Door Hardware from Doorhardware
Liceo Scientifico “A. Volta”
Presentation transcript:

Study of Chinese oil-less chamber

Construction details 350 X 350 X 30 mm Insulating surface Gas connections

Construction details Signal pick-up strips Gas/HV terminals Back view Front view

HV test result Top gap V-I characteristics seem to be OK till about 3000V (Current: 0.09A) Current fluctuates beyond this voltage Bottom gap Current, a factor of 10 higher than the top gap

Construction details Double-gap Gap sizes Bottom: 320 X 320 X 6.6 mm Top : 290 X 290 X 6.6 mm Pick-up strips: 13; Strip width: 22 HV contacts made through Cu tapes stuck on graphite surfaces and terminated on gas nozzles!