ECE4006 Group 6 – Presentation 9 Gigabit Ethernet Gautam Khanna http://content.honeywell.com/vcsel/products/datacom.stm
Gigabit Ethernet - Overview Completed/In Progress Tranceiver Board Soldered 2nd and 3rd boards Tested Debugging 2nd Run Tranceiver Layout Revised Gantt Charts Updated Financial Budget Website Updated Upcoming Tasks Order PCB Board Complete Testing of Tranceiver Board Prepare Bill of Materials Start Work on Final Report
Last Week (2nd Tx Board Tested) PRBS7 2nd Tx Board Soldered
This Week….Adjustments Made to 2nd Board PRBS7
3rd Board – Soldering & Surgery
PRBS7 – Baseline Transmitter Test Results of 3rd Board Possible Causes of Jitter: Bad Solder Joints Underneath Ground Plane may be too close to pins which are not grounded NO CAPACITOR DECOUPLING!!!!!!!!! PRBS7 – Baseline Transmitter Test
Attenuation Testing Setup Receiver Testing Attenuation Testing Setup PRBS7
Layout for 2nd Board
Financial Budget
Gantt Chart Update
Tasks For Next Week Order PCB Board Solder the new Tranceiver Board Complete Testing of Tranceiver Board Prepare Bill of Materials Start Work on Final Report