ProJet 3000/3500 Training Daily Agenda

Day 1 8:30 AM: Meet at 3D Systems 8:30- 9:00: Welcome and Introduction 9:00- 9:15: Tour 3D Systems 9:15-10:00: Safety and Material Hazard 10:00-10:30: Removing and Replacing Side Panels 10:30-10:45: Break 10:45-11:15: General Introduction of main assemblies 11:15- 12:00: Drop Mass Tests and Tag Tests 12:00- 1:00: Lunch 1:00- 2:30: X Motion System 2:30- 3:30: Printhead Introduction 3:30- 4:30: Planerizer Introduction 4:30- 5:00: Client Software 5:00: Dismissal 2 4 2

Day 2 8:30 AM: Meet at 3D Systems 8:30- 10:30: Begin Installation Process 10:30-10:45: Break 10:45-12:00: Installation Process 12:00- 1:00: Lunch 1:00- 4:30: Installation Process 4:30- 5:00: Question and Answer 5:00: Dismissal 3 4 3

Day 3 8:30 AM: Meet at 3D Systems 8:30- 10:30: Installation Process 10:30-10:45: Break 10:45-12:00: Planerizer wiper replacement 12:00- 1:00: Lunch 1:00- 3:00: UV Bulb replacement 3:00- 5:00: Material Feed System Removal and Replacement 5:00: Dismissal 4 4 4

Day 4 8:30 AM: Meet at 3D Systems 8:30- 10:30: Printhead Recovery Procedures 10:30-10:45: Break 10:45-12:00: Z Motion, X Motion and Waste System 12:00- 1:00: Lunch 1:00- 5:00: RMT DIAGS 5:00: Dismissal 5 4 5

Day 5 8:30 AM: Meet at 3D Systems 8:30- 9:00: Grade and Review Tests 9:00-10:30: Troubleshooting Test 10:30-10:45: Break 10:45-1:00: Error logs and troubleshooting tips 1:00: Dismissal or Remedial Classroom time 6 4 6