Software for Hardware Intro to ECSE Analysis K. A. Connor

Slides:

Advertisements

Similar presentations

Basic Circuits TEST YOUR BRAIN!.

Advertisements

The Bipolar Junction Transistor

7.2 The Basic Gain Cell 7.3 The Cascode Amplifier

Digital Electronics Dan Simon Cleveland State University ESC 120 Revised December 30, 2010.

Physical States for Bits. Black Box Representations.

Recall Last Lecture Voltage Transfer Characteristic A plot of V o versus V i Use BE loop to obtain a current equation, I B in terms of V i Use CE loop.

1 Applied Control Systems Technology. 2 Pin configuration Applied Control Systems.

Intro to Digital Electronics. Classifications of Electronic Circuits Switching Circuits – by turning electricity on and off. – Figure 1 – Known as the.

Chapter 2: Fundamentals of Digital Electronics Dr Mohamed Menacer Taibah University

General Licensing Class Oscillators & Components Your organization and dates here.

Transistors and Logic Circuits. Transistor control voltage in voltage out control high allows current to flow -- switch is closed (on) control low stops.

Logic Gates How Boolean logic is implemented. Transistors used as switches to implement Boolean logic: ANDOR Logic with Transistors.

Technical Training. 1 Configuration: 2558 Analog Input Module 1. Select voltage or current input mode for each channel 3. Select digital filtering, offset.

3-1 McGraw-Hill Copyright © 2001 by the McGraw-Hill Companies, Inc. All rights reserved. Chapter Three The Bipolar Junction Transistor.

Eng.Samra Essalaimeh Philadelphia University 2013/ nd Semester PIC Microcontrollers.

9/15/09 - L4 Combinational Logic - Gates Copyright Joanne DeGroat, ECE, OSU1 Combinational Logic Circuits – Gates.

Electronics 1 Introductory Lecture Ahsan Khawaja Lecturer Room 102 Department of Electrical Engineering.

Beath High School - Int 1 Physics1 Intermediate 1 Physics Electronics Glossary AND gate to device digital signals to inverter LDR to logic circuit logic.

1 Ethics of Computing MONT 113G, Spring 2012 Session 1 Digital Circuits, binary Numbers Course webpage:

SMART LIGHTING Filters & The Behavior of L and C at Low and High Frequencies K. A. Connor Mobile Studio Project Center for Mobile Hands-On STEM SMART LIGHTING.

SMART LIGHTING Diodes K. A. Connor Mobile Studio Project Center for Mobile Hands-On STEM SMART LIGHTING Engineering Research Center ECSE Department Rensselaer.

SMART LIGHTING Using Excel with Data from Analog Discovery and LTspice K. A. Connor Mobile Studio Project Center for Mobile Hands-On STEM SMART LIGHTING.

Intro to BJT Amplifier Circuits. In this Lecture, we will:  Discuss how a BJT is used as a switch (use this as a frame of reference).  Understand the.

Logic Gates Digital Logic Design. What is a logic gate? A switch with an output that will only turn on when inputs are in particular positions.

LOGIC GATES. INTRODUCTION TO LOGIC GATES Boolean functions may be practically implemented by using electronic gates. The following points are important.

Presented by Under the esteemed guidance of D.GANGADHAR REDDY, M. Tech. Asst. Prof., EEE Department UNIVERSAL COLLEGE OF ENGINEERING & TECHNOLOGY AUTO.

CHAPTER 10 AC Power Bipolar Junction Transistors: Operation, Circuit Models, and Applications.

Logic Gates Unit 16.

Diodes Part II Intro to ECSE Analysis K. A. Connor

Chapter 1 Introduction to Electronics

INDUSTRIAL ELECTRONICS/ELECTRICITY

Different Types of Transistors and Their Functions

Transistors and Logic Circuits

Digital-to-Analog Analog-to-Digital

Bipolar Junction Transistor

A lecture for Arduino Course, Winter 2017/18

EI205 Lecture 15 Dianguang Ma Fall 2008.

Digital Signals Digital Signals have two basic states:

Analog Electronic Circuits 1

PWM? K. A. Connor Mobile Studio Project

PWM? K. A. Connor Mobile Studio Project

Intro to ECSE 1010 Intro to ECSE Analysis K. A. Connor

Digital Electronics, Software and Hardware

Transistor & Voltage Divider

Intro to Engineering Electronics

Op Amps Intro to ECSE Analysis K. A. Connor Mobile Studio Project

Intro to ECSE 1010 Intro to ECSE Analysis K. A. Connor Was ECSE 1961

TEXTBOOK Please be informed that the Electronics textbook will be available from next week at OSCENT, an engineering textbook selling booth arranged by.

Voltages & Currents Intro to ECSE Analysis K. A. Connor

How Boolean logic is implemented

Intro to Analog Discovery

DC Power Supplies Intro to ECSE Analysis K. A. Connor

Phase in Circuits Intro to ECSE Analysis K. A. Connor

Intro to Logic Gates Intro to ECSE Analysis K. A. Connor

Logic Gates Practical Objective: to develop an understanding of logic circuits and truth tables.

Plotting and Analysis with Matlab

Intro to Engineering Electronics

Chapter 1 Introduction to Electronics

Phasor Circuit Analysis

JC Technology Logic Gates.

Transformers Intro to ECSE Analysis K. A. Connor Mobile Studio Project

Exponential Function in Circuits, Part 1

Exponential Function in Circuits, Part 2

ELECTRONIC SYSTEMS Note: There is no compulsory question set on Section 25 of the syllabus. Questions set on topics within Section 25 are always set as.

9.2 Digital Logic, DIO and DAC why digital logic?

Digital Logic Experiment

Digital Logic Design Basics Combinational Circuits Sequential Circuits.

Logic Gates AIM: To know the different types of logic gate

Logic Gates By: Asst Lec. Besma Nazar Nadhem

The state in a stored-program digital computer

Presentation transcript:

Software for Hardware Intro to ECSE Analysis K. A. Connor Mobile Studio Project Center for Mobile Hands-On STEM SMART LIGHTING Engineering Research Center ECSE Department Rensselaer Polytechnic Institute Intro to ECSE Analysis

Outline Digital Static I/O with Analog Discovery ADAP TTL Gates Data Logger Threshold PWM TTL Gates Bar Graph Display

Static I/O 16 Channels Configuration Right Click Channel Input Output Right Click Channel LED for Output Switch for Input Config – Bit I/O

ADAP Download from Analog Discovery Information on Course Website Data Logger 2 Channels Set Times Threshold PWM Cannot Run Simultaneously with Wave Forms

TTL Gates Transistor–transistor logic (TTL) is a class of digital circuits built from bipolar junction transistors (BJT) and resistors. TTL NAND Gate Truth Table Experiment

Bar Graph Display Basic Design Turns on One LED Bar Graph Turns on All LEDs Up to Some Level Requires Different Logic Input 2 LED 2 Input 1 LED 1 Input 1

Functional Blocks Generic Circuit System Source Transfer Function Load Generic Circuit System Source (voltage plus resistance, as in Thevenin Equivalent) Intermediate Circuit (characterized by a transfer function … filter, amplifier, etc.) Load (resistance, capacitance, inductance or combination) Voltage divider for Zin and Zout

Adding Functional Blocks Adding Functional Blocks to a Circuit can Radically Change What the Circuit Does Potential Issues Check input and output impedances to be sure independent functions work together Check input and output voltage, current, power to be sure that they are adequate Voltage Divider Video 6.1 (Designing Circuits from Functional Blocks)

Have Fun