TIGHTEN THE BATTERY TERMINAL Most Effective Methods to

The battery of your car is the most important and essential part of your car's operating system.

When the battery is worn out or fallen, it doesn't always mean that the battery itself is going to be dead.

Sometimes the cables or the terminals of your battery can be loose, so the charge unable to reach the desired place.

So, to continue the flow of the charge in your car, you need to tighten the leads of your car battery.

Here the given points help you to tighten your car battery without having any difficulties.  Check the coverage  Clean the battery terminal  Tighten the battery terminals

Check the coverage

Checking the battery is the simplest solution for maintaining your car. So open the hood to look at the battery cables and the correct terminals.

If you find that the connectors moved or placed incorrectly, the battery will not work the way it should be and damage the components.

The cable attached to the leads of the battery must be insulated to prevent the possibilities of electric shock.

The rust wires can disperse the energy created by the battery and weaker the connection. So, you need to cover it with electrical tape or replace them.

Clean the battery terminal

If you notice that the battery of your car is connected properly, then the terminals can be dirty for producing the charge.

For cleaning the battery terminals, you can apply the cleanser on the terminals as well as the clamps.

You can use the cleanser for cleaning your battery as much as you think because it will not hurt the terminals or anything around them.

You can also use the wire brush for cleaning few parts of your car and wipe it with a clean towel to clean the battery completely.

Tighten the battery terminals

For tightening the battery terminal, you need a socket wrench to turn the bolts available on the clamps in a counter-clockwise to open them.

Then place each of the clamps over each of the terminals on the car battery.

Make sure that the negative clamps on the negative terminals, and the positive clamps over the positive terminals.

Once you will put them in their places, tighten them again with the ratchet and turn it clockwise until it is tightening.

Conclusion

If you want to replace and tighten the car battery or cleaning other parts of the engine, you first need to disconnect the battery.

The connected battery may be losing other components of your car, that should be also lost during the normal uses.

However, by following the above defines methods the battery terminals are very easy to tighten regardless of the situation.

THANK YOU!