Effect Of Wind Load On High Rise Buildings PRESENTED BY, SRUTHI SIVAKUMAR ROLL NO : 20 SECM,S3, M TECH SJCET,PALAI GUIDED BY, Mrs.MARIAMOL KURIAKOSE ASSISTANT.

Slides:



Advertisements
Similar presentations
Properties of Solids and Fluids
Advertisements

Projectile Motion.
Wind Loads: The Nature of Wind
Wind Loads: The ASCE 7 Provisions
Projectile Motion with Wind and Air Resistance
Gliding.
Gravity & Free Fall.
Projectile Motion. 2 components of all projectile motion: Horizontal component (vx) is constant. Vertical component (vy) is affected by gravity.
Prutkova Eugenia and Ryabchenkov Sergei Represent Report on the theme: JASS-2006.
PREPARED BY: JANAK GAJJAR SD1909.  Introduction  Wind calculation  Pressure distribution on Antenna  Conclusion  References.
Networking the World TM 86 Leon Kempner, Jr., P.E. Bonneville Power Administration February 6, 2000 IEEE Three Second Gust Extreme Wind Speed Map, CP2363.
EOSC 112: THE FLUID EARTH ATMOSPHERIC STRUCTURE AND DYNAMICS Atm12 Read: Kump et al. Chap.3, p ; Chap.4, p Objectives: 1.To describe how.
Projectile Motion characteristics and analysis procedures Objectives –Review characteristics of projectile motion (pp ) –Review factors influencing.
Projectile Motion characteristics and analysis procedures Objectives –Review characteristics of projectile motion (pp ) –Review factors influencing.
Review Chapter 12. Fundamental Flight Maneuvers Straight and Level Turns Climbs Descents.
Introduction to Aeronautical Engineering
Velocity and Acceleration. Definitions of Velocity and Acceleration.
Wind Energy.
1. A 1250 Kg car going 23 m/s can gain how much elevation on a very tall hill if it loses no energy to friction? (27 m)
THE BUILDING ENVELOPE: Lecture 4 Designing the Building Envelope.
 Model airplanes are sized down models of an aircraft  The calculations are easy and the importance is given to building of the plane.
한국강구조학회 2001 년도 학술발표대회 Three Dimensional Finite Element Analysis of Structures under Wind Loads *Byoung-Wan Kim 1), Woon-Hak Kim 2) and In-Won Lee 3) 1)
University of Palestine
10 extra topic: Projectile Motion Greg Kelly, Hanford High School, Richland, Washington Photo by Vickie Kelly, 2002 Fort Pulaski, GA.
10.4 Projectile Motion Fort Pulaski, GA. One early use of calculus was to study projectile motion. In this section we assume ideal projectile motion:
KEY KNOWLEDGEKEY SKILLS Projectile motion of the human body and objects through the air and through water  Key principles associated with projectile motionof.
Ground-based energy flux measurements for calibration of the Advanced Thermal and Land Application Sensor (ATLAS) Eric Harmsen, Associate Professor Dept.
Chapter 4 Newton’s Laws of Motion. Newton’s First Law of Motion Every object continues in its state of rest, or of uniform motion in a straight line,
1 The trend for international standards is to adopt and adapt the ASCE-7 approach for primary systems.
Aerodynamic Forces Lift and Drag.
Grade 5/6 Environmental Science JEOPARDY THIS IS JEOPARDY.
Basic Aeronautics Know the principles of basic aeronautics. 1. Describe the effects of angle of attack. 2. Identify the four forces of flight.
Principles of Flight Chapter 1 – Lift and Weight.
All forces that affect motion.
1 Chapter 10-Forces All forces that affect motion.
Lecture 20 Ground Water (3) Ground water movement
Ground-based energy flux measurements for calibration of the Advanced Thermal and Land Application Sensor (ATLAS) Eric Harmsen, Associate Professor Dept.
ASCE Wind Loads SESSION 1-2 Wind Engineering Theory: Bluff Body Aerodynamics.
Basic Aeronautics Know the principles of basic aeronautics. 1. Describe the effects of angle of attack. 2. Identify the four forces of flight. Lesson.
Aerodynamics By. NBueckert. What is Aerodynamics  Aerodynamics is making an object affect the air flow around it  It also is a type of Fluid Dynamics.
Flight Investigations TEXT BOOK CHAPTER 16 PAGE
Physics Section 4.4 Describe various types of forces Weight is a measure of the gravitational force exerted on an object. It depends upon the objects.
Lecture Leading Cadet Training Principles of Flight 2 Lift and Thrust.
Parametric Study of Turbine Cascades P M V Subbarao Professor Mechanical Engineering Department Identification of New design Variables.……
Vocabulary Set #1. Condensation the process of changing from a gas to a liquid.
 Gravity is the force of attraction between two objects due to their masses  Acceleration is the rate at which velocity (speed with a direction) changes.
Lay-On Gable Frame Connection Overview. Introduction A lay-on gable frame is typically connected from the top during truss placement, but after sheathing.
Airfoil in a Wind Tunnel Experiment #6
ARC 810: Building Climatology Department of Architecture, Federal University of Technology, Akure, Nigeria ARC 810: Building Climatology Department of.
The Nature of Force and Motion 1.Force – A push or a pull – How strong it is and in what direction? 2.Net Force – The sum of all forces acting on an object.
FLUID  a substance, such as a liquid or gas, that is capable of flowing and that changes its shape at a steady rate when acted upon by a force tending.
Chapter 6 Forces and Motion Section 1 Gravity and Motion.
Unit 2 BASICS OF FLIGHT MECHANICS
Weather Lesson Two Pressure and Wind.
Four Forces of Flight Lift Weight Thrust Drag
SHERINE RAJ AP/CIVIL ENGINEERING DEPARTMENT OF SCD
MASS training of trainers General Physics
Airplane and Pilot Performance
Oregon State University PH 211, Class #6
Force Force is a push or a pull that alters the state of motion of a body and can be calculated using the following equation: Force = mass x acceleration.
Maths Unit 16 – Measures & Bearings
Projectile Motion.
Lesson: Similar Solids
Using and rearranging the lift calculation
Introduction to Aeronautical Engineering
What is Projectile Motion?
 More Fluids  November 30,  More Fluids  November 30, 2010.
Chapter 2 Sec. 2 Friction and Gravity
Drag and Lift Elliott.
WHAT IS FLUID? Fluid is a substance that is capable of flowing. It has no definite shape of its own. It assumes the shape of its container. Both liquids.
Presentation transcript:

Effect Of Wind Load On High Rise Buildings PRESENTED BY, SRUTHI SIVAKUMAR ROLL NO : 20 SECM,S3, M TECH SJCET,PALAI GUIDED BY, Mrs.MARIAMOL KURIAKOSE ASSISTANT PROFESSOR DEPT.OF CIVIL ENGINEERING SJCET,PALAI

INTRODUCTION Structural engineers need to consider the effect of wind forces on civil engineering structures. These studies are conducted to first evaluate the dynamic effect of wind on the structure and then to optimize the design to mitigate these effects. Wind is essentially the large scale horizontal movement of free air. It play an important role in design of tall structures because it exerts loads on buildings.

As per ASCE guideline for wind load calculation 3sec gust speed at 10m above the ground is considered. Structures in wind are subjected to forces which vary with time and space.

Wind load Depends upon :- Velocity and density of the air Height above ground level Shape and aspect ratio of the building Topography of the surrounding ground surface Angle of wind attack building Solidity ratio or openings in the building

WIND PRESSURE