Welcome to our Web Ex! Super II Repairs
Super II Repairs Calibration Span Linearity MILC Replacement Firmware Replacement Keypad/Controller Assembly Replacement RSO Installation Super II Repairs
Super II Repairs Span Calibration Press Menu Press Softkeys MORE Enter the value of of the span weight using the numeric keypad. Press softkey ENTER or choose either 50% or 100% Place the required weight on the pan Press the SPAN softkey The scale will perform a span calibration and display the weight value. Press Menu Press Softkeys MORE SETUPS TECH CALIB SPAN Super II Repairs
Super II Repairs Linearity Calibration Press Menu Press Softkeys MORE SETUPS TECH CALIB Super II Repairs
Locate access to cal protect switch in plate
Move switch forward to calibrate position with screwdriver.
Protect Calibrate Move switch forward to calibrate position with screwdriver.
Protect Calibrate Cal-Protect Switch
Add weight as displayed
Move switch to back to protect position with screwdriver.
MILC Replacement Super II Repairs
Remove Plate
Disconnect rear power board rainbow cable
Loosen bolts at base
Remove MILC
Install New MILC
Position new MILC. Bolt in place.
Connect Rear Power Board to Weigh-Only Board
Buy 1 404 MILC, get 1 FREE Offer good until July 31, 2003
Firmware Replacement Super II Repairs
Turn controller to back
Unscrew fasteners on back
Rev 4 Check revision of board
Rev C Check revision of board
Rev B Locate Firmware IC
Remove Firmware IC
Replace IC. Align “U” indentation at top of chip with “U” in socket
Replace IC. Align “U” indentation at top of chip with “U” in socket
Move jumper to “DIS” disable and back to “EN” enable to reset board
Replace back of controller
Keypad/Controller Assembly Replacement Super II Repairs
Remove back of controller.
Disconnect keypad cable
Disconnect back light connection
Disconnect Display Cable
Unscrew controller board
Remove controller board
Unscrew display board
Remove Display Board
New keypad/controller assembly
Reinsert display board into new keypad assembly and tighten screws
Insert controller board
Reconnect backlight - note position of tab
Plug in backlight - note position of tab
Connect new keypad
Reconnect display
Replace back of controller
RSO Installation Super II Repairs
Remote Scale Option
Remove pan and unscrew plate
Place RSO bolts
Disconnect coil cord to rear power board
Slice radius of rubber grommet
Place rubber grommet around coil cord
Slip rubber grommet w/ coil cord onto RSO board
Slip RSO board onto bolts and tighten bolts
RSO Weigh-only Board Connect RSO Rainbow cable to JP5 on Rear Power Board Caution: Do not connect RSO cable to JP4
Overview of RSO Installation See manual
DIN Connector
Super II (the sequel) ... Super II Macros “ Programming Macros” Those pesky macros….. Join us next Wednesday, July 23, at 2:00 EDT for... Super II (the sequel) ... “ Programming Macros” Step by Step Super II Macro Training to cover: > Stability > Redirect > Execute > If/Then Statements Check your Inbox…Your invitation is there! Super II Macros
That’s it! Thanks for joining us…see you next Wednesday, same time, same place. Our thanks to WebEx - “We’ve got to start meeting like this”