Communicate with an NA through the NX102 Routing - NX102 Communicate with an NA through the NX102

Warning In order to work with this document, the user is expected to have basic Sysmac knowledge. This quick start instruction has been compiled with great care, but we can not guarantee that the information in this document is correct and complete. If in doubt, consult the recommended manuals and / or datasheets. If you find an imperfection in one of our quick start instructions, please report this via our helpdesk at (IA.Techsupport@Omron.com) so that we can improve this.

Minimum Required Software Qty Part Number Description 1 SYSMAC-SE200D Sysmac Studio DVD (v1.23 or newer) SYSMAC-SE201L Sysmac Studio single license Hardware NX102-1100 All NX102 CPU’s are possible NA5-12W101 All NA HMI’s are possible 2 Ethernet Cable 2x RJ45, all lengths <100 m CP1W-CN221 USB cable 1.8 m A-type to B-type S8VK-S06024 24 VDC, 60 W power supply Documentation Code W506 CPU Unit Built-in EtherNet/IP Port User Manual

Wiring diagram PC with Sysmac Studio NX102-1100 IP:192.168.250.15 GW: 192.168.250.1 NA5-12W101 EtherNet Cable USB cable IP:192.168.250.1 IP:192.168.251.1 S8VK-S06024 IP:192.168.251.20 GW: 192.168.251.1

Setup PC Open the settings for the Ethernet connection that is being used Possibly close all other connections Set the IP address For this example, the following IP addresses are used: IP: 192.168.250.15 subnet: 255.255.255.0 Default Gateway: 192.168.250.1 Note: Windows can have multiple Default gateways. By default all data will go through the first Default gateway or via the port with the highest priority. Turn off all other connections (including Wi-Fi) or remove the cable.

Setup NX102 Open Sysmac Studio and select new Project Start with a new Controller type NX102-xxxx Open Controller Setup in the Multiview Explorer Select Build-in Ethernet / IP Port Settings

Setup NX102 Set the IP addresses For this example the default IP addresses are used: Port 1: 192.168.250.1 subnet: 255.255.255.0 Port 2: 192.168.251.1 subnet: 255.255.255.0 Set the IP Forward to Use(default setting) Scroll down

Setup NX102 Go online with the controller If necessary, set the communication settings correctly via the Controller Communication setup Synchronize the project with the controller

Setup NA "Add" an NA HMI in the existing project Choose the NA in the Multiview Explorer

Setup NA Open HMI Settings in the Multiview Explorer Select TCP/IP Settings Set the IP address For this example, the following IP addresses are used: IP: 192.168.251.20 subnet: 255.255.255.0 Default Gateway: 192.168.251.1

Setup NA Go online with the HMI via USB If necessary, adjust the communication settings via HMI - Communication Setup Synchronize the project with the NA

Online NA Disconnect the NA if it is still open (USB) and remove the USB cable Fill in IP address, subnet and default gateway via the HMI Set the communication settings to the next setting via Controller Communication Setup Ethernet Connection via a hub IP adres 192.168.251.20 Go Online If it does not work, check Default gateways on the PC eg via CMD + ipconfig Test does not always work in this case