Introduction and Principle of IR Spectrophotometry

Slides:



Advertisements
Similar presentations
Molecular Vibrations and IR Spectroscopy
Advertisements

I.R. Spectroscopy C.I. 6.4.
Structural Determination (IR)
Infrared Spectroscopy
The Greenhouse Effect. Terrestrial Emissions Terrestrial emissions have energies corresponding to the infrared (IR) region of the electromagnetic spectrum.
UV / visible Spectroscopy
Lecture 6. FT-IR and Raman Spectroscopy. FT-IR Analytical infrared studies are based on the absorption or reflection of the electromagnetic radiation.
1 CHAPTER 9 Spectroscopy: the study of the interaction of energy with matter Energy applied to matter can be absorbed, emitted, cause a chemical change,
The electromagnetic spectrum covers a continuous range of wavelengths and frequencies, from radio waves at the low-frequency end to gamma (  ) rays at.
Introduction to Infrared Spectroscopy
Lecture 3 INFRARED SPECTROMETRY
Time out—states and transitions Spectroscopy—transitions between energy states of a molecule excited by absorption or emission of a photon h =  E = E.
Fourier transform infrared spectroscopy[FTIR]
Understanding infrared spectroscopy
What Are Some Types of Spectroscopy ?
Common types of spectroscopy
Microwave Spectroscopy Rotational Spectroscopy
Spectroscopic Analysis Part 4 – Molecular Energy Levels and IR Spectroscopy Chulalongkorn University, Bangkok, Thailand January 2012 Dr Ron Beckett Water.
KHS ChemistryUnit 3.4 Structural Analysis1 Structural Analysis 2 Adv Higher Unit 3 Topic 4 Gordon Watson Chemistry Department, Kelso High School.
1 University of Petra Faculty of Science & Arts Department of Chemistry Seminar I.R Spectroscopy By Firas Al-ouzeh Supervisor : Nuha I. Swidan Summer 2007.
Spectroscopy.  Spectroscopy is the study of the interaction of electromagnetic radiation with matter. There are many forms of spectroscopy, each contributing.
INFRA RED ABSORPTION SPECTROSCOPY Kateřina Hynštová.
Structure Determination by Spectroscopy Mass spectroscopy Ultraviolet-visible spectroscopy Infrared spectroscopy Nuclear magnetic resonance spectroscopy.
TOPIC D: SPECTROMETRY AND SPECTROSCOPY. Mass spectrometry is used to detect isotopes. mass spectrometer uses an ionizing beam of electrons to analyze.
Infrared Spectroscopy and Mass Spectroscopy
States and transitions
Important concepts in IR spectroscopy
SPECTROSCOPIC CONCEPTS BY Dr.JAGADEESH. INTRODUCTION SPECTROSCOPY: Study of interaction of matter with electromagnetic radiationelectromagnetic radiation.
441 Chem Introduction to Spectroscopy CH-1 1. Introduction to Spectroscopy Set of methods where interaction of electromagnetic radiation with chemical.
Infrared Spectroscopy
INFRARED SPECTROSCOPY
Infrared Spectroscopy
Infrared Spectroscopy
INTRODUCTION TO SPECTROSCOPY
The Electromagnetic Spectrum
Infrared Infrared radiation extends from the nominal red edge of the visible spectrum at 700 nanometers (nm) to 1 mm. NameWavelength Gamma rayless than.
IR Spectroscopy CHM 411 Suroviec. I. Theory of IR Spectroscopy Frequency of absorbed radiation is the molecular vibration frequency responsible for absorption.
Spectroscopy and Atomic Spectra A satellite orbiting the Earth contain gravitational potential energy. The satellite can orbit the Earth at any height.
IR, NMR, and MS CHEM 315 Lab 8. Molecular Structure and Spectra The most powerful and efficient methods currently in use to characterize the structure.
Introduction to Infrared Spectroscopy
Absorption Spectroscopy
Infra-Red (IR) Spectroscopy Vibrational spectroscopy
Infrared (IR) Spectroscopy for Structural Analysis Ridwan Islam.
Introduction and Principle of IR Spectrophotometry
MOHAMED NIJAS V S5 I.S.P. CONTENT  SPECTROSCOPY.  IR SPECTROSCOPY.  MOLECULAR VIBRATIONS.  EXPERIMENTAL SETUP.  FUTURE DIRECTIONS.
SPECTROSCOPY SL Chemistry Topic IHD – Index of hydrogen deficiency (degree of unsaturation) ■Used to determine from a molecular formula the number.
Molecular Spectroscopy
Infrared Spectroscopy
Ultraviolet–visible spectroscopy UV
IR Spectroscopy سپکتروسکوپی ماتحت سرخ
Infrared Spectroscopy
Spectroscopy Chem honors.
ADINA INSTITUTE OF SCIENCE AND TECHNOLOGY
Molecular Vibrations and IR Spectroscopy
IR-Spectroscopy IR region Interaction of IR with molecules
Analytical methods Prepared By Dr. Biswajit Saha.
Molecular Vibrations and IR Spectroscopy
IR-Spectroscopy IR region Interaction of IR with molecules
INFRARED SPECTROSCOPY Dr. R. P. Chavan Head, Department of Chemistry
ADINA INSTITUTE OF SCIENCE AND TECHNOLOGY
The Electromagnetic Spectrum
Molecular Vibrations and IR Spectroscopy
化工群英文示例 沙鹿高工 簡佩琳.
LI: Understand how IR Spectroscopy works
Presentation On INFRARED SPECTROSCOPY
Introduction During the last years the use of Fourier Transform Infrared spectroscopy (FTIR) to determine the structure of biological macromolecules.
IR-Spectroscopy Atoms in a molecule are constantly in motion
Presentation transcript:

Introduction and Principle of IR Spectrophotometry

Spectroscopy Method of “Seeing the unseeable” using electromagnetic radiation to obtain information about atoms and molecules that are too small to see. Atoms Molecules

Spectroscopy is an instrumentally aided study of the interactions between matter (sample being analyzed) and energy (any portion of the electromagnetic spectrum) EMR SPECTROPHOTOGRAPH ANALYTE Conc. should be lower 1.UV-Visible radiations--------excitation of electrons---------UV-visible spectrum 2.IR-radiations------------------vibration changes in electrons--------IR spectrum 3.Radio frequency---------------spin rotational changes-------------N.M.R spectrum

IR spectrophotometry Energy of molecule = Electronic energy+ Vibrational energy + Rotational energy IR spectroscopy is concerned with the study of absorption of infrared radiation, which causes vibrational transition in the molecule. Hence, IR spectroscopy also known as Vibrational spectroscopy. IR spectra mainly used in structure elucidation to determine the functional groups.

IR region: 0.8 µm (800nm) to 1000 µm (1mm) Near IR: 0.8-2 µm Middle IR: 2-15 µm Far IR: 15-1000 µm Most of the analytical applications are confined to the middle IR region because absorption of organic molecules are high in this region. Sub divided into

Principle of IR spectroscopy Molecules are made up of atoms linked by chemical bonds. The movement of atoms and the chemical bonds like like spring and balls (vibration) This characteristic vibration are called Natural frequency of vibration.

When energy in the form of infrared radiation is applied then it causes the vibration between the atoms of the molecules and when, Applied infrared frequency = Natural frequency of vibration Then, Absorption of IR radiation takes place and a peak is observed. Different functional groups absorb characteristic frequencies of IR radiation. Hence gives the characteristic peak value. Therefore, IR spectrum of a chemical substance is a finger print of a molecule for its identification.

Criteria for a compound to absorb IR radiation Correct wavelength of radiation Change in dipole moment 1. Correct wavelength of radiation: A molecule to absorb IR radiation, the natural frequency of vibrations of some part of a molecule is the same as the frequency of incident radiation.

2. Change in dipole moment A molecule can only absorb IR radiation when its absorption cause a change in its electric dipole A molecule is said to have an electric dipole when there is a slight positive and a slight negative charge on its component of atoms.

Molecular vibrations There are 2 types of vibrations: Stretching vibrations Bending vibrations Stretching vibrations: Vibration or oscillation along the line of bond Change in bond length Occurs at higher energy: 4000-1250 cm-1 2 types: Symmetrical stretching Asymmetrical stretching

a) Symmetrical stretching: 2 bonds increase or decrease in length simultaneously. H C

b) Asymmetrical stretching in this, one bond length is increased and other is decreased. H C

2. Bending vibrations Vibration or oscillation not along the line of bond These are also called as deformations In this, bond angle is altered Occurs at low energy: 1400-666 cm-1 2 types: In plane bending: scissoring, rocking Out plane bending: wagging, twisting

a) In plane bending Scissoring: This is an in plane blending 2 atoms approach each other Bond angles are decrease H C

Movement of atoms take place in the same direction. Rocking: Movement of atoms take place in the same direction. H C

b) Out plane bending i. Wagging: 2 atoms move to one side of the plane. They move up and down the plane. Twisting: One atom moves above the plane and another atom moves below the plane. H C H C