How to Change a Flat Tire

Slides:



Advertisements
Similar presentations
POWER TOOLS.
Advertisements

The primary learning outcomes desirable from this lesson are as follows: 1)Become knowledgeable concerning the various types of vehicle insurance and.
Brake System Diagnosis and Repair
Car Hoist.
CHAPTER 13 HANDLING EMERGENCIES.
Training Meeting: ‘Handy Man 101’ October 21, :00pm CE 110.
Changing the Oil in a 2006 Mitsubishi Eclipse. Introduction Changing the oil in your 2006 Mitsubishi Eclipse is easier than you may think. With a few.
Basic Automotive Care Oil, Transmission Fluid, Brake Fluid, Power Steering Fluid, Radiator Coolant, Tires.
Representor: Yoo D. Moon Date : November 25, 2008.
Service Brake Adjustments Eric Shogren. Tools Must Haves Wrench 4 Jack Stands Nice to Have Adjusting Board.
Chapter 15 Handling Emergency.
are included in this kit.
Honda 450 Installation Manual.
Mr. Jody Hannan Automotive Technology.  Topic- This presentation will give students knowledge of emergency car repair. We will explore how to change.
1 STEPMILL 7000 PT ASSEMBLY INSTRUCTIONS PART NUMBER
Traffic Safety Series How to Change a Tire Oklahoma Department of Corrections.
Presented by: Ginnette Clark Terri Hall Robert Ishmael Michael Petry.
Figure Caption Bicycle Component: short description of function and location Removal: Tools: Inspection: ##
MyLock 644D Service Seminar.
Legacy High School Drivers Education
Robot Quick Build Session Frame Assembly Instructions Produced by Ed Latimer, Team 476 Ken York, Team 476 Ron Markum, Team 1750 Special Thanks to Oklahoma.
January 7, 2013 Changing or replacing G460 sensors Slide 1 November 9, 2012 Changing or replacing G460 sensors.
How to Change Your Oil By: Sam Wallace. Overview Introduction (Importance) When? Tools Required Changing the Oil Clean Up.
POWDER PUFF AUTO’S Beginners’ Automotive Training for Moms.
Step 1 Park vehicle on a level surface then engage the parking brake and turn off engine. If you cannot comfortably get under the car, raise the front.
CHANGING A FLAT TIRE WHY ME! I’M GOING TO BE LATE TO SCHOOL.
How To Replace Your Fuel Filter On a 1998 Mustang GT.
Driving in Adverse Weather and Driving Emergencies FLIPPED CLASSROOM Ms. Sacony Name: ___________________________.
Jack Stands and their Proper Use. Jack Stands The tire-changing jack that comes with your car is safe only for changing tires - any under-the-car work.
Job Hazard Analysis Proactive Planning to Prevent Incidents Also known as: Task Safety Analysis, Job Safety Analysis Pre-requisites: None Course Goals:
Changing your car's oil yourself is not only a money saver—it’s also a lot easier than it sounds! By Rachel Ammann ENGL 393.
USING THE DRIVE-ON HOIST. LOADING VEHICLE ON HOIST 01. Ensure that vehicle is centered left to right. 02. Make sure vehicle is in Park, parking brake.
Period 8Gary Clements1 How to do an oil change Gary Clements Period 8.
Getting Ready Gather tools, oil and filter. If you plan to change your oil regularly, consider investing in jack stands, a socket set and an oil drain.
310 Series Basic Leveling Procedure
Figure Caption Bicycle Component: short description of function and location Removal: Tools: Inspection: ##
BY: JORDON BIORGE Quite the Squeak and Change your Pads.
Six Simple Steps to Fix a Flat
HOW TO CHANGE OIL IN A CAR
Presented by: Timothy Wheeler December 4 th, 2008 ENGL393, Mrs. Harris.
By Victor Moctezuma. Have you Ever?  Have you ever been driving comfortably in your car listening to your favorite jams, when all of a sudden one of.
HOW TO CHANGE A TIRE. Take out the following items for you vehicle: - Spare Tire - Jack - Tire Iron - Lug Nut Key(if applicable) Spare Tire Jack Tire.
EMERGENCY SITUATIONS SKIDS Emergency Stops Running off the pavement Car Fires, Electrical wires Plunging into Water Hood Latch Failure Wind shield wiper.
JOB SAFETY ANALYSIS Presentation. ANY New Job/ Activity Recognize the Hazards Plan the work Protect the people Before starting ANY new job/ activity,
4 Square Diagram with Transitional Words Review (AGAIN)
A device used to lift and hold a car to change a tire jack.
Tire Rotation Tire rotation extends the life of your tires.extends the life of your tires In most cases tires should be rotated every 6000 miles (10,000.
Alyssa,Ben,Mike &Tyler.  These instructions are intended for anyone whose vehicle has a flat tire and wishes to change it themselves, but is unfamiliar.
AVIVA™ ELECTRIC BIKES VIPER ASSEMBLY INSTRUCTIONS Aviva™ - For A New Way Of Life.
The primary learning outcomes desirable from this lesson are as follows: 1)Become knowledgeable concerning the various types of vehicle insurance and.
Getting Back On the Road Again After a Flat Tire October 2011.
 A car Jack  A wrench  A flat surface Put the car into park and apply the parking brake.
6 Things Every Driver Should Know. 1) How to Change a Tire 1 st : Once you have a flat, stop at a SAFE place to change your tire. 2 ND : Grab the spare,
GSE Towing and Recovery Vehicle Operations
Drive Right Chapters 12 and 13
Dismounts & Tactics Pages
St. Francis Prep Driver Education
Bilge Pump Service Project Model Service Kit
Service Procedure For Changing Engine Oil And An Oil Filter
What all Teens Need to Know About Cars
Performing Basic Maneuvers
Servicing the Steering System
Effective Methods to Remove the Broken Key from the Ignition.
W201 3R hardboard Replacement Procedure.
310 Series Basic Leveling Procedure
Alabama Driver Manual Chapter 3
PROPER USE OF FLOOR JACK AND SAFETY STANDS
Changing Oil and an Oil Filter
How to Change Tires on a Rim?
Presentation transcript:

How to Change a Flat Tire Representor: Yoo D. Moon Date : November 25, 2008

Introduction What you will need Process Tips and warning

What you will need Jack Lug wrench Spare tire Tire blocks (Optional) Gloves (Optional) Flashlight (Optional)

Process Step 1 : Choose your spot well Put the car in park in a level area Apply parking break Put manual transmissions in gear Turn Engine off/ turn on hazard light Open the hood

Process Step 2 : Remove tools from vehicle Wedge wheel using a solid object Get a spare tire, lug nut wrench, and jack. Step 3 : Loosen the lug huts Remove the hubcap, if necessary Using the lug wrench, begin to loosen the lug nuts Do not remove the lug nuts, only loosen them

Process Step 4 : Jack up the vehicle Position the jack under the car, and raise until it contacts the frame Position the jack on the right position Contacts the car at a small plate on the frame of the car The plate is located just in front of the rear tires, and just behind the from tires. Extend the jack about 6 inches off the ground

Process Step 5 : Remove the flat tire Remove the lug nuts from the bolts, and put them aside Grab the wheel Easy way : grab the tire at the “nine o’clock” and “three o’clock” position Pull the wheel straight toward you, and off the car

Process Step 6 : Put on the spare tire Position the spare tire directly in front of the wheel well Align the holes in the center of the spare tire with the bolts on the car Lift the spare tire and position it on the threaded bolts Push the tire onto the car until it cannot go any father Replace the lug nuts on the bolts and tighten them, but not too tight

Process Step 7 : Lower the vehicle Lower the car with the jack until the car is again resting on all four tires Tighten the lug nuts with one, then moving to the one opposite it, and so on 1 3 5 2 4

Process Step 8 : Put the tools away Place the tools and the flat tire back to the original place Carefully inspect your work area and make sure that you are not leaving anything

Process Put them all together

Tips and Warnings Squirt oil on the base of stuck lug nuts Keep equipment ready Never get under car with only a jack for support Pull lug nuts (Don’t push) Use knees (Not back) when using wrench