Performance Specifications

Slides:



Advertisements
Similar presentations
Db Decibels Decibels. "A" Weighting Attenuates the lower frequencies to approximate the response of the human ear, which is most sensitive to frequencies.
Advertisements

Oscilloscope Traces. Looking at sound waves You cant see a sound wave. But you can use an oscilloscope to make a trace which looks the same as the sound.
Transformer Coupling.
Analog-to-Digital Converter (ADC) And
Grounding Issues and Interfacing Balanced and Unbalanced Signals.
ENEL 583/589 Electrical, Computer, and Software Engineering In modern society, machinery is frequently used to make our lives simpler, and to help us carry.
RF Circuit Design Chris Fuller /7/2012.
E0262 MIS - Multimedia Playback Systems Prof Pallapa. Venkataram, Electrical Communication Engineering, Indian Institute of Science, Bangalore – ,
CE 478: Microcontroller Systems University of Wisconsin-Eau Claire Dan Ernst Analog to Digital (and back again) Interfacing a microprocessor-based system.
Antennas Lecture 9.
f has a saddle point at (1,1) 2.f has a local minimum at.
Advanced Lecture.  dynamic range The ratio of the loudest (undistorted) signal to that of the quietest (discernible) signal in a unit or system as expressed.
Audio Levels in TRICX. TRICX-AIU BOARD TESTER Utility to control TRICX-AIU inputs and outputs o Use to select mic source for testing levels Installed.
1 Electronic Circuits COMMON EMITTER CIRCUITS. 2 Electronic Circuits AMPLIFIERS CAN BE CLASSIFIED AS EITHER: VOLTAGE AMPS POWER AMPS AMPLIFIERS CAN BE.
Study of Actual State of Wireless Technology in Residential Environments Mo Sha Peng Li Jing Xia.
 The output from a single amplifier is generally insufficient to drive an output device. In other words, the gain of a single amplifier is inadequate.
Link Budget Calculation
Calibration & Curve Fitting
Microwave Amplifier Design Blog by Ben (Uram) Han and Nemuel Magno Group 14 ENEL 434 – Electronics 2 Assignment
Care Use and Feeding of a MFJ-259B Antenna Analyzer.
Digital to Analog Converters (DAC) 1
MIDI. A protocol that enables computers, synthesizers, keyboards, and other musical devices to communicate with each other. Instead of storing actual.
Chapter 2.  Types of Network  Circuit Switched & Packet Switched  Signaling Techniques  Baseband & Broadband  Interference  Transmission Medium.
Receivers.
Korea University Ubiquitous LAB. Chapter 2. RF physics Ph.D Chang-Duk Jung.
Wireless Earphones Avionne Maurice & Jacqueline Suarez Advisors: Prof. Hassib & Hedrick March 5, 2005.
COMPUTED ENVELOPE LINEARITY OF SEVERAL FM BROADCAST ANTENNA ARRAYS J. Dane Jubera 2008 NAB Engineering Conference.
Transport Layer To provide reliable process to process data delivery and recovery. Unit is segments. Sessions Layer To establish, manage and terminate.
Developing Design Specifications Taken from engineering design: a project-based introduction by dym & little.
Toshiba RF Project Presentation 12: 02/17/2005 Team: Josue Caballero, Brett DiCio, Daniel Hooper, Efosa Ojomo, George Sewell.
ELEC 423 Digital Signal Processing Prof. Siripong Potisuk.
DISP 2003 Lecture 6 – Part 2 Digital Filters 4 Coefficient quantization Zero input limit cycle How about using float? Philippe Baudrenghien, AB-RF.
1 Electronic Circuits MULTI STAGE AMPLIFIERS. 2 Electronic Circuits There are several different multi-stage amp circuits that function as dc-amps. 1)COMPLIMENTARY.
CommunicationElectronics Principles & Applications Third Edition Chapter 6 Radio Transmitters ©2001 Glencoe/McGraw-Hill Louis E. Frenzel.
A tree line has a central line connecting together a series of star networks. The server is connected to a central line. Tree Network As the star, and.
Tests of Random Number Generators
SRI & Lexile Measures. Using Lexile Levels and SRI Data for Improving Reading Instruction.
IEEE802.11a 指導教授 : 高永安 學生 : 陳穎俊. PLCP preamble.
Digital Sound Projection ECE 477 Group 6 Patent Liability Steve Anderson Mike Goldfarb Shao-Fu Shih Josh Smith.
Connectors & Cables © D. J. McMahon rev
Analog/Digital Conversion
Engineering Vocabulary By: David Flores. Additive Synthesis A synthesis technique that creates a periodic signal by adding sinusoids together.
Electrical Characteristics of ICs Part 3 Last Mod: January 2008  Paul R. Godin.
Basic Components used in Electronics. Used in electronic circuits to charge up to a given potenti al.
©F.M. Rietti Communication Lines Fundamentals. ©F.M. Rietti LM-18 Computer Science SSI Embedded Systems I 2 Communication Lines Generally used to connect.
Prototype Sensor Status and Measurements u Sensor Response Measurements u Mechanical Response u Noise Expectations u DAQ Status.
Copyright © 2005 Heathkit Company, Inc. All Rights Reserved Automating and Integrating Residential Systems Presentation 4 – Control of Entertainment Equipment.
Describing Arc Flash Incident Energy per Feeder Length in the Presence of Distributed Resources Tom R. Chambers, P.E. Power System Engineering, Inc. Madison,
Kankeshwaridevi institute of technology Subject Code : Name Of Subject : ELECTRONICS DEVICES AND CIRCUITS Topic : POWER AMPLIFIER Name of Faculty.
Universal IR Controller -- Home Automation. Universal IR Controller Features 360° full range IR launch Wifi, RF communication Remote control Delicate.
Fundamentals of Communications. Communication System Transmitter: originates the signal Receiver: receives transmitted signal after it travels over the.
INSTALLING AUDIO VIDEO CCTV SYSTEM 3. Explain the principles of camera placement monitoring By Sarbini S.Pd, SMK Muh 3 Yogyakarta)
Dynamic Handheld W/L Microphone
Antenna An antenna is a transducer that converts radio frequency electric current to electromagnetic waves that are then radiated into space. The electric.
Analog to Digital Converters Electronics Unit – Lecture 7
Proposal for IEEE802.11g Receiver Maximum Input Level in OFDM Mode
Triangle Inequalities
Waves Vocab.
Accuracy and Precision
Triangle Inequalities
CHARACTERISTICS OF RADIO RECEIVERS
Analogue Inputs and Processing
VCE IT Theory Slideshows
A. Linearity B. Sensitivity C. Selectivity
X y y = x2 - 3x Solutions of y = x2 - 3x y x –1 5 –2 –3 6 y = x2-3x.
Length 4.5m = 9cm on the scale drawing Scale 1cm to 0.5m
ANALOG VS DIGITAL Analog devices and systems: Process analog signals (time-varying signals that can take any value across a continuous range known as dynamic.
Electromagnetic Spectrum Notes
Entry Guideline Template
The Need Specification
Presentation transcript:

Performance Specifications A description of how well an artifact performs

Prescriptive Performance Specifications Range of acceptable performance Performance, not product or means of achieving that performance Stated in way that is independent of a particular solution Quantify, if possible range maximum or minimum

Examples Weight and length of ladder Loudness of radio Frequency response of audio Power radio consumes Sensitivity to rf signals How far digital indicators can be read

Interface Performance Specifications How well devices or systems must work together with other systems Physical fit with each other Electrical impedance matching Under the hood of an automobile

Detailed Design Performance Specifications After the fact, how the device actually operates after it is created