DC Power Supplies Intro to ECSE Analysis K. A. Connor

Slides:



Advertisements
Similar presentations
Current Electricity - Symbols
Advertisements

Wiring Color Codes for McLean County 4-H Projects.
Register Digital Multimeter Usage Click Register to begin the course.
“Power Supply” Controls Voltage Difference in Voltage is set Output Current is “as requested” by attached device.
Current Electricity - Symbols Identify the Symbol.
OBJECTIVES 1. Create correctly sized connectivity cabling.
Solar Energy Station Directions. Making a Solar-Powered Circuit 1.Make sure your solar panel is in direct sun. 2.Get the clear LED bulb. 3.Use a red jumper.
CHAPTER Wiring Schematics and Circuit Testing 9 Copyright © 2016 by Pearson Education, Inc. All Rights Reserved Automotive Electrical and Engine Performance,
Wiring Schematics and Circuit Testing
4.2.3B Electrical Power What About Watts?. Power Law Moving electrons (current) requires ENERGY How much energy gets used depends on: Strength of push.
Charge and Current: More Practice. A Review of Circuits: Student Learning Goal The student will be able to construct and then compare and contrast.
SMART LIGHTING Energy Storage Circuit Elements (aka L & C) K. A. Connor Mobile Studio Project Center for Mobile Hands-On STEM SMART LIGHTING Engineering.
1 of 7 Displays Voltage Displays Current Adjusts Voltage Output voltage is available at these terminals; the + is at a higher voltage than the - Photo.
SMART LIGHTING Filters & The Behavior of L and C at Low and High Frequencies K. A. Connor Mobile Studio Project Center for Mobile Hands-On STEM SMART LIGHTING.
SMART LIGHTING Diodes K. A. Connor Mobile Studio Project Center for Mobile Hands-On STEM SMART LIGHTING Engineering Research Center ECSE Department Rensselaer.
SMART LIGHTING Using Excel with Data from Analog Discovery and LTspice K. A. Connor Mobile Studio Project Center for Mobile Hands-On STEM SMART LIGHTING.
Chapter 6: Voltage Regulator
Class Parts List Breadboard 1 Wire kit 1 Red LEDs 3 Green LEDs 3 Yellow LEDs 1 Photoresistor 1 xPiezo sensor 1 Button 3 Slide button, switch 1 Reed switch.
LOGIC GATES. INTRODUCTION TO LOGIC GATES Boolean functions may be practically implemented by using electronic gates. The following points are important.
Schematic Diagrams Schematic diagrams are used to graphically represent the components and interconnections of electrical circuits. Electronic schematics.
ELECTRICAL CIRCUITS Multimeter.
Diodes Part II Intro to ECSE Analysis K. A. Connor
+ I V V R (Ω) - R + V - V R (Ω) ref(erence) = 0V = ground DC th th
Dr. Cynthia Furse University of Utah
Soldering Leads to the DC Motor
Basic Concepts of DC Circuits
Figure 17.1 (a) As an engine is accelerated under a load, the engine vacuum drops. (b) The relationship between absolute pressure, vacuum, and gauge pressure.
Dr. Cynthia Furse University of Utah
DC Motor, Stepper Motor By Connor.
SWITCHES W. C. “Buster” Hounshell Spring 2002.
AA>1 AA=1 1 A-A -Vcc Vcc =AV = -AV =V V V V V V X X X p n in out in
PWM? K. A. Connor Mobile Studio Project
PWM? K. A. Connor Mobile Studio Project
Potentiometer or Potential divider
Intro to ECSE 1010 Intro to ECSE Analysis K. A. Connor
Digital Electronics, Software and Hardware
Software for Hardware Intro to ECSE Analysis K. A. Connor
Resistors Intro to ECSE Analysis K. A. Connor Mobile Studio Project
Effective Way to Test the Battery of your Car
Lecture 4: Operational Amplifiers
Lecture 4: Operational Amplifiers
Circuits and Circuit Elements
Op Amps Intro to ECSE Analysis K. A. Connor Mobile Studio Project
Intro to ECSE 1010 Intro to ECSE Analysis K. A. Connor Was ECSE 1961
Voltages & Currents Intro to ECSE Analysis K. A. Connor
How Boolean logic is implemented
Intro to Analog Discovery
Circuit in DC Instruments
Phase in Circuits Intro to ECSE Analysis K. A. Connor
Intro to Logic Gates Intro to ECSE Analysis K. A. Connor
FIGURE 21-1 The digital multimeter should be set to read DC volts, with the red lead connected to the positive (+) battery terminal and the black meter.
Plotting and Analysis with Matlab
Topic H: Electrical circuits
Phasor Circuit Analysis
Basic Concepts Circuit Elements.
Transformers Intro to ECSE Analysis K. A. Connor Mobile Studio Project
Exponential Function in Circuits, Part 1
Exponential Function in Circuits, Part 2
THE RESISTOR Forward characteristic Reverse characteristic Circuit.
Basic Laws of Electric Circuits
Experiment No. 1 Ohm’s Law
Modified by Mr. Wanninkhof
Current Electricity and Electric Circuits
Fields and Waves I Lecture 4 K. A. Connor Pulses on Transmission Lines
Electricity: Designing Circuits
Fields and Waves I Lecture 25 K. A. Connor Course Review
Basic Circuits.
FIGURE 15–21 When connecting a starter tester such as a Sun VAT 45 to the vehicle, make certain that the inductive probe is placed over all of the cables.
Rectifiers.
Course Title : Digital Electronics -1 Course No.: 6841 Course Teacher:Engr: Suvadra Chowdhury Chief Instructor Chittagong Mohila –Polytechnic Institute.
Presentation transcript:

DC Power Supplies Intro to ECSE Analysis K. A. Connor Mobile Studio Project Center for Mobile Hands-On STEM SMART LIGHTING Engineering Research Center ECSE Department Rensselaer Polytechnic Institute Intro to ECSE Analysis

Outline Batteries Fixed DC Supplies Variable DC Supplies Current Limited Voltage Supplies What Else?

+ + + Batteries 9V Battery & Connector Red is plus (+) and Black is minus (-) Can be either a +9V (Black grounded) or -9V DC (Red grounded) supply + + + 20 November 201820 November 2018

Batteries Many Types – All with ± Symbols for Polarity 20 November 201820 November 2018

+ Generic DC Supply Black Box Circuit Symbol Black Box Output Note: Can always be connected in either direction to be positive or negative source. 20 November 201820 November 2018

Fixed Power Supplies 20 November 201820 November 2018

Bench Top Supplies Single or Multiple Output Fixed or Variable Output Current Limiting Voltage Supply Nearly All Can be Connected in Either Direction 20 November 201820 November 2018

HP E3631A Again, the 3 power supplies can be connected in either direction. 3 1 2 Case Ground 20 November 201820 November 2018