LO/IF Switches Doug Scott

Slides:



Advertisements
Similar presentations
Hardware Integration of the Prototype Wes Grammer NRAO September 24-26, 2012EOVSA Prototype Review1.
Advertisements

Ph: Fx: ohm Components.
Preliminary Design Review EVLA 1 st and 2 nd Local Oscillators.
Quiz: Lead/Lag Network Determine the transfer function V O (s)/V D (s) for the lead-lag network shown: VDVD VOVO 200  5000  2000  100 .01 uf VCO PD.
Diode Circuits By Professor Syed Idris Syed Hassan Sch of Elect. & Electron Eng Engineering Campus USM Nibong Tebal SPS Penang.
Types Of Mixers In Radar Receivers
Sensor For Cellular Activity Supervised by : Yossi Hipsh Preformed by: Assaf Haim Ohad Fremder.
Fundamentals of Power Electronics 1 Chapter 19: Resonant Conversion Outline of discussion DIRECT MODELING APPROACH 1.How small-signal variations in the.
Polar Loop Transmitter T. Sowlati, D. Rozenblit, R. Pullela, M. Damgaard, E. McCarthy, D. Koh, D. Ripley, F. Balteanu, I. Gheorghe.
Bandpass Sigma-Delta Modulator Michael Vincent Brian McKinney ECEN5007.
Sensor for cellular activity Supervised by : Yossi Hipsh Preformed by : Assaf Haim Ohad Fremder.
Mid-Semester Design Review High Frequency Radio with BPSK Modulation.
94 GHz Switching Circulator Tracy Shain Ryan Nichols Daniel Komisar Andrew Gadbois Advisor: Prof. Paul Siqueira.
STARLight PDR 3 Oct ‘01 L. van Nieuwstadt Receiver - Page 1 STARLight Objective To design, build and test RF front end receiver as small as possible, meeting.
Instrumentation Development for the Measurement and Characterisation of Indoor and Urban Canyon Ambient Noise Floor in the Galileo Frequency Bands M. Junered.
EEE 194RF_ L121 ELEC 412 RF & Microwave Engineering Fall 2004 Lecture 12.
To produce the highest quality, cost effective microwave products to meet our customers’ needs with either Dorado standard catalog devices or custom products.
2.4-GHZ RF TRANSCEIVER FOR IEEE B WIRELESS LAN UF# UF#
2.4GHz Single Balanced Mixer Andrew Bacon Jacqueline Griffin John Stone.
HIAPER Cloud Radar Transceiver Exciter Receiver Oscillators High-Powered Amplifier Calibration Exciter Receiver Oscillators High-Powered Amplifier Calibration.
1 Mixers  Mixers plays an important role in both the transmitter and the receiver  Mixers are used for down frequency conversion in the receiver  Mixers.
Reconfigurable Patch Antenna With Matching Network Presented by: Mike Bly, Josh Rohman Advisor: Dr. Prasad N. Shastry.
Microwave Integrated Circuits (MIC)
Microwave Engineering/Active Microwave Devices 9-13 September Semiconductor Microwave Devices Major Applications Substrate Material Frequency Limitation.
Introduction to Vector Network Analyzer (VNA)
Electronics Involves the use of devices and circuits to control the flow of electric current to achieve some purpose. These circuits contain: Resistors,
ADS Design Guide.
FULLY DIFFERENTIAL OPAMP Eduardo Picatoste Calorimeter Electronics Upgrade Meeting.
Paul HardenEVLA LO-IF CDR May 17, IF Subsystem Specs & Measured Test Data.
KFPA LO Modifications (from single pixel results) Critical Design Review January 30, 2009 G. Anderson.
February 17-18, 2010 R&D ERL Alex Zaltsman R&D ERL High Power RF Systems Alex Zaltsman February 17-18, 2010 High Power RF Systems.
Paul LilieFeed & Front End PDR-Solar Feb Feed & Front End PDR Solar Observing.
Codan 5700 Series C-Band Transceiver Technical Overview.
Bob Hayward Receiver Engineer Feed & Front End PDR Feb Feed & Front End PDR Q, Ka, K, Ku & X-Band Receivers Backup Slides.
1 Microwave Semiconductor Devices Major Applications Substrate Material Frequency Limitation Device Transmitters AmplifiersSi, GaAs, InP< 300 GHzIMPATT.
Amplifiers Amplifier Parameters Gain = Po/Pi in dB = 10 log (Po/Pi)
Leon Abeyta LO-IF Engineer EVLA LO-IF PDR 22 January EVLA LO/IF Central and Antenna Reference Generation.
Bandpass Filter Terminology f r Rejection A r Upper and Lower Rejection Frequencies Shape A r : SF = B r (A r )/B p.
Paul Harden VLA Veteran EVLA LO-IF PDR 22 January EVLA IF/LO EVLA “LOW BAND” CONVERTERS For 4/P/L/S/C and Ku Bands.
Travis Newton LO-IF Engineer EVLA LO/IF PDR January IF Downconverter Travis Newton LO/IF Engineer.
SCROD CAL buffer test results The buffer was fed with sinewave in range 150 – 750 MHz, and first the input and then the output were measured on scope for.
10 June 2002 Paul Lilie Advisory Committee1 EVLA Front Ends.
Chuck KutzEVLA Front-End CDR – LO/IF System April 24, EVLA Front-End CDR EVLA Front-Ends and the EVLA LO/IF System.
April 12 | Comparison of Sophisticated Synthesizer Concepts and Modern Step Attenuator Implementations | 2 Comparison of Sophisticated Synthesizer Concepts.

EE3110 Active Filter (Part 1)
RF components Design for the Internet Over TV Band Adaptor
Communication 40 GHz Anurag Nigam.
Linear Technology Corporation
EE3110 Active Filter (Part 1)
ALPS SPS BPM Read-out Electronics RF Front-end – revised
EVLA Advisory Committee Meeting System Status
EVLA NSF Mid-Project Review System / Antenna Status
Electronics: Demod + 4Q FE
Sales Guide ANT ANT C Date 2011/08/31 DCN PP.
Water Vapor Radiometer
> 50 dB ≤ 500 MHz Non-intercepting beam position measurement
Terry Cotter LO/IF Group Leader
LO/IF System Requirements
البيئة السياسية للإدارة الدولية
EVLA System PDR System Overview
EVLA Receivers PDR Transition Planning Author Daniel (Mert) Mertely
Terry Cotter LO/IF Group Leader
LX7202 Upstream USB Port Termination, EMI Filter and ESD Protection
X-BAND & S-BAND FOR MARINE RADAR
Sruthi Dinesh1, Dr.Aanandan C.K.1
EVLA Advisory Panel Mtg. System Overview
Pole Position Student Points Time
A B C D.
Presentation transcript:

LO/IF Switches Doug Scott LO/IF System PDR LO/IF Switches Doug Scott 11/21/2018 Doug Scott LO/IF System PDR 22-23 January 02

LO/IF System PDR Type of Switches (# per antenna) IF High Band Switches (4) IF Low Band Switches (4) IF Transfer Switches (2) LO Switches (2) 11/21/2018 Doug Scott LO/IF System PDR 22-23 January 02

LO/IF System PDR IF High Band Switch Specifications Frequency Range: 8 to 12 GHz VSWR: 1.4 to 1 max Insertion Loss: 0.4 db max Isolation: 60 db min # of poles: 1 per switch # of throws: 9 min per switch 11/21/2018 Doug Scott LO/IF System PDR 22-23 January 02

LO/IF System PDR IF Low Band Switch Specifications Frequency Range: 1 to 8 GHz VSWR: 1.3 to 1 max Insertion Loss: 0.4 db max Isolation: 70 db min # of poles: 1 per switch # of throws: 6 min per switch 11/21/2018 Doug Scott LO/IF System PDR 22-23 January 02

LO/IF System PDR IF Transfer Switch Specifications Frequency Range: DC to 12 GHz VSWR: 1.4 to 1 max Insertion Loss: 0.4 db max Isolation: 60 db min # of poles: 2 per switch # of throws: 2 min per switch 11/21/2018 Doug Scott LO/IF System PDR 22-23 January 02

LO/IF System PDR LO Switch Specifications Frequency Range: 12 to 20 GHz VSWR: 1.8 to 1 max Insertion Loss: 0.8 db max Isolation: 55 db min # of poles: 1 per switch # of throws: 6 min per switch 11/21/2018 Doug Scott LO/IF System PDR 22-23 January 02

LO/IF System PDR Mechanical Switches Electronic Pin Diode Switches Better Insertion Loss Better VSWR & BW Better Phase & Amplitude Performance Electronic Pin Diode Switches Lower Cost High Reliability 11/21/2018 Doug Scott LO/IF System PDR 22-23 January 02

Switch Costs IF High Band IF Low Band IF Transfer $1775 (1-2) $965 (1-2) $435 (1-2) $1511(3-5) $821 (3-5) $370 (3-5) $1384 (6-10) $743 (6-10) $328 (6-10) $1162 (51-100) $612 (51-100) $261 (51-100) LO Switches to use recycled FE switches. 11/21/2018 Doug Scott LO/IF System PDR 22-23 January 02

LO/IF System PDR LO/IF Switch Physical Locations IF High Band, Outside B Rack IF Low Band, Outside B Rack IF Transfer, Inside B Rack LO, Outside B Rack Additional Control Switch Module 11/21/2018 Doug Scott LO/IF System PDR 22-23 January 02

LO/IF System PDR Current Status Obtaining more switch price quotes Purchase Requisitions signed by 2/02 Switches available in 6-10 wks 11/21/2018 Doug Scott LO/IF System PDR 22-23 January 02