SCHEMATIC MANOEUVRE ILLUSTRATIONS

Slides:



Advertisements
Similar presentations
ClAss F3P Indoor Aerobatic Power Model aIRCRafts Schedule F3P - AP.
Advertisements

Baseline 1 vs Zone 1 = Point Guard 2 = Shooting Guard
FLYING BASIC COMPETITION AEROBATICS David Pilkington July 2013.
Class F3P Indoor Aerobatic Power Model aIRCRafts
SCHEMATIC MANOEUVRE ILLUSTRATIONS SCHEDULE F-11 SCHEMATIC MANOEUVRE ILLUSTRATIONS SCHEDULE F-11.
Class F3P Indoor Aerobatic Power Model aircrafts Schedule F3P – AP-15.
FAI / F3A Radio Control Aerobatics Judges Briefing NSW Pattern Seminar 2009.
CIVA / FAI Seminar CIVA / FAI Seminar CIVA / FAI Seminar CIVA / FAI Seminar.
PRINCIPLES of Judging F3A-Indoor Manoeuvres PRINCIPLES of Judging F3A-Indoor Manoeuvres.
SCHEMATIC MANOEUVRE ILLUSTRATIONS
1 AMA Precision Aerobatics JUDGES TRAINING PRESENTATION Effective 2011 AMA Precision Aerobatics JUDGES TRAINING PRESENTATION Effective 2011.
Version 1.0. Technical Information Take Off Straight Flight Series Three Inside Loops Reverse Outside Loop One Inside Loop Double Stall Turn One Horizontal.
● Centre of Gravity Track ● Zero Lift Axis ● When to use each one ? ● The “Box” ● Steep / Shallow, Neg & Pos ● Basics Rules of Judging ● Turns ● Slow Rolls.
SCHEMATIC MANOEUVRE ILLUSTRATIONS GBR/CAA Masters SCHEDULE SCHEMATIC MANOEUVRE ILLUSTRATIONS GBR/CAA Masters SCHEDULE.
SCHEMATIC MANEUVER DIAGRAMS AMA ADVANCED 403 Effective 2011 SCHEMATIC MANEUVER DIAGRAMS AMA ADVANCED 403 Effective 2011.
Club Night Introduction To Aerobatics. PRECISION.
Some pilots think judges do a poor job. True or false?
FAI/F3A Radio Control Aerobatics JUDGES TRAINING SESSION England, 14 th March 2004 FAI/F3A Radio Control Aerobatics JUDGES TRAINING SESSION England, 14.
SCHEMATIC MANOEUVRE ILLUSTRATIONS SCHEDULE P-17 SCHEMATIC MANOEUVRE ILLUSTRATIONS SCHEDULE P-17.
Fly Baby Monoplane Center Wing Ribs & Fin and Stab Ribs Printing Notes: Squares are on 1” centers Check with ruler prior to use Print to “ARCHITECTURE.
FAI/F3A Radio Control Aerobatics JUDGES TRAINING PRESENTATION
LIFT: Back Spin LIFT: Top Spin Bottom of ball moving toward the direction of the ball’s flight lower flow on bottom higher flow on top F LIFT UPWARD Top.
Freestyle tips IAC Chapter 49 January 3, in the beginning... Wing wag like you mean it Start with a bang – something at center box that looks good.
AMA Precision Aerobatics JUDGES TRAINING PRESENTATION 2005 AMA Precision Aerobatics JUDGES TRAINING PRESENTATION 2005.
ClAss F3P Indoor Aerobatic Power Model aIRCRafts Schedule F3P – AP-13.
Scale Aerobatic Judging Seminar 2015 I-1 Welcome to the Judging Seminar JUDGE EACH MANEUVER AS IF IT’S THE ONLY ONE BEING FLOWN.
Mathematics 2 Ms. Meek Symmetry. A figure is said to be symmetric if you can draw a line down the middle, and split the figure into two pieces that are.
AMA Precision Aerobatics JUDGES TRAINING PRESENTATION 2005 AMA Precision Aerobatics JUDGES TRAINING PRESENTATION 2005.
IMAC Judging Training Sportsman Known 2011 Jeff Mortimer.
IMAC Judging Seminar J-101/30/2010Scale Aerobatics Judging Seminar Aresti System Families 1 – –  Family 1 – Lines & Angles  Family 2 – Turns.
SCHEMATIC MANOEUVRE ILLUSTRATIONS SCHEDULE F-17 SCHEMATIC MANOEUVRE ILLUSTRATIONS SCHEDULE F-17.
1 MAAC Precision Aerobatics JUDGES TRAINING PRESENTATION 2016 MAAC Precision Aerobatics JUDGES TRAINING PRESENTATION 2016.
IMAC Judging Seminar Judging Scale Aerobatics Judging SeminarJ-11/30/2010 JUDGE EACH MANEUVER AS IF IT’S THE ONLY ONE BEING FLOWN.
Aerobatics and Formation Flying
A Quick Zoom through the Rules
Theory of Flight 6.08 Loads and Load Factors References:
Basic 2017 IMAC Judging Training
JUDGE EACH MANEUVER AS IF IT’S THE ONLY ONE BEING FLOWN.
Aerobatic Judging Seminar
Theory of Flight 6.09 Stability References: FTGU pg 31, minutes.
6.08 Aircraft Stability References: FTGU pages 31, 32
6.06 Loads and Load Factor References: FTGU pages 17-18, 34-35
A Quick Zoom through the Rules
Supplementary Explanations
Manoeuvre Execution Guide
2018 Basic Known Guide IMAC Judge’s Training
SCHEMATIC MANOEUVRE ILLUSTRATIONS
SCHEMATIC MANOEUVRE ILLUSTRATIONS
F3A Judging seminar Bob Romijn.
SCHEMATIC MANOEUVRE ILLUSTRATIONS
SCHEMATIC MANOEUVRE ILLUSTRATIONS
Class F3P Indoor Aerobatic Power Model Aircrafts
Class F3P Indoor Aerobatic Power Model Aircrafts
SCHEMATIC MANOEUVRE ILLUSTRATIONS
SCHEMATIC MANOEUVRE ILLUSTRATIONS
FAI/F3A Radio Control Aerobatics JUDGES TRAINING SESSION
Aerobatic Judging Seminar
Class F3P Indoor Aerobatic Power Model Aircrafts
Class F3P Indoor Aerobatic Power Model Aircrafts
2019 Basic Known Guide IMAC Judge’s Training
A Quick Zoom through the Rules
Recall: A horizontal projectile
Aerobatic Judging Seminar
Force A Force is a push or pull..
A Quick Zoom through the Rules
Aerobatic Judging Seminar
QUESTION NUMBER 1.
SCHEMATIC MANOEUVRE ILLUSTRATIONS
Presentation transcript:

SCHEMATIC MANOEUVRE ILLUSTRATIONS Flying and Judging F3A SCHEMATIC MANOEUVRE ILLUSTRATIONS SCHEDULE N-19

( not judged, not scored ) Take-off procedure ( not judged, not scored ) wind 1200 Safety line

N-19.01 Vertical 8 All radii are equal. Entry and exit must be at the same altitude. From upright, pull through a ½ loop, push through a loop, pull through a ½ loop, exit upright. N-19.01.01

N-19.02 Stall Turn with ½ rolls All radii are equal. ½ rolls on middle of the lines ½ roll ½ roll From upright, pull through a ¼ loop into a vertical upline, perform a half roll, perform a stall turn into a vertical downline, perform a half roll, pull through a ¼ loop, exit upright. N-19.02.01

N-19.03 Square Loop on Corner All radii are equal. 45° From upright, pull through a 1/8 loop into a 45° upline, pull through a ¼ loop into a 45° upline, pull through a ¼ loop into a 45°downline, pull through a ¼ loop into a 45° downline, pull through a 1/8 loop, exit upright. N-19.03.01

N-19.04 Figure 9 All radii are equal. ½ roll ½ roll From upright, pull through a ¼ loop into a vertical upline, perform two consecutive ½ rolls, push through a ¾ loop, exit inverted. N-19.04.01

N-19.05 Knife-Edge flight with ¼ roll, ¼ roll From inverted, perform a ¼ roll, perform a knife-edge flight, perform a ¼ roll, exit upright. N-19.05.01

N-19.06 Split S with ½ roll ½ roll No line between roll and loop From upright, perform a ½ roll, pull through a ½ loop, exit upright. N-19.06.01

N-19.07 Golf Ball All radii are equal. 45° From upright pull through a 1/8 loop into a 45° upline, pull through a ¾ loop into a 45° downline, pull through a 1/8 loop, exit upright. N-19.07.01

N-19.08 Shark Fin with ½ roll ½ roll on middle of the line. All radii are equal. ½ roll 45° From upright, pull through a ¼ loop into a vertical upline, pull through a 3/8 loop into a 45° downline, perform a ½ roll, pull through a 1/8 loop, exit upright. N-19.08.01

N-19.09 Reverse Split S, ½ roll, Reverse Immelman with full roll No line between roll and loop All radii are equal. ½ roll ½ roll on middle of the line. roll ½ roll From upright perform a ½ roll, push through a ½ loop, perform a half roll in the centre, pull through a ½ loop, perform a roll, exit upright. N-19.09.01

N-19.10 Pull-Push-Pull Humpty-Bump with ½ roll (Option: with ¼ rolls) All radii are equal. ½ roll ½ roll on middle of the line. From upright, pull through a ¼ loop into a vertical upline, push through a ½ loop into a vertical downline, perform a ½ roll, pull through a ¼ loop, exit upright. Option: From upright, pull through a ¼ loop into a vertical upline, perform a ¼ roll, push through a ½ loop into a vertical downline, perform a ¼ roll, pull through a ¼ loop, exit upright N-19.10.01

N-19.10 Pull-Push-Pull Humpty-Bump with ½ roll (Option: with ¼ rolls) All radii are equal. 1/4 roll 1/4 roll 1/4 roll on middle of the line. N-19.10.02

N-19.11 Three consecutive ½ rolls From upright, perform three consecutive ½ rolls, exit inverted N-19.11.01

N-19.12 Top Hat with spin All radii are equal. From inverted, push through a ¼ loop into a vertical upline, push through a ¼ loop into a horizontal line, perform a spin with 2 turns into a vertical downline, pull through a ¼ loop, exit upright. N-19.12.01

N-19.13 Figure Z 45° All radii are equal. From upright, pull through a 3/8 loop into a 45° upline, push through a 3/8 loop, exit upright. N-19.13.01

N-19.14 Comet with ½ roll ½ roll on middle of the line. ½ roll 45° ½ roll on middle of the line. ½ roll All radii are equal. From upright, push through a 1/8 loop into a 45° downline, pull through a ¾ loop into a 45° downline, perform a ½ roll, pull through a 1/8 loop, exit upright. N-19.14.01

N-19.15 Roll Combination ½ roll ½ roll From upright perform two consecutive ½ rolls in opposite direction, exit upright. N-19.15.01

N-19.16 Half Square Loop on Corner All radii are equal. 45° From upright, pull through a 1/8 loop into a 45° upline, pull through a ¼ loop into a 45° upline, pull through a1/8 loop, exit inverted. N-19.16.01

N-19.17 Outside loop From inverted perform a ½ roll, push through an outside loop, perform a ½ roll, exit inverted. N-19.17.02

( not judged, not scored ) Landing procedure ( not judged, not scored ) The direction of the landing may be different to the take off. wind 1200 Safety line

Forget WHAT is flying (2-stroke, 4-stroke, electric) Forget WHO is flying (friend, rival, countryman, flier from other nation) Forget WHAT is flying (2-stroke, 4-stroke, electric) LOOK ONLY AT LINES DESCRIBED IN THE SKY! (and the precision, smoothness, positioning, and size) Thank you! © Peter Uhlig, October 2016