PARALLEL OPERATION OF SINGLE PHASE TRANSFORMER

Slides:

Advertisements

Similar presentations

An Electronic Device, and also a Action Hero…

Advertisements

TYPES & CONSTRUCTION OF TRANSFORMERS POWER IN AN IDEAL TRANSFORMER

Introduction to Switchgear

Chapter 4 Transformer Connections

King Abdul Aziz University College of Engineering Electrical and Computer Department EE 454 SWITCHG.& PROT. OF PWR. SYS. Lectures Book Dr. ABDULRAHMAN.

Power System Analysis/ Power System 1 EEE 4113/ EEE 3131

Physics for Scientists and Engineers II, Summer Semester Lecture 19: July 8 th 2009 Physics for Scientists and Engineers II.

TRANSFORMERS. TRANSFORMER PARAMETERS Turns Ratio (n) It is defined as the ratio of the number of turns in the secondary winding (N sec ) to the number.

Problem #2-8 A 480 – 120 V, 60 Hz transformer has its high voltage winding connected to a 460 V system, and its low voltage winding connected to a 24/32.8°Ω.

Universal College of Engineering & Technology

Transformers and Coupled Circuits

NETWORK OPERATING DIVISION Operating Effectiveness Phase Shifters What is a Phase Shifter These transformers create a difference in phase angle between.

Mehran University College Of Engineering & Technology, Khairpur Mir’s ENGR. AHSANULLAH MEMON LECTURER DEPARTMENT OF ELECTRICAL ENGINEERING MUCET KHAIRPUR.

Mehran University College Of Engineering & Technology, Khairpur Mir’s

Electrical Machine-I EE 2107 Dr. Md. Sherajul Islam

EQUIVALENT CIRCUIT AND POWER EQUATION OF SYNCHRONOUS MOTOR

Unit 28 Single-Phase Transformers. Objectives: Discuss the different types of transformers. List transformer symbols and formulas. Discuss polarity markings.

Transformers  A transformer is used to change alternating p.d.s. from a lower to a higher voltage or vice versa. A simple transformer consists of two.

Mehran University Of Engineering & Technology, SZAB Khairpur Mirs Campus ENGR. AHSANULLAH MEMON LECTURER DEPARTMENT OF ELECTRICAL ENGINEERING MUCET KHAIRPUR.

Universal college of engineering and technology  C.P.D. SUBJECT:- DC Machine & Transformer ELECTRICAL ENGG. DEPARTMENT.

Physics 12 Mr. Jean May 4 th, The plan: Video clip of the day AC/DC power generation.

Institute of Power Electronics 1 Comparison of Series Hybrid Active Power Filters in Medium Power Application Comparison of Series Hybrid Active.

Announcements For lectures 8 to 10 please be reading Chapter 3

POWER CIRCUIT & ELECTROMAGNETICS

ENL1819T Progress Report Confidence in Our Success.

Modeling of Power Transformers A Static Device. Transformers The transformer enables us to utilize different voltage levels across the system for the.

Norton’s Theorem and Maximum Power Transfer Theorem Lecture No.7 By – Engr Sajid Hussain Qazi Lecturer Mehran University C.E.T Khairpur.

CURRENT AND RESISTANCE LECTURE 8 DR. LOBNA MOHAMED ABOU EL-MAGD.

Introduction to switchgears

Transformers They’re more than meets the eye. A transformer is made of 2 coils, near each other but not touching. Many times one is inside the other,

A Training Presentation On 132 KV GSS JAIPUR Submitted in partial fulfillment For the award of the degree of BACHELOR OF TECHNOLOGY Submitted To:- Submitted.

FUNDAMENTALS OF ELECTRICAL ENGINEERING [ ENT 163 ] LECTURE #10 ELECTRICAL MACHINES HASIMAH ALI Programme of Mechatronics, School of Mechatronics Engineering,

Mehran University Of Engineering & Technology, SZAB Khairpur Mirs Campus ENGR. AHSANULLAH MEMON LECTURER DEPARTMENT OF ELECTRICAL ENGINEERING MUCET KHAIRPUR.

Lecture 09Electro Mechanical System1 Chapter 11 Special Transformers.

Single-Phase Transformers Prepared By: Chadarana Jigna( ) Gandhi Disha ( ) Kanani Mital ( ) B.E SEM : 3 Subject:- Electrical.

Transformer A transformer is a static piece of equipment used either for raising or lowering the voltage of an a.c. supply with a corresponding decrease.

SARDAR VALLABHBHAI PATEL INSTITUTE OF TECHNOLOGY PREPARED BY: 1)BALDIWALA ALIABBAS ( ) 2)PARTH GUPTA ( ) 3)ANIL KHATIK ( )

Three-Phase Transformer

Mehran University Of Engineering & Technology, SZAB Khairpur Mirs Campus ENGR. AHSANULLAH MEMON LECTURER DEPARTMENT OF ELECTRICAL ENGINEERING MUCET KHAIRPUR.

Lesson 12: Parallel Transformers and Autotransformers ET 332b Ac Motors, Generators and Power Systems 1 Lesson 12_et332b.pptx.

HNC/D Engineering Science

CHAPTER 4 SINGLE-PHASE TRANSFORMER

THREE-PHASE TRANSFORMER

ECE 476 POWER SYSTEM ANALYSIS

EE 442 POWER ELECTRONICS I Introduction Dr. Said A. Deraz

3-Phase Transformer Construction, Principal, Working, Operation Advantages Over 1-Phase Transformer Introduction Advatages Construction Principal Working.

SIGMA INSTITUTE OF ENGINEERING

ELECTRONICS & COMMUNICATION 3-SEM SHANTILAL DHOLIYA ( )

K. J. I. T institute of engineering 3-PHASE TRANSFORMER. PREPARD BY:-

SIGMA INSTITUTE OF ENGINEERING DEPARTMENT OF ELECTRICAL ENGINEERING

AC Voltage Controllers AC to ac Converters

Energy Conversion and Transport George G. Karady & Keith Holbert

AUTOTRANSFORMERS.

3-Phase Transformer Construction, Principal, Working, Operation Advantages Over 1-Phase Transformer Introduction Advatages Construction Principal Working.

Energy Conversion and Transport George G. Karady & Keith Holbert

Lab For the following simple switch mode power supply:

Transformer Impedance

Islamic University of Gaza

ELL100: INTRODUCTION TO ELECTRICAL ENGG.

Voltage Divider Circuit

EET 323 – Electrical System Design Lecture 14: Transformers

Wye/Wye 277/480 4 wire Transformer Bank

Chapter 33 Transformer: Three Phase. Chapter 33 Transformer: Three Phase.

Exercise 9 Power systems.

Presentation transcript:

PARALLEL OPERATION OF SINGLE PHASE TRANSFORMER Mehran University Of Engineering & Technology, SZAB Khairpur Mirs Campus PARALLEL OPERATION OF SINGLE PHASE TRANSFORMER ENGR. AHSANULLAH MEMON LECTURER DEPARTMENT OF ELECTRICAL ENGINEERING MUCET KHAIRPUR MIRS

INTRODUCTION The transformers are connected in parallel when load on one of the transformers is more than its capacity. Two transformers are said to be connected in parallel if the primary windings are connected to supply busbars and secondary windings are connected to load busbars. The reliability is increased with parallel operation than to have single larger unit. The cost associated with maintaining the spares is less when two transformers are connected in parallel.

Conditions for Parallel Operation

CONDITION (I)

CONDITION (II)

CONDITION (III)

CONDITION(IV) If the reactance/resistance ratios of the two transformers are not equal, the power factor of the load supplied by the transformers will not be equal. In other words, one transformer will be operating with a higher and the other with a lower power factor than that of the load.