A Fluoroscopy-Free Technique for Percutaneous Screw Positioning During Arthroscopic Treatment of Depression Tibial Plateau Fractures  Mathieu Thaunat, M.D., Nuno Camelo Barbosa, M.D., Sanesh Tuteja, M.D., Nicolas Jan, M.D., Jean Marie Fayard, M.D., Bertrand Sonnery-Cottet, M.D.  Arthroscopy Techniques  Volume 5, Issue 3, Pages e507-e511 (June 2016) DOI: 10.1016/j.eats.2016.02.012 Copyright © 2016 Arthroscopy Association of North America Terms and Conditions

Fig 1 Our simple trick allows the surgeon to avoid the use of fluoroscopy intraoperatively to position the cannulated screw for fixation of a depression lateral tibial plateau fracture. After reduction of the fragment, an outside-in anterior cruciate ligament femoral guide, set at maximum amplitude with a 115° to 120° aiming device, is introduced through the tibial cortical metaphyseal window and positioned under endoscopic control just underneath the elevated fragment. This ensures optimal placement of the screw in the middle of the bony tunnel just underneath the elevated fragment to obtain an optimal rafter effect. Arthroscopy Techniques 2016 5, e507-e511DOI: (10.1016/j.eats.2016.02.012) Copyright © 2016 Arthroscopy Association of North America Terms and Conditions

Fig 2 Surgical technique. (A, B) The patient is placed in the supine position on a standard table. A tibia-specific jig (Tibial Plateau Fracture Management System) is positioned arthroscopically, through the anteromedial portal. When satisfactory orientation is achieved, a guide pin is drilled toward the deepest point of the fracture. (C, D) A cannulated tamp (Arthrex) is introduced through the tibial cortical window, and under arthroscopic guidance, the depressed fragment is carefully elevated until satisfactory reduction is achieved. (E, F) An outside-in anterior cruciate ligament femoral guide (Arthrex), set at maximum amplitude with a 115° to 120° aiming device, is introduced through the tibial cortical metaphyseal window and positioned under endoscopic control just underneath the elevated fragment. (G, H) A 7-mm cannulated cancellous screw with an 16- or 32-mm thread length is then introduced over the guide pin, after drilling and tapping (Magna-FX cannulated screw system), under endoscopic control. (Ant, anterior; C, condyle; Lat, lateral; LM, lateral meniscus; Med, medial; Post, posterior; T, tibia.) Arthroscopy Techniques 2016 5, e507-e511DOI: (10.1016/j.eats.2016.02.012) Copyright © 2016 Arthroscopy Association of North America Terms and Conditions

Fig 3 Preoperative and postoperative radiographs of 2 cases of Schatzker type 3 depressed lateral tibial plateau fracture. (A, C) Tibial plateau fractures (arrows) occasionally are difficult to appreciate with standard radiographs. The preferred examination consists of radiographs in multiple obliquities of the knee. (B, D) Postoperative anteroposterior views after 7-mm cannulated screws (Magna-FX cannulated screw system) were used as a rafter to support the articular surface. Arthroscopy Techniques 2016 5, e507-e511DOI: (10.1016/j.eats.2016.02.012) Copyright © 2016 Arthroscopy Association of North America Terms and Conditions