And how to configure the each external EEPROM and internal registers?

Slides:

Advertisements

Similar presentations

EDC Client Installer An installation program which installs the EDC Client software on a workstation, for a client of your record center, with the data.

Advertisements

Introduction to Micro-controllers Anurag Dwivedi.

 Gain Adjust G1 Gain Adjust G2 Gain Adjust G3 Gain Adjust G4 Phase Adjust P1 Phase Adjust P2 Phase Adjust P3 Phase Adjust P4 t1 t2 t3 t4 Beamformed Sum.

CHAPTER 4 I/O PORT PROGRAMMING. I/O Port Pins The four 8-bit I/O ports P0, P1, P2 and P3 each uses 8 pins All the ports upon RESET are configured as input,

Keystone PCIe Usage Eric Ding.

University of Pennsylvania 1 The BASIC Stamp 2. University of Pennsylvania 2 The BASIC Stamp 2 Serial Signal Conditioning Conditions voltage signals between.

Given Connections Solution

ATtiny2313 Fuse Programming CS-423 Dick Steflik. Whats a Fuse Fuses are used to hold important configuration information for the MPU Not really a fuse,

PROBE CARD INTEGRATION IN pALPIDEfs TEST SYSTEM ALICE | ITS-MFT Mini-Week | | Markus Keil.

Technion - Israel institute of technology department of Electrical Engineering High speed digital systems laboratory Super Computer System Midterm presentation.

Parallel Ports, Power Supply and the Clock Oscillator Material to be covered  Parallel I/O ports  Interfacing external switches and LEDs  Clock Oscillator.

 Configuring a vSwitch Cloud Computing (ISM) [NETW1009]

Microcontroller based system design Asst. Prof. Dr. Alper ŞİŞMAN.

PCIe Mezzanine Carrier Pablo Alvarez BE/CO. Functional Specifications External Interfaces User (application) FPGA System FPGA Memory blocks Mezzanine.

Confidential 1 SpecificationsFeatures ProcessorFreescale MPC8640 Single 1 GHz DDRAMDual channel DDR2 with ECC, 512 MB (expandable up to 2GB) Flash.

I uninstalled the driver for “TSW1400”. Then when I connect the “TSW1400” to my computer, it is detected but the computer can not install the driver for.

Keystone Family PCIE Eric Ding. TI Information – Selective Disclosure Agenda PCIE Overview Address Translation Configuration PCIE boot demo.

Chapter 2 Introducing the PIC Mid-Range Family and the 16F84A The aims of this chapter are to introduce: The PIC mid-range family, in overview The overall.

BR 1/991 Issues in FPGA Technologies Complexity of Logic Element –How many inputs/outputs for the logic element? –Does the basic logic element contain.

Computer System Internal components - The processor - Main memory - I / O controllers - Buses External components (peripherals). These include: - keyboard.

ECE 424 Embedded Systems Design Lecture 5: Platform Architecture Ning Weng.

Download F4232H UART AP Run the program FT4232H_UART.exe in the FT4232H_UART\bin\Release.

7/23 Coldfire 5211 Signals and IO Multiplexing Computer Science & Engineering Department Arizona State University Tempe, AZ Dr. Yann-Hang Lee

Msi interrupt reception as EP. Msi debug Based on sprugs6a.pdf, Keystone architecture Perpheral Component Interconnect Express (PCIe) wrote 8 into MSI_IRQ.

Objectives Blue Color VLAN’s Should reach Message Server from all locations Red Color VLAN’s Should not Reach Message Server In Each L2 Switch Blue Color.

CIT 673 Created by Suriyong1 Micro controller hardware architechture.

Case study: Data Provider setup Sergey Sukhonosov National Oceanographic Data Centre, Russia Expert training on the Ocean Data Portal technology, Buenos.

ENEE 440 Chapter PPI 8255 Register Select -CS A1 A0 REGISTER R/W PORT A R/W PORT B R/W PORT C R/W CR W 1 X X8255 NOT.

Features of the PIC18 microcontroller - 8-bit CPU - 2 MB program memory space (internal 32KB to 128KB) bytes to 1KB of data EEPROM - Up to 4096 bytes.

LAN Sephiroth Kwon GRMA OUTLINE Diagram Voltage Clock Head Signal Description Repair Flow Chart.

Figure 10.1 Cross-NOR S-R flip-flop: (a) Set condition; (b) Reset condition.

© 2008, Renesas Technology America, Inc., All Rights Reserved 1 Course Introduction Purpose  This course provides an introduction to the peripheral functions.

1 Pertemuan 2 Routers. Discussion Topics Introduction to WANs Router physical characteristics Router external connections Management port connections.

What is a Bus? A Bus is a communication system that transfers data between components inside a computer or between computers. Collection of wires Data.

Components of a typical full-featured microcontroller.

PROCStar III Performance Charactarization Instructor : Ina Rivkin Performed by: Idan Steinberg Evgeni Riaboy Semestrial Project Winter 2010.

NAM S.B MDLAB. Electronic Engineering, Kangwon National University 1.

ECE 447: Lecture 3 Microcontroller Programming in C.

System on a Programmable Chip (System on a Reprogrammable Chip)

Discovery 2 Internetworking Module 4 JEOPARDY K. Martin.

FIGURE 4.1 SOC System Overview.. FIGURE 4.2 Memory Map Representation for an Intel Platform.

Installation Guide Summary Installation Guide Summary Richard Sah CTO MX100D (Direct Connect) June 14, 2016 Company confidential.

Lecture 15: IO Virtualization

Issues in FPGA Technologies

CC2430 module Jinho Son Real-Time System Lab.

DHT 11 Sensor Connect the sensor with Arduino board like picture below. Download DHT11 Sensor library from

PCIe control interface for user logic.

Components of Computer

Erno DAVID, Tivadar KISS Wigner Research Center for Physics (HU)

Accelerator Network Safety at PSI

Intel Desktop Board D945GTP

SCSI over PCI Express (SOP) use cases

Motherboard and its component What is Motherboard? Location Function.

AVR Hardware Connections and Flash Loading

: XIO3130 We need to make the main board as small as possible,

ADDRESSING MODES AND INSTRUCTION SET

NetSilicon & Digi Confidential

Baremetal C Programming for Embedded Systems

5 × 7 = × 7 = 70 9 × 7 = CONNECTIONS IN 7 × TABLE

5 × 8 = 40 4 × 8 = 32 9 × 8 = CONNECTIONS IN 8 × TABLE

4 × 6 = 24 8 × 6 = 48 7 × 6 = CONNECTIONS IN 6 × TABLE

5 × 6 = 30 2 × 6 = 12 7 × 6 = CONNECTIONS IN 6 × TABLE

NS Training Hardware.

10 × 8 = 80 5 × 8 = 40 6 × 8 = CONNECTIONS IN 8 × TABLE MULTIPLICATION.

3 × 12 = 36 6 × 12 = 72 7 × 12 = CONNECTIONS IN 12 × TABLE

CHAPTER 4 I/O PORT PROGRAMMING.

5 × 12 = × 12 = × 12 = CONNECTIONS IN 12 × TABLE MULTIPLICATION.

5 × 9 = 45 6 × 9 = 54 7 × 9 = CONNECTIONS IN 9 × TABLE

3 × 7 = 21 6 × 7 = 42 7 × 7 = CONNECTIONS IN 7 × TABLE

Presentation transcript:

And how to configure the each external EEPROM and internal registers? SoC(PCIe RC) XIO3130 Port 0 EEPROM Port 1 Port 2 Port 3 XIO3130 Port 0 XIO3130 Port 0 XIO3130 Port 0 EEPROM EEPROM EEPROM Port 1 Port 2 Port 3 Port 1 Port 2 Port 3 Port 1 Port 2 Port 3 SoC (PCIe EP) SoC (PCIe EP) SoC (PCIe EP) SoC (PCIe EP) SoC (PCIe EP) SoC (PCIe EP) SoC (PCIe EP) SoC (PCIe EP) Not Connect Who can configure the each external EEPROM and internal registers of XIO3130? And how to configure the each external EEPROM and internal registers?