Resistive Circuits Resistors in series Resistors in parallel

Slides:



Advertisements
Similar presentations
Pew Pow Think about the differences between a series circuit and a parallel circuit and explain which method is used to wire your house. Show a formula.
Advertisements

Unit 7 Parallel Circuits
II. Electric current 1. Definition Units: [ I ] = 1A = 1 C/s Conventional current Electron flow Example: electrons passed through the electric conductor.
Circuits Series and Parallel. Series Circuits Example: A 6.00 Ω resistor and a 3.00 Ω resistor are connected in series with a 12.0 V battery. Determine.
DC ELECTRICAL CIRCUITS
Basic Electronics II Series and Parallel Circuits.
Resistance and Ohm’s Law: More Practice
Ch. 23 Series and Parallel Circuits Milbank High School.
Series Circuits Circuits in which there is only one path for current to flow through All elements of the circuit (resistors, switches etc…) are in the.
Concurrent Assessment DC Electronics 1 1.When you have a complete series circuit, is the current flow the same at every place in the circuit? 2.What is.
Section 2: Series and Parallel Circuits. Series Circuits Picture of Series Circuit:Properties: 1)Current: 2) Voltage: 3) Equivalent Resistance:
Series and Parallel Circuits How to find the resultant resistance of an electronic circuit.
INC 112 Basic Circuit Analysis Week 2 Kirchhoff's laws.
Series and Parallel Circuits. Series Circuit Current must pass through all resistors.
KIRCHHOFF’S LAWS & COMBINATIONS OF RESISTORS
+ Using Ohm’s Law to Build a Voltage Divider 1. + Learning Objectives Understand and demonstrate the engineering design process Use Ohm's Law as a tool.
ELECTRIC CURRENT 2 Ohm’s law shows the relationship between current, potential, and voltage. We need a few more rules to make predictions about current.
4/17/10. Electric Circuits Circuit = Any path along which electrons can flow For a continuous flow of electrons, there must be a complete circuit with.
Circuits. V = IR Voltage is electric potential. It is measured in volts (V). I is current. This is the flow rate of electrical charge. It is measured.
RESISTANCE OF A SYSTEM OF RESISTORS Resistance can be joined to each other by two ways: Electricity Combination of Resistors 1. Series combination 2. Parallel.
SERIES RESISTORS AND VOLTAGE DIVISION In Fig the two resistors are in series, since the same current i flows in both of them. Applying Ohm’s law.
Electrical Resistance Electrical resistance is a measure of how difficult it is for electricity (electrons) to flow through a material. The units of resistance.
Circuits and Electronics Midway in Chapter 2 Resistor Combinations.
Regents Physics Chapters 17/18 Circuits  Series Circuits.
Circuits. In circuits, elements are connected by wires. Any connected region of wire has the same potential. (same color = same potential) The potential.
Regents Physics Parallel Circuits –Ohm’s Law in Parallel Circuits.
ELECTRIC CURRENTS. SIMPLE CIRCUIT What’s providing the energy? What’s “moving” in the circuit? What’s causing the movement? e.m.f. = Electromotive Force.
Simple Resistive Circuites
Circuit Basics and Ohms Law. Types of Circuits There are two basic types of circuits SeriesParallel.
Series and Parallel.  a single resistance that can replace all the resistances in an electrical circuit while maintaining the same current when connected.
Ohm’s Law Resistance in Series Circuits
Building Circuits. Why are some Christmas lights more expensive than others?
Electric Circuits. Electric circuit: a complete path from the positive terminal to the negative terminal.
What we will do today Define the term ‘potential difference’. Look at the ratio V/I for a resistor. Define an equation relating resistance, voltage and.
Electric Circuit Types Series and Parallel Circuits.
Chapter 18 Electric Circuits Chapter Opening 18.1 Electric circuits and electric current 18.2 Electrical energy and voltage 18.3 Resistance and Ohm’s law.
Electric Circuits containing resistors. Circuits Charges travel in a circuit to maintain charge balance.
Ohm’s Law PSSA Requirement Unit 9 Honors Physics.
Lecture Name: Dr. Mohammed Elmaleeh Office Location: Building No. D Office Contact Number: ELECTRICAL CIRCUITS (EE 270)
The Series Circuit Summary 1. The sum of the _____________or voltage equals the potential rise of the source. 2. The current is ______________ everywhere.
Kirchhoff’s Current Law For a series circuit: In a series circuit there is only one path so the current must be… Kirchhoff’s Current Law For a series.
Start + end ???? 1.2 Electric circuits Lesson starter
Ohm’s Law.
Resistors in Series Req=equivalent resistance.
Ohm’s Law.
P2 Topic 2: Controlling and using electric currents
Unit 7 Parallel Circuits
II. Electric current 1. Definition a) Conventional current Electron
Circuit Elements Voltage and current sources Electrical resistance
Series Circuit – 1 bulb Series Circuit – 1 bulb.
Resistive Circuits Resistors in series Resistors in parallel
FIGURE 5-1 A series circuit with three bulbs
Resistance Chapter 23.
Topic H: Electrical circuits
  emf Chapter 31 – Some Basics of Circuits The Basic things to know:
P2 Topic 2: Controlling and using electric currents
Series Circuits: Other examples:.
Circuit Elements Voltage and current sources Electrical resistance
One Thing at a Time Series Circuits.
P2 Topic 2: Controlling and using electric currents
Comparing Series and Parallel Circuits
Circuit Elements Voltage and current sources Electrical resistance
Series Circuits: Other examples:.
Resistance in Series and Parallel
Series and Parallel Resistors
Series and Parallel Circuits
Electric Circuits Chapter 35.
SCI 340 L43 circuits Group Work
FIGURE 5-1 A series circuit with three bulbs
Chapters 18 & 19 What is the definition of electric potential?
Presentation transcript:

Resistive Circuits Resistors in series Resistors in parallel Voltage divider Current divider The bridge

Electrical resistance Resistor’s obey Ohm’s Law: V = I R The voltage “drop” across a resistor is linearly proportional to the current passing through the resistor

Resistors in series

Resistors in parallel

Voltage divider

Current divider

A series-parallel connection

The bridge The bridge is “balanced” when the ammeter reads zero If ammeter current = 0, I1 = I3 and I2 = Ix The points A and B are at the same potential So I3R3 = IxRx and I1R1 = I2R2

Classwork #1 Find the total current emitted by the voltage source