ENEE 303 6th Discussion.

Slides:



Advertisements
Similar presentations
Chapter 5: BJT AC Analysis. Copyright ©2009 by Pearson Education, Inc. Upper Saddle River, New Jersey All rights reserved. Electronic Devices and.
Advertisements

Differential Amplifiers and Integrated Circuit (IC) Amplifiers
Recall Lecture 13 Biasing of BJT Applications of BJT
Rowan Hall 238A April 24, 2007 Electronics I for M.E. ECE Load Line Exercises James K. Beard, Ph.D.
Chapter 13 : Bipolar Junction Transistors 13-0 Introduction 13-1 Current and voltage relationships 13-2 Common –emitter characteristics 13-3 Load –line.
The Bipolar Junction Transistor
Module 2: Part 2 Basic BJT Amplifiers. Learning Objectives After studying this module, the reader should have the ability to: n Explain graphically the.
Fig. 7.1 Bode plot for the typical magnitude term. The curve shown applies for the case of a zero. For a pole, the high-frequency asymptote should be drawn.
Practical Differential Amplifier Design We’ve discussed Large signal behaviour Small signal voltage gain Today: Input impedance Output impedance Coupling.
BJT Differential Pair Transistors Q1, Q2 are matched
© 2000 Prentice Hall Inc. Figure 7.1 The current mirror.
Microelectronic circuits by Meiling CHEN 1 Lecture 13 MOSFET Differential Amplifiers.
Chapter 5 Differential and Multistage Amplifier
1 The 741 Operational-Amplifier. Reference Bias Current : The 741 op-amp circuit. Reference Bias Current.
Figure 7.12 The basic BJT differential-pair configuration.
Recall Last Lecture Biasing of BJT Applications of BJT
Operational-Amplifier Circuits
Chapter 5: BJT AC Analysis
Figure 8.1 The basic MOS differential-pair configuration.
전자회로 개요 기초 이론 Diode Transistor (MOSFET, BJT) 전자회로 1
3-1 McGraw-Hill Copyright © 2001 by the McGraw-Hill Companies, Inc. All rights reserved. Chapter Three The Bipolar Junction Transistor.
HW due Friday (10/18) 6.39,6.61,6.71,6.80 October 15, 2002.
POWER AMPLIFIER Class B Class AB Class C.
Problems on Terminal Resistances Chapter 5. Schedule 153/4TuesdayTerminal Resistance (R B, R C and R E ) L3/4Tuesday small signal model from Cadence,
Transistor Circuit DC Bias Part 1 ENGI 242. February 2003ENGI 2422 DC Biasing Circuits Fixed-Bias Circuit Emitter-Stabilized Bias Circuit Collector-Emitter.
Microelectronic Circuit Design, 3E McGraw-Hill Chapter 13 Small-Signal Modeling and Linear Amplification Microelectronic Circuit Design Richard C. Jaeger.
Circuit Theorems. Quiz 1. The source resistance from a 1.50 V D-cell is 1.5 . The voltage that appears across a 75  load will be a V b V.
HW #5 7.10, 7.21, 7.71, 7.88 Due Tuesday March 3, 2005.
SEM I 2008/09 LECTURE IV: C-E AC ANALYSIS II DMT 231 / 3 ELECTRONICS II Lecture IV AC Analysis II [BJT Common-Emitter Amplifier]
Chapter 15 Differential Amplifiers and Operational Amplifier Design
3.TRANSISTOR CIRCUIT CONFIGURATION
741 Op-Amp Where we are going:. Typical CMOS Amplifier.
1 Small Signal Model MOS Field-Effect Transistors (MOSFETs)
SJTU Zhou Lingling1 Chapter 5 Differential and Multistage Amplifier.
Exam 3 information Open book, open notes, bring a calculator Eligible topics (1 of 9) (not an exhaustive list) Generic amplifiers Amplifier basics voltage.
The Bipolar Junction Transistor
Emitter-Stabilized Bias Circuit Load Line Analysis.
BJT transistors Summary of DC problem 2 Bias transistors so that they operate in the linear region B-E junction forward biased, C-E junction reversed.
Transistor Modelling A model is a combination of circuit elements, properly chosen, that best approximates the actual behaviour of a semiconductor device.
Recall Last Lecture Biasing of BJT Applications of BJT
Chapter 1 Introduction to Electronics
BJT transistors.
Recall Last Lecture Biasing of BJT Three types of biasing
Chapter 9 Common-Emitter Amplifiers
Bipolar Junction Transistor
ENEE 303 4th Discussion.
Recall Lecture 14 Introduction to BJT Amplifier
Transistor Amplifiers
EI205 Lecture 15 Dianguang Ma Fall 2008.
SMALL SIGNAL ANALYSIS OF CB AMPLIFIER
SMALL SIGNAL ANALYSIS OF CE AMPLIFIER
Chapter 5: BJT AC Analysis
Analog Electronic Circuits 1
Transistor & Voltage Divider
Subject Name: Microelectronics Circuits Subject Code: 10EC63
Electronics Fundamentals
741 Op-Amp Where we are going:.
ENEE 303 5th Discussion.
Recall Last Lecture Introduction to BJT Amplifier
Recall Last Lecture Voltage Transfer Characteristic
Recall Lecture 12 Voltage Transfer Characteristics Biasing of BJT
Recall Last Lecture Introduction to BJT Amplifier
Recall Last Lecture Voltage Transfer Characteristic
Recall Last Lecture Introduction to BJT Amplifier
Lecture 24 ANNOUNCEMENTS OUTLINE
Review & Problems.
DC Biasing Circuits.
Analysis of Single Stage Amplifiers
Chapter 13 Small-Signal Modeling and Linear Amplification
Chapter 15 Differential Amplifiers and Operational Amplifier Design
Presentation transcript:

ENEE 303 6th Discussion

Contents MOSFET differential pair (discussion 5) Y matrix of BJT Homework problems

Differential Pair: MOSFET I in terms of (vb1-vb2)

Small-Signal Operation of the MOS Differential Pair   Neglect channel modulation Because of symmetry, the common source connection acts as virtual ground

Y Matrix of BJT I in terms of (vb1-vb2)

Y Matrix of BJT 𝒊𝒃 𝒊𝒄 𝒊𝒆 = 𝒈𝝅+𝒔𝑪𝝅, 𝟎, −𝒈𝝅−𝒔𝑪𝝅 𝒈𝒎, 𝒈𝒐, −𝒈𝒎−𝒈𝒐 −𝒈𝝅−𝒈𝒎−𝒔𝑪𝝅, −𝒈𝒐, 𝒈𝝅+𝒈𝒎+𝒈𝒐+𝒔𝑪𝝅 𝒗𝒃 𝒗𝒄 𝒗𝒆 I in terms of (vb1-vb2)

Y Matrix of BJT: HW6 Problem1 Assume a properly biased transistor working linearly with small signals. a) For the grounded base transistor give the admittance matrix with port-1 seen as emitter to base and port-2 as collector to base. b) From that give the input admittance seen at the emitter to ground when loaded at the collector to ground by yL(s). c) Find the Thevenin’s equivalent seen from collector to base when fed at port-1 by a voltage source, vi, in series with a resistor of conductance Gi. I in terms of (vb1-vb2)

CMOS bidirectional current mirror I in terms of (vb1-vb2)

OTA with feedback I in terms of (vb1-vb2)

Thevenin’s Equivalent Circuit Find the small signal Thevenin’s equivalent seen looking between the output and ground of the following circuit. Assume complementary transistors biased at collector currents of 5ma, Early voltages of 20V, Cπ=1pFd and Cμ=0. I in terms of (vb1-vb2)