Power Steering Test Stand User Guide

Test Set-up Instructions 1) Prepare a Module and EPS 2) Place Module Onto Pins 3) Place EPS onto Mounting Block 4) Attach Slip-shaft to EPS output 7) Using the Barcode Scanner (Left) Scan the Motor Barcode, Motor Type, and side of stand that will be run. 5) Attach EPS and Module Wires 6) Attach Module Wires to Terminal At this point, the stand will start the test. Proceed to the next page to view the test instructions. 1

In Test Instructions LED KEY PASS FAIL RUNNING LED’s *Flashing MOTOR NOT ATTACHED *Solid If the Motor passes, two barcodes will be printed. One goes on the motor, the other on the module. 2