How to do a Manual Titration

Slides:



Advertisements
Similar presentations
Antacids Titration Lab. Teacher Preparation 1.Gather all materials and place them in trays at each lab station. Have extra flasks, beakers & graduated.
Advertisements

Standardising potassium permanganate solution with iron(II) sulfate
Titration By Dr H W Winter.
Pipetting Pipetting involves drawing a liquid into a pipet and allowing liquid to drain from the pipet in a controlled manner. Pipetting is used to quantitatively.
Laboratory Techniques I: Dilution Go to browse and set to full screen.
Volumetric Analysis Apparatus. The Volumetric Flask.
Exp 4C: How Much Acetic Acid is in Vinegar?
Common Laboratory Glassware and Volumetric Glassware Prepared By Michigan Department of Environmental Quality Operator Training and Certification Unit.
Volumetric Analysis Apparatus. The Volumetric Flask.
MLAB 1335 Immunology Serology Terry Kotrla, MS, MT(ASCP)BB
CHM 101/102 Laboratory Manual Water Hardness: Determination with EDTA General Chemistry 101/102 Laboratory Manual University of North Carolina at Wilmington.
Laboratory Glassware and equipment lab 2
Laboratory Techniques II: Titration
Lab Techniques How to do a Manual Titration. Rinse the inside of the Burette Rinse the burette with 2-3 mLs of standarized NaOH solution. Make sure all.
How to do a Manual Titration. Rinse the Burette with 2-3 mL of standardized NaOH solution. Make sure all inside walls including the tip are rinsed. Discard.
Performing a titration A bluffers guide! Preparing a standard solution 4 Accurately weigh a weighing bottle, recording the mass 4 Add approximately x.
COMMON LABORATORY EQUIPMENT. FLASKS, BEAKERS, CYLINDERS Erlenmeyer flask beaker Erlenmeyer flasks and beakers are used for mixing, transporting, and reacting,
MLAB 1335 Immunology Serology Terry Kotrla, MS, MT(ASCP)BB
Experimental Procedure. Overview The supernatant from a saturated calcium hydroxide solution is titrated with a standardized hydrochloric acid solution.
Titration and Buffers Chemistry Department Minneapolis Community & Technical College Intro to Chemistry Chem1020 Lab 1.
Chapter 8: Density mass volume density = for example, the density of benzene is: g mL.
AcidAcid / Base Titration – K a (HAc)BaseTitration AcidAcid / Base Titration – K a (HAc)BaseTitration Hand in: Pre-Lab and Equilibrium report and Submit.
HCl (aq) + NaOH (aq)  NaCl (aq) + H2O (l)
Acid/Base Titration Thurston High School Chemistry.
Lab Techniques How to do a Manual Titration. Rinse the inside of the Burette Rinse the burette with 2-3 cm 3 of water then with 2-3 cm 3 the solution.
A buret is used to deliver solution in precisely-measured, variable volumes. Burets are used primarily for titration, to deliver one reactant until the.
Some Common Laboratory Glassware Please be careful when using glassware in the laboratory. Wet glassware and wet gloves are slippery. Always read a volume.
Volumetric Analysis Topic 8.4 Titration readings in a normal titration you are usually advised to carry out at least one rough and two accurate.
Vitamin C tablets vs. Citrus fruit juice
TITRATION Andy Park. What is Titration? A method of quantitative chemical analysis used to calculate concentration A known concentration and volume of.
4/24/ :54 PM Accuracy = of a measurement is how close that measurement is to the true or “exact” value EX: Standard weight = 5.00g 4.98g more accurate.
Experiment 1 Basic Laboratory Techniques Parts A, D, E, and an Unknown
Experiment 8. Thermodynamics of the Dissolution of Borax
General chemistry Lab 2. Chemistry Analytical Chemistry Gravimetric Analysis Oxidation and Reduction Reactions Oxidation and Reduction Reactions Instrumental.
Preparing Solutions.
Introduction to Titration Go to browse and set to full screen.
Titration of Acetic Acid Chemistry Titration  Commercial White Vinegar  Determination of Molar Concentration Of Acetic Acid.
General Laboratory Techniques Dry Lab Chemistry 1105.
Balancing An Equation Experimentally CHEMISTRY 1105.
枣庄学院化学化工与材料科学学院 Preparation of Solution. 枣庄学院化学化工与材料科学学院 1. Grasp the basic Method and Operation of Preparing Solution 2. Study the Method of Use about.
Trinity College Dublin, The University of Dublin Titration Demonstration.
Practical Analytical Chemistry (1) Practical (8) Faculty of Pharmacy Department of Pharmaceutical Chemistry.
Density of Liquids and Solids. A. Instructor Demonstration Take down observations as each step is performed by the instructor Make sure to label each.
Identification of Substances by Physical Properties.
How much acid is there in a solution
Laboratory Glassware and equipment
TITRATION OF A STRONG BASE WITH A STRONG ACID
How to do a Manual Titration
Measurement and Lab Equipment
MLAB 1335 Immunology Serology Terry Kotrla, MS, MT(ASCP)BB
Lab Techniques How to do a Titration.
Measurement of Volume Chapter 20.
Preparing Standard Solutions
Titrations.
Titration Ensuring good volumetric technique
Diluting Aqueous Solutions (page )
Introduction to Titration
Laboratory Techniques: Titration
Volumetric Analysis Apparatus.
Identification of the common laboratory glassware, pipettes and instruments . BCH 312 [PRACTICAL]
Common Laboratory Glassware
Volumetric Analysis Apparatus.
Acid/Base Titration Purpose- to find the concentration of four HCl samples, by titrating them with 0.100M NaOH Solution(titrant).
Experiment 1 Basic Laboratory Techniques Parts A, D, E, and an Unknown
Laboratory Glassware.
Procedure Notes Part 1: Making NaOH solution
Procedures Reading from the text.
Mustard Titration Mrs. Wilson
Identification of the common laboratory glassware, pipettes and instruments . BCH 312 [PRACTICAL]
Presentation transcript:

How to do a Manual Titration Lab Techniques How to do a Manual Titration

Rinse the inside of the Burette Rinse the burette with 2-3 mLs of standarized NaOH solution. Make sure all inside walls including the tip are rinsed.

Fill the Burette Discard the rinse solution into the sink or a “waste” beaker. Close the stopcock, return the burette to the lab stand and fill with NaOH.

Take an Initial Reading Make sure your eye is level with the meniscus before taking any readings. meniscus

Reading the Burette Read and record burette measurements with care. Take all readings to 2 decimal places. This burette is reading 24.28. The last digit is an estimate.

Rinse the Volumetric Pipet Use the rubber pipet bulb to draw 2-3 mLs of the sample into the pipet. Hold the pipet in a vertical position and tilt so the solution contacts all inside surfaces of the pipet. Discard the Rinse Solution.

Pipet a 10.00 mL Sample Use a rubber bulb to draw solution up into the volumetric pipet. The volume should be above the mark. Use your index finger to control the level of the solution in the pipet. When the bottom of the meniscus is at the mark, the volume is correct.

Transfer the Sample Move the filled pipet to an erlenmeyer flask. Release your finger and allow the liquid to drain on it’s own. Touch the tip of the pipet to the side of the flask and remove the pipet.

Add an Indicator Add 3-4 drops of phenol-phthalein indicator to each flask.

Use Proper Titration Techniques Manipulate the burette stopcock with your left hand. Hold and swirl the flask with your right hand. Note: Instructions are for right handed persons. Do the reverse if left handed

Rinse Down the Flask Use small amounts of distilled water to rinse down the sides of the flask from time to time, during the titration.

Aiming for Accuracy As you near the endpoint add the NaOH dropwise then a fraction of a drop at a time. To add a fraction of a drop, allow the drop to form on the tip of the burette then rinse it in with dist. Water. Accuracy is how close your value is to the actual or known value.

Precision and Finishing The titration is over when the solution becomes, and stays, a very pale pink. This is known as the “End Point” of the titration. Precision is how close your values are to each other. Aim for 3 samples to be within 1% of each other.