Commercial Stainless Steel Freezers December 2016

CU-221EDF SS Features: Digital Temp Control With Lock and Key Stainless Steel Dual Function Upright Freezer Features: Digital Temp Control With Lock and Key LED-Lighted Interior Programmable Automatic Defrost Adjustable Wire Shelves Roller Feet with Stopper Embraco/Secop Compressor Eco-friendly R404a Refrigerant Capacity: 600 Liters Temp: -22˚C to +10 ˚C HWD in mm: 2010 x 680 x 810

CU-438EDF SS Features: Digital Temp Control With Lock and Key Stainless Steel Dual Function Upright Freezer Features: Digital Temp Control With Lock and Key LED-Lighted Interior Programmable Automatic Defrost Adjustable Wire Shelves Roller Feet with Stopper Embraco/Secop Compressor Eco-friendly R404a Refrigerant Capacity: 1065 Liters Temp: -22˚C to +10 ˚C HWD in mm: 2010 x 1333 x 774

Accessories User’s Manual Programming Manual Warranty Card Keys 1 2 3 4

Technical Specifications Model Number CU-221EDF SS CU-438EDF SS Rated Voltage / Frequency 220-240V/60Hz Current 4.2A 6.3A Wattage Energy Consumption 8.8KWh/24h 9.6KWh/24h Refrigerant/Amount R404a/380g R404a/450g Net Weight in kg 115kg 164kg Gross Weight in kg 125kg 173kg Compressor Brand Embraco Compressor Model NT2180GK NJ2212GK

Located at the right-hand wall of the unit. Model and Serial Number Location Model Number Serial Number Located at the right-hand wall of the unit.

Installation Procedure After delivery, allow the unit to stand for 12 hours before operation, in order to let the compressor oil settle. Before using the unit for the first time clean the shelves and freezer cavity with soapy water. ONLY USE DISH WASHING SOAP. Allow the unit to operate EMPTY until the SET TEMPERATURE IS REACHED before introducing a heat load. This allows the compressor to warm up first. Set the brakes of the roller feet to keep the unit in its intended position. Maintain a distance of 20cm (7 inches) between the unit and the walls or other objects for ventilation. Increase distance if the object next to the unit produces heat.

Control Panel Compressor Indicator Light Temperature Controller Power Switch 1 2 4 3 Switches the controller to programming mode Increases the value of the controller parameter Decreases the value of the controller parameter Activates the Manual Defrost mode

Control Panel Commands Control Panel Legends and Commands Control Panel Legends Control Panel Commands

Usage TURNING ON THE UNIT AND SETTING THE TEMPERATURE Make sure that power switch is set to [O] before the power cord is plugged into the power source. Switch on the Power [I]. The current temperature will be displayed on the screen.

Usage TO MANUALLY DEFROST THE UNIT Press and hold the DEFROST button for 5 seconds. The defrost cycle will start immediately and the DEFROST symbols will light up on the display. NOTE: The defrost cycle will last for 30 minutes

Care and Maintenance Switch off and disconnect the power cord from the power supply before cleaning Clean the freezer cavity as often as possible to maintain food safety Do not use abrasive cleaning agents as this leaves harmful residue and damages the freezer cavity. Clean the door seal with WATER ONLY. Always wipe dry after cleaning Do not allow water used in cleaning to run through the drain hole into the evaporation pan. Take caution when cleaning the back of the unit. Sharp edges may cause injury.

Care and Maintenance The condenser filter should periodically be cleaned in order to let the unit run on its optimal performance. Condenser Filter

Self-correction Routine Error Codes Self-correction Routine Error Code Self-correction Routine P1 and P2 Unit automatically stops for a few seconds afterwards the unit resumes its normal operation HA and LA Error automatically clears as soon as the temperature returns to normal values. EA and CA Error automatically clears as soon as the digital input is disabled

Commercial Stainless Steel Freezer Warranty Information Commercial Stainless Steel Freezer 1 Year Warranty on Parts 1 Year Warranty on Service 1 Year Warranty on Compressor