Safety Hazards for Asbestos Abatement Workers

Slides:



Advertisements
Similar presentations
Preventing Slips, Trips & Falls
Advertisements

Good Housekeeping Nueces County Risk Management Department
1 Walking and Working Surfaces. 2 Related Work Activities Working in a greenhouse Pruning trees Mowing lawns Trimming Carrying heavy loads Painting.
Ladders and Stairs. Hazards of ladders Falls Slips Reaching too far Weather 1a.
SETUP Chapter 6 Lead Abatement for Workers Course.
Stairways & Ladders
Walking-Working Surfaces
Slips, Trips, and Falls. Section I Introduction 2.
This material was produced under grant number SH F-51 from the Occupational Safety and Health Administration, U.S. Department of Labor. It.
1 Walking-Working Surfaces This material was produced under grant [SH20856SH0] from the Occupational Safety and Health Administration, U.S. Department.
When you see a hazard… Take time to correct it.. What’s wrong with this photo?
Slips, Trips, and Falls. Fall Factors Friction Momentum Gravity 1a.
Walking-Working Surfaces
Walking-Working Surfaces: Preventing Falls.
Good Housekeeping Maintaining focus.
Welding, Subpart J OSHA 500 Course. Critical Hazards n Heat is a source of ignition in the various welding processes n Welding fumes can become a health.
Liquid Fuel Safety Cummins Southern Plains, Ltd..
Electrical Safety - Construction. Electricity - The Dangers About 5 workers are electrocuted every week Causes 12% of young worker workplace deaths Takes.
BUILDING TRADE SAFETY ELECTRICAL SAFETY.
OSHA’s Top 10 Violations in General Industry: Hazard Communication 2.Respiratory Protection 3.Lockout/Tagout 4.Electrical, Wiring Methods 5.Powered.
This training tool is brought to you by
Electrical Safety INSTRUCTOR’S NOTES:
Electrical Safety INSTRUCTOR’S NOTES:
GENERAL INDUSTRY SAFETY TEST. What does OSHA stand for? 1.Occupational Safety and Health Administration 2.Occupational Safety and Help Administration.
Walking-Working Surfaces: Preventing Falls. Start Safe and Stay Safe In order to Start Safe and Stay Safe in the areas where you walk and work, you should.
OSHA Office of Training and Education - Revised by TEEX 12/04/07 1 Walking-Working Surfaces.
HVACR416 - Design Electrical Safety. Safety and Hazard Prevention Current is the killing factor in electrical shock Human bodies has resistance If voltage.
1 SAFETY and HAZARD PREVENTION SAFETY and HAZARD PREVENTION NEXT.
1 Falls Module 2. 2Objectives After this module you should be able to – identify the most common fall hazards – take the steps necessary to avoid those.
1 HVACR317 – Core for Refrigeration Safety and Hazard Prevention.
Safety Training for the Focus Four Hazards in the Construction Industry.
OSHA Office of Training and Education 1 Walking-Working Surfaces.
Theatre Safety A quick guide to avoiding accidents in class.
An Introduction………. The Benefits Connect directly with 12V Battery and Enjoy. Low and High Speed to use as per need. Only 12W consumption.
POWER TOOL SAFETY.
3 things needed to make a circuit: 1. Battery - energy 2. Wire – transfers the electricity 3. Indicator – tells you if circuit is working Ex: light, sound,
Inspection Programs.
Recognizing and correcting hazards
ELECTRICAL SAFETY. OSHA Office of Training & Education Electrical Safety.
HEMIC Hawaii Employers Mutual Insurance Company Pathways to Safety Series Restaurant Safety HEMIC Loss Prevention Series.
Flammable Liquids Directorate of Training and Education
Business, Marketing, and Computer Technology
Ladder Safety Training
Georgia Tech Safety and Health Consultation Program
PROTECTING THE WORKER PROTECTIVE CLOTHING Need for clothing
Walking and Working Surfaces
Stairways & Ladders
Evaluating Slip, Trip and Fall Hazards
Slips, Trips, and Falls.
Slip, Trips and Falls are the #1 cause of workplace accidents
Chapter 2 – Safety in Welding
WORKSITE PREP AND THE DECON
Waste Disposal Requirements
Stairways & Ladders
Fall Hazards.
Stairways & Ladders
Safety O.H.S..
Slips, Trips, and Falls.
GLOVE BAGGING & PLASTICIZING
Medical Surveillance 05/19/02 Medical Surveillance
Slips, Trips, and Falls.
Fall Hazards.
Safety Moments Topic: Material Handling, Ergonomics, Lifting, Ladders
Slips, Trips and Falls Safety Meeting Topics
SLIPS & FALL PREVENTION
Basic Electrical Safety
IOES Guidance Document
Fall Hazards.
Click anywhere to get started…
Presentation transcript:

Safety Hazards for Asbestos Abatement Workers Other Safety Concerns 06/03/02 Safety Hazards for Asbestos Abatement Workers SLIDE #1 (Tray 2 – 39): Safety Hazards for Asbestos Abatement Workers 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #2 (Tray 2 – 40): A temporary light with a poor splice and poorly place -- not of the low-power portable variety recommended. The aluminum reflector gets hot. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #3 (Tray 2 – 41): A similar problem found in the previous slide w/o the splice concern. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #4 (Tray 2 – 42): All-around poor housekeeping, including potential trip hazards. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #5 (Tray 2 – 43): Power panels covered with one layer, not two, of critical barrier poly – and hopefully locked and tagged out. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #6 (Tray 2 – 44): A poorly dressed-out abatement worker shoveling asbestos. (Questions: Is heat stress a problem? Is the shovel metal or plastic? Is this the time to be scooping up this ACM waste? This is slide #81 from Tray 1) 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #7 (Tray 2 – 45): Poor electrical maintenance and handling of wire – at least a trip hazard – and code violations very likely. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #8 (Tray 2 – 46): More electrical wiring and connection hazards, as well as trip hazard. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #9 (Tray 2- 47): Improper use of a ladder and working in a tight spot. (There is someone standing on the ladder.) 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #10 (Tray 2 – 48): An improperly dressed-out abatement working using a chair for a ladder or portable scaffold. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #11 (Tray 2 – 49): Improper use of ladder and perhaps heat stress? Or just poor work habits? 06/03/02 CPWR

SLIDE #12 (Tray 2 – 50): Several trip hazards. Other Safety Concerns 06/03/02 SLIDE #12 (Tray 2 – 50): Several trip hazards. 06/03/02 CPWR

SLIDE #13 (Tray 2 – 51): Trip hazards and poor critical barrier work. Other Safety Concerns 06/03/02 SLIDE #13 (Tray 2 – 51): Trip hazards and poor critical barrier work. 06/03/02 CPWR

SLIDE #14 (Tray 2 – 52): Trip hazards and tardy cleanup. Other Safety Concerns 06/03/02 SLIDE #14 (Tray 2 – 52): Trip hazards and tardy cleanup. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #15 (Tray 2 – 53): Steps where airlines may be a trip hazard. (Question: What about the poly on the steps – do you see some-thing not right?) 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #16 (Tray 2 – 54): One way to prevent slipping of the stair poly. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #17 Tray 2 – 55): Improperly dressed-out abatement workers who may fall at any moment, especially the worker second from the right. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #18 (Tray 2 – 56): A repeat from the previously slide, only add ACM with metal lathing. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #19 (Tray 2 – 57): Improperly dressed-out abatement worker in a just plain sloppy regulated area. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #20 (Tray 2 – 58): Improperly dressed-out abatement worker wearing a half-face respirator w/air hose gripping metal lathing. 06/03/02 CPWR

Other Safety Concerns 06/03/02 SLIDE #21 (Tray 2- 59): Disposal of waste bags where the worker on the ground to the right is not dressed-out, while the workers in the truck are. And, Who or what is going to fall over the edge first? (Workers in back of truck have continuous-flow helmets on.) 06/03/02 CPWR