Joe Blubaugh Diana Mui David Sutherland Matthew Swallow

Slides:



Advertisements
Similar presentations
Amplifying Signals Breadboarding: from a diagram to an actual working amplifier.
Advertisements

Chapter 10 Analog Integrated Circuits The 741 OP-AMP Introduction.
Team 12 Greg Eakins Eric Geier Pete Dudash Jeremy Gries The Two Wheel Deal SS 4000.
1 More on Op Amps Discussion D Ideal Op Amp 1) The open-loop gain, A v, is infinite. 2) The current into the inputs are zero.
Operational Amplifier
INTEGRATED CIRCUITS EE OVERVIEW  Introduction  What are Op-Amps?  Circuit symbol and Pin- Configuration  Inverting and Non-inverting modes..
Sample servo diagrams and Bode plots. Acousto optic performance plots Unlock servo Measure gain and phase vs drive input K.
Operation Amplifier. Golden Rules of OP Amp 1.i in =0, no current flow into op amp. 2.V + =V - Typically one end of op amp is connected to ground, therefore,
P07301 Summary Data Acquisition Module. Team Members.
Servo Control Using Analog Signal Obtain “analog” input using analogRead().
The Ideal Op-amp (Operational amplifier) + – v+v+ v–v– V OUT + – + – V IN V OUT V IN [μV] V OUT [V] +15V –15V V OUT =A(v + –v – ) A~10 5 saturation.
Chapter 8 Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.
1 Motors & Motor Controllers ECE AC or DC Motors AC –Few robots use AC except in factories –Most of those that use AC first convert to DC DC –Dominates.
ECE 340 ELECTRONICS I OPERATIONAL AMPLIFIERS. OPERATIONAL AMPLIFIER THEORY OF OPERATION CHARACTERISTICS CONFIGURATIONS.
Digital-to-Analog & Analog-to- Digital Conversion Anuroop Gaddam.
P-REV Initial PCB Michael Connaboy Stephen Schiffli Ram Hudiara Win Than Aung.
Servo Motor Control Demonstration.
Fall CS-EE 480 Lillevik480f04-l1 University of Portland School of Engineering Project Swift Fox Design Review 21 Jan 2005 Peter Brunke Andrew Robinson.
Servo Motor Control Demonstration. EML 2023 Department of Mechanical and Aerospace Engineering motor with gear reducer flex coupling incremental optical.
Font 4 Review Digital Feedback System BPM Analogue Processor Digital Processor Feather Kicker Power Amplifier Pick up StriplinesKicker StriplinesBeam.
Control Angle via Button Pushes One button increases angle. Other decreases angle. Both light LED.
EE445:Industrial Electronics. Outline Introduction Some application Comparators Integrators & Differentiators Summing Amplifier Digital-to-Analog (D/A)
Operational Amplifiers. What is an Op Amp? High voltage gain IC with differential inputs –Designed to have characteristics near ideal Inexpensive, widely.
Operational Amplifiers AC Power CHAPTER 8. Figure 8.2, A voltage amplifier Figure 8.2 Simple voltage amplifier model Figure 8.3.
Joe Blubaugh Diana Mui David Sutherland Matthew Swallow.
What does Boris do? a progressively more technical answer.
ECE 194 S’01 Introduction to Engineering II Arizona State University 1 The operational amplifier, cont.  Has a multitude of circuit applications  Linear.
ELECTRONICS PRIMER II.
THEMIS Instrument CDR 1 UCB, April 19-20, 2004 Boom Electronics Board (BEB) Engineering Peer Review Apr. 20, 2004 Hilary Richard.
TECHNIQUES OF DC CIRCUIT ANALYSIS: SKEE 1023
What is an Amplifier…? An Amplifier is a device which takes small voltage at the input, amplifies it and produce higher voltage at the output. The gain.
Senior Design Project A Simple Thermostat. Build This.
Test of E906 PreAmp Prototype Da-Shung Su, Su-Yin Wang, Ting-Hua Chang, Wen-Chen Chang 2010/01/28.
1 PRELIMINARY PCB LAYOUT Autonomous Targeting Vehicle (ATV) Daniel Barrett Sebastian Hening Sandunmalee Abeyratne Anthony Myers.
Preamplifiers : BGA 2003 (Silicon MMIC amplifier): In general, the function of a preamp is to amplify a low-level signal to line-level. DESCRIPTION: Silicon.
Figure 8.2, A voltage amplifier Figure 8.2 Simple voltage amplifier model Figure 8.3.
ELECTRONIC SYSTEMS ENGINEERING TECHNOLOGY TEXAS A&M UNIVERSITY Innovating tomorrow’s products and systems today Krisys Technology Krisys Robot Sensor Board.
Servo Demonstration In MPIDE, select File > Examples > Servo > Sweep.
ASIC Activities for the PANDA GSI Peter Wieczorek.
Impedance Matching Units. Maximum Power Transfer Theorem As we have seen previously the output of a power amplifier must transfer as much power as possible.
Prestenters : Ehab Shakour Gaby Shakour Instructor : Moni Orbach.
Ryan McLean John-Michael Mulesa Joe Perrin Zach Schoenberger.
Task List  Group management plan  Background studies  Link budget: optical/electrical  Build, test learning Rx board  Order components for transceiver.
1 Operational Amplifiers n Ideal Op-Amp –input terminals –differential gain, open-loop gain.
Advanced Programming Analog Operation % 0 8 steps 100% True Analog Volts.
Evaluation of OPA569 Bridge-Tied-Load Errol Leon and Thomas Kuehl Precision Linear Analog Applications January 26,
Sound Source Location Stand Group 72: Hiroshi Fujii Chase Zhou Bill Wang TA: Katherine O’Kane.
© 2015, Cornell Bioacoustics Research Program Are Raven’s dB measurements SPL? By default, Raven’s dB measurements are relative to an arbitrary reference.
A Wireless Local Area Network by Raymond Woodward.
Enrollment no. : Darshan Institute of Engineering & Technology - Rajkot Department of Electrical Engineering ANALOG ELECTRONICS ( )
CSE 341 Project : Ultrasonic Radar PRESENTED BY: NAME : AKIFA TASNEEM ID : SECTION: 02 1.
Motors & Motor Controllers
BIOPOTENTIAL AMPLIFIERS
SUMMING AMPLIFIER INTEGRATOR DIFFERENTIATOR COMPARATOR
Digital-to-Analog Analog-to-Digital
Feedback No feedback : Open loop (used in comparators)
Examples of Negative Feedback Applications: A) Inverting Amplifiers
Joe Blubaugh Diana Mui David Sutherland Matthew Swallow
Yuchen Chai, Pradeep Shenoy, Philip T. Krein
In the name of allah.
The operational amplifier, cont.
μ[sic] preliminary pcb
Design Team 3 Texas Instruments Contact: Pete Semig Facilitator:
Operational Amplifiers
Lesson 11: Transducer Electrical Interfaces
Joe Blubaugh Diana Mui David Sutherland Matthew Swallow
Nathan Meyers Joe Riley Matthew Barga Alex Reyes
Arduino Controlled DC Load
Team 14 PCB Layout Design Narrative
Preliminary PCB Layout Presented by: Carey Woolet
Presentation transcript:

Joe Blubaugh Diana Mui David Sutherland Matthew Swallow .das Autotünr. Joe Blubaugh Diana Mui David Sutherland Matthew Swallow

PCB Considerations Three different voltage rails – 6VDC (unreg), 5VDC (reg), 3.3VDC(reg). Current draw of servo motors when in use. Signal integrity of servo motor control. Noise on microphone input and analog amplifier output. Sizing

Preliminary PCB Layout 5.4” 4.4”

Preliminary PCB Layout

Preliminary PCB Layout

Power Rail – 6VDC (Unreg)

Power Rail – 5VDC (Reg)

Power Rail – 3.3VDC (Reg)

The Sum of All Power!

Ground Rail

Signal Integrity

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2024 SlidePlayer.com. Inc. All rights reserved.