ActivRACTM 30P Mobilized Storage System

Capabilities ActivRAC® 30P Mobilized Storage System Wt. Capacity 30,000 lbs per rack section, 60,000 lbs back to back racking Can utilize existing racking Requires structural footings under rails. To be determined by licensed structural engineer System requires rails to be leveled and floor finished flush to rail Carriage design capability permits virtually unlimited carriage layout configurations Heights – Base height to width ratio up to 4 to 1

Applications ActivRAC® 30P Mobilized Storage System

Guide Rail ActivRAC® 30P Mobilized Storage System Welded steel two piece structural rail 2.5” square steel bar with center groove machined 6” wide x ½” thick base Center flange guidance-minimum two guide rails Rails to be set level and welded to top plates anchored to floor or footings with threaded rods or J-bolts

Guide Rail Footings ActivRAC® 30P Mobilized Storage System

Guide Rail On Top of Existing Structural Slab ActivRAC® 30P Mobilized Storage System

Load Rail ActivRAC® 30P Mobilized Storage System Welded steel two piece structural rail 2.5” square steel bar 6” wide x ½” thick base Rails to be set level and welded to top plates anchored to floor or footings with threaded rods or J-bolts.

Load Rail Footings ActivRAC® 30P Mobilized Storage System

Load Rail On Top of Existing Structural Slab ActivRAC® 30P Mobilized Storage System

Wheel Guide & Load ActivRAC® 30P Mobilized Storage System Large 10 5/8” diameter load and drive wheels Precision machined solid steel wheels Each wheel has two permanently lubricated and shielded radial ball bearings

Carriage Base ActivRAC® 30P Mobilized Storage System Welded Wheel Assemblies Bolted structural steel construction Welded Uniframe wheel assemblies Integral rack beams Integral cross bracing Wire raceway and cover Powder-coat painted finish Integral Rack Beams Cross Bracing Wiring Raceway

Multiple Synchronized Motors ActivRAC® 30P Mobilized Storage System Provides smooth and even carriage movement ¼ HP 90 volt DC gearmotor Multiple synchronized motors adapt to un-level floor conditions and un-balanced loading Continuous closed loop motor feedback system monitors all motors Direct chain drive 2.6” per second carriage speed Multiple Synchronized Motors

Control Box & Operational Interface ActivRAC® 30P Mobilized Storage System All control boards located in the front control box for easy access for service Open an aisle with one-touch directional control button or an infrared remote control aboard a fork truck Safety Stop/Reset button immediately stops any moving carriage(s) System operational status lighted indicators Flashing beacon and horn warns of carriage movement

Safety System - Photo Sweep ActivRAC® 30P Mobilized Storage System Photo sweep extends the entire length of both sides of the carriage Stops movement of system and requires manual reset when the beam is broken in a closing aisle Add Red Line Photo Sweep

Safety System - Aisle Entry ActivRAC® 30P Mobilized Storage System Automatically stops and prevents carriage movement when entering a closing aisle Manual reset at open aisle provides additional safety by prompting users to visually check the open aisle before resetting the system Does not stop carriage(s) movement when entering an open aisle Add Red Line Aisle Entry Sensor

Optional Features ActivRAC® 30P Mobilized Storage System Infrared remote control – user key Requires a manual reset and visual check of open aisle for operation Infrared remote control – managerial key Rechargeable battery pack - Half Speed - Manual “push and hold” power operation - Approx. _ hours of operation Can interface with inventory control systems (ERP/WMS) provides by third party Available on 16P and 30P