CENTROIDS AND CENTRES OF GRAVITY

Slides:

Advertisements

Similar presentations

Load Paths and Tributary Area Examples

Advertisements

Distributed Forces: Centroids and Centers of Gravity

Chp12- Footings.

Abstract This project is a structural analysis and design of a residential building located in JENIEN City, The building is consisted of 7 floors. The.

PREPARED BY : NOR AZAH BINTI AZIZ KOLEJ MATRIKULASI TEKNIKAL KEDAH

FIG. 1.4 Deformations produced by the components of internal forces and couples.

AERSP 301 Shear of beams (Open Cross-section)

ME 221Lecture 141 ME 221 Statics Lecture #14 Sections 4.1 – 4.2.

ME 221Lecture 171 ME 221 Statics Lecture #17 Section 4.6.

ME 221Lecture 151 ME 221 Statics Lecture #15 Section 4.3.

Professor Joe Greene CSU, CHICO

Homework #2 Due Date: 25 Feb, Problem #1 If you represent the three forces and the couple by an equivalent system consisting of a force F acting.

CE 230-Engineering Fluid Mechanics Lecture # 6 Basics of Fluid Statics.

Centre of gravity and centroid

ME221Lecture 71 ME 221 Statics Lecture #7 Sections 4.1 – 4.3.

ME 221Lecture 161 ME 221 Statics Lecture #16 Section 4.6.

ME221Lecture 81 ME 221 Statics Lecture #8 Section

ME 221Lecture 141 ME 221 Statics Lecture #14 Section 4.3.

Distributed Forces: Centroids and Centers of Gravity

EQUILIBRIUM OF RIGID BODIES. RIGID BODIES Rigid body—Maintains the relative position of any two particles inside it when subjected to external loads.

Statics (MET 2214) Prof. S. Nasseri Forces and Moments MET 2214.

BENDING MOMENTS AND SHEARING FORCES IN BEAMS

SHEAR AND BENDING MOMENT DIAGRAMS IN HORIZONTAL BEAMS WITH

4.10 Reduction of a Simple Distributed Loading

5.3 Equations of Equilibrium

The center of gravity of a rigid body is the point G where a single force W, called the weight of the body, can be applied to represent the effect of the.

Centroids and Centers of Gravity

Foundation Systems Unit 11. Types of Foundations Pilings Continuous Grade Beam.

Problem y For the machine element shown, locate the z coordinate

9.6 Fluid Pressure According to Pascal’s law, a fluid at rest creates a pressure ρ at a point that is the same in all directions Magnitude of ρ measured.

Theoretical Mechanics STATICS KINEMATICS

Determination of Centroids by Integration

Problem The square gate AB is held in the position shown by hinges along its top edge A and by a shear pin at B. For a depth of water d = 3.5 ft,

Beams - structural members supporting loads at various points along the member. Transverse loadings of beams are classified as concentrated loads or distributed.

Problem a 24 kN 30 kN The beam AB supports two concentrated loads and rests on soil which exerts a linearly distributed upward load as shown. Determine.

3.9 Linear models : boundary-value problems

MEC 0011 Statics Lecture 4 Prof. Sanghee Kim Fall_ 2012.

سایت جامع دانشجویان و مهندسین عمران Footing Design

Problem 5-c The square gate AB is held in the position shown by hinges along its top edge A and by a shear pin at B. For a depth of water d = 3.5 ft,

Bending Deformation.

Distributed Forces: Centroids and Centers of Gravity

Structure II Course Code: ARCH 209 Dr. Aeid A. Abdulrazeg

Force and Moment Vectors

INTERNAL FORCES AND FORCES IN BEAMS

STATICS (ENGINEERING MECHANICS-I)

Chapter No. 04 Equilibrium

REDUCTION OF A SIMPLE DISTRIBUTED LOADING

Equivalent Systems.

Building Construction

Distributed Forces: Centroids and Centers of Gravity

Distributed Forces: Centroids and Centers of Gravity

Chapter Objectives Chapter Outline

Equilibrium Of a Rigid Body.

Engineering Mechanics

Equilibrium Of a Rigid Body.

Problem 5-b a 24 kN 30 kN The beam AB supports two concentrated loads and rests on soil which exerts a linearly distributed upward load as shown. Determine.

Equilibrium Of a Rigid Body.

Internal Forces.

Distributed Forces: Centroids and Centers of Gravity

Engineering Mechanics

Equilibrium Of a Rigid Body.

Static Equilibrium.

Introduction Classification of Beam Supports.

Problem 7.6 Locate the centroid of the plane area shown. y x 20 mm

Centre of Gravity, Centre of Mass & Centroid

Structure II Course Code: ARCH 209 Dr. Aeid A. Abdulrazeg.

Centroid TUTORIAL.

Presentation transcript:

CENTROIDS AND CENTRES OF GRAVITY ME13A: CHAPTER FIVE CENTROIDS AND CENTRES OF GRAVITY

5.2. Centroids of Areas

Examples Solve Examples Using the method of integration to locate Centroids.

Centroids of Composite Objects

Centroids of Composite Objects Contd.

Examples Solve Examples to Illustrate the centroid of Composite Objects.

Examples Solve Examples to illustrate the centroids of beams with distributed Loads.

Assignment 1. The column is used to support the floor which exerts a force of 3000 N on top of the column. The effect of soil pressure along its side is distributed as shown. Replace this loading by an equivalent resultant force and specify where it acts along the column, measured from the base A.

Assignment 2. The wall footing is used to support the column load of 12,000 N. Determine the intensities w1 and w2 of the distributed loading acting on the base of the footing for equilibrium.