Problem 11.7 Find the average power absorbed by the 10- resistor.

Slides:

Advertisements

Similar presentations

Network Theorems (AC Circuits)

Advertisements

Series and Parallel Circuits

Chapter 7 Series-Parallel Circuits. Objectives Analyze series-parallel circuits Analyze loaded voltage dividers Analyze ladder networks Analyze a Wheatstone.

THEVENIN’S THEOREM Thevenin’s theorem permits the reduction of a two-terminal dc network with any number of resistors and sources (Complex Circuit) to.

ECE 201 Circuit Theory I1 Maximum Power Transfer Maximize the power delivered to a resistive load.

Special Diodes. Describe and analyze the function and applications of:  Zener Diodes.

ECE 201 Circuit Theory I1 Source Transformation Convert a Voltage Source in Series with a Resistance into A Current Source in Parallel with the SAME Resistance.

Circuits Series and Parallel. Series Circuits Example: A 6.00 Ω resistor and a 3.00 Ω resistor are connected in series with a 12.0 V battery. Determine.

Superposition, Thevenin / Norton Equivalents, Maximum Power Transfer Circuits 1 Fall 2005 Harding University Jonathan White.

Lecture - 7 Circuit Theorems

Measurement of internal resistance. 1. Connect up circuit shown opposite. 2. Measure the terminal pd (V) with the voltmeter 3. Measure the current drawn.

SEE 1023 Circuit Theory Concept of Equivalence. Circuit A and circuit B are equivalent if they have the same I-V characteristics at their terminals. Circuit.

Power Transfer Superposition Principle. Maximum Power Transfer Choose an RL in order to maximize power delivered to RL.

Welcome to Phase III Understanding & Calculating Parallel Circuits This phase should only be opened if you are finished with Phase II.

Thyristor Converters or Controlled Converters

1 ECE 3144 Lecture 23 Dr. Rose Q. Hu Electrical and Computer Engineering Department Mississippi State University.

Maximum Power Transfer Theorem:

Maximum Power Transfer Theorem

Study Guide Exam 2. Closed book/Closed notes Bring a calculator.

Series and Parallel.  a single resistance that can replace all the resistances in an electrical circuit while maintaining the same current when connected.

Electric Circuit Types Series and Parallel Circuits.

Engineering Science EAB_S_127 Electricity Chapter 3.

ELECTRONICS – Input Transducers Engineering Science – National 5.

Voltage Divider Circuits Input transducers Input transducers are devices that convert a change in physical conditions (for example, temperature) into a.

Work out the power dissipated by the resistor in the following 2 circuits. All LEDs have a forward voltage of 2v Which circuit is the most efficient and.

ET-314 Week 7. Superposition Thevenin and Norton Theorems 0.

1 Eeng 224 Chapter 11 AC Power Analysis Huseyin Bilgekul Eeng224 Circuit Theory II Department of Electrical and Electronic Engineering Eastern Mediterranean.

Techniques of Circuit Analysis

Fall 2001ENGR-201 Maximum Power Transfer 1 Maximum Power Transfer If a load resistor R L is connected to a linear circuit, what value of R L results in.

Example 4.10 Finding the Thevenin equivalent of a circuit with a dependent source.

Introduction Filters are circuits that are capable of passing signals within a band of frequencies while rejecting or blocking signals of frequencies outside.

COMMUNICATION ENG. PROF. A.M.ALLAM

Chapter 11 AC Power Analysis

Bridge Rectifier Electrical Engineering and Industrical Electronics

Electric Circuits (EELE 2312)

Electric Circuits (EELE 2312)

Chapter 11 AC Power Analysis

Techniques of Circuit Analysis

Exercise 1 In Fig. 1, run the analysis, and verify that the overall voltage gain Av=V0/Vs=-25.74, input resistance at VS = 15.44K, output resistance at.

(a) Find the value of average charging current,

Electronic Components

ELECTRIC CIRCUITS EIGHTH EDITION

Dr John Fletcher Rectifiers Dr John Fletcher

The resistance of a thermistor changes from 30k to 12k when the temperature changes from 20C to 70 C Calculate the sensitivity if resistance is taken.

Lecture 08 AC POWER ANALYSIS

a) For the trace, determine

Maximum Power Transfer

Ch. 4B – Circuit Theorems II

Ch. 4B – Circuit Theorems II

Chapter 11 AC Power Analysis

Maximum Power Transfer Theorem

L = L1 + L2 + L3 + 2M12 – 2M23 –2M31 = x6 – 2x6 –2x4 Problem 13.2 Determine the inductance of the three series-connected inductors. Consider.

Smith Chart Parametric Equations

Lesson 12: Analog Signal Conditioning

··,--.,.,. ·.._. ·.., ' t... ' ' ;'I.1!; " ·( '·( ' ·), '+ "."

Diode Circuits.

Electric Circuits RL Circuits

Maximum Power Transfer

Voltage Divider Circuit

Unit 3 Review (Calculator)

Resistance in Series and Parallel

Chapter 11 – Power AC Circuits

Source Transformation

Associate Professor, Dept. of Physics,

Calculate 9 x 81 = x 3 3 x 3 x 3 x 3 3 x 3 x 3 x 3 x 3 x 3 x =

Circuit Theorems.

Associate Professor, Dept. of Physics,

Chapter 11 – Power AC Circuits

Example Example 1: An electric lamp is rated 110 W, 200 V. When the lamp is operated at its rated power and voltage, calculate a) the current flowing through.

Ch. 4 – Circuit Theorems Linearity

Presentation transcript:

Problem 11.7 Find the average power absorbed by the 10- resistor.

Calculate the value of ZL in the circuit in order for ZL to receive maximum average power. What is the maximum average power received by Z? Problem 11.17

The load resistance RL in the circuit is adjusted until it absorbs the maximum average power. Calculate the value of RL and the maximum average power. Problem 11.20

Problem 11.20

Problem 11-57

Problem 11-57

Problem 11.60 For the circuit given, find Vo and the input power factor.

Problem 11-62

Problem 11-74