Test Setup TPS1H100 EVM Supply voltage VS = 13.5V Electronic load

Slides:

Advertisements

Similar presentations

Selected Design Topics. Integrated Circuits Integrated circuit (informally, a chip) is a semiconductor crystal (most often silicon) containing the electronic.

Advertisements

Operational Amplifiers

Electronic memory & logic devices. Solid State Physics N N P P +- Transistors And diodes Logic gates Memory devices : Flip flops Flip Flop Flip Flop Flip.

Precision AC Current Measurement Technique Guildline Instruments Limited.

7.2 The Basic Gain Cell 7.3 The Cascode Amplifier

Switching Power Supply Component Selection

ECE 4951 Lecture 5: PID Control of Processes. PID Control A closed loop (feedback) control system, generally with Single Input-Single Output (SISO) A.

ECE 442 Power Electronics1 Full-Wave Bridge Rectifier.

ECE 442 Power Electronics1 Full-Wave Rectifier with RL Load.

SUB; ANALOG ELECTRONICS PREPARED BY MR.HUTESH BAVISKAR.

Source Transformation

Digital to Analog Converters

1 Electronic Circuits COMMON EMITTER CIRCUITS. 2 Electronic Circuits AMPLIFIERS CAN BE CLASSIFIED AS EITHER: VOLTAGE AMPS POWER AMPS AMPLIFIERS CAN BE.

Low power CDN. SPEED Operate vdd at half rails Data should operate at full rails.

Delivering MORE Together What is SuPA?. SuPA: Supply for Power Amplifier “SuPA” = DC/DC converter that provides an adaptive, optimized output power supply.

9/27/2004EE 42 fall 2004 lecture 121 Lecture #12 Circuit models for Diodes, Power supplies Reading: Malvino chapter 3, Next: 4.10, 5.1, 5.8 Then.

Dc regulated power supply SKN. Introduction All electronic circuits need DC power supply either from battery or power pack units. Many electronic equipment.

4.2.3B Electrical Power What About Watts?. Power Law Moving electrons (current) requires ENERGY How much energy gets used depends on: Strength of push.

Rectification. AC to DC Electricity distribution –Power stations –Transformers –Transmission lines AC Electronics DC –Smooth –Stable.

Tutorial: Mechanic - electrician Topic: Electronics II. Class Operational Amplifiers: Comparators – Part 1 - Basics Prepared by: Ing. Jaroslav Bernkopf.

DAC5688 EVM testing. DAC5688 EVM Equipments 2x Signal Generator with 1GHz output 1x Spectrum analyzer 3x rail power supply with 1.8V, 3.3V, and 5V 4x.

Linear Regulator Fundamentals

Class D Output Power Estimation Audio Group Applications 1.

Preparation of Module Assembly and Stringtest Haridas, Heinz, Marge One possibility for an assembly and test line? Preparation of a full string test –aim.

Jaeger/Blalock 7/26/07 Microelectronic Circuit Design, 3E McGraw-Hill Chapter 14 Single-Transistors Amplifiers Microelectronic Circuit Design Richard C.

SPEED CONTROL OF ( SEDM ) ADOPTING CHOPPER CONVERTER AND PI CONTROLLER

Interfacing to External Devices  Explore Digital Interfaces techniques  Introduce some complex optical devices and how to interface them  Describe methods.

Diode Rectifier Circuits Section 4.5. In this Lecture, we will:  Determine the operation and characteristics of diode rectifier circuits, which is the.

Ohm’s Law. Learning Goals  I will be able to use Ohm’s Law to solve for current, voltage and resistance.

University of Toronto ECE530 Analog Electronics MOS Single Stage Amplifiers # 1 MOS Single-Stage Amplifiers.

Linear Regulator Fundamentals

ELECTRONICS – Input Transducers Engineering Science – National 5.

Voltage Divider Circuits Input transducers Input transducers are devices that convert a change in physical conditions (for example, temperature) into a.

A function generator is usually a piece of electronic test equipment or software used to generate different types of electrical waveforms over a wide.

PSX-R. What is the PSX-R? PSX-R is a separate high quality power supply PSX-R acts like a giant battery PSX-R supplies regulated smooth DC power to the.

Power Supplies (Voltage Regulators)

CHAPTER 10 AC Power Bipolar Junction Transistors: Operation, Circuit Models, and Applications.

UNIT III DC Choppers.

EC-1/ UNIT- 1 RECTIFIERS/ PREMA.S, AP/ECE

Automatic Voltage Regulator

EE 442 POWER ELECTRONICS I Introduction Dr. Said A. Deraz

Chapter 27 Power Supplies.

Voltage and Power.

Automatic Voltage Regulator

Single-phase half-bridge inverter

Development of the DC Electronics for the TAMUTRAP RFQ Cooler/Buncher Louis Cooper Cyclotron Institute Texas A&M University.

Non-ideal Power Supply

Electronics Devices & Circuits

FET Small Signal Analysis ENGI 242 ELEC 222. March 2003FET Small Signal Bias2 g m at Q.

DC Motor and Stepper Controller

بسم الله الرحمن الرحيم اساس عمل الترانزستور اعداد: م/ أحمد المصرى.

Basic Design of PID Controller

PULSE-WIDTH-MODULATED OUTPUT

JC Technology Logic Gates.

MCP Electronics Time resolution, costs

Dr. Unnikrishnan P.C. Professor, EEE

Last time Analysis vs Design General tasks for analysis

Source Transformation

CBE / MET Feb 12.

CBE 491 / Sep 12.

500 nm WRITE VOLTAGE 0 V.

Dr. Unnikrishnan P.C. Professor, EEE

Dr. Unnikrishnan P.C. Professor, EEE

CBE / MET Feb 12.

PLC Front Panel.

FAN5358 2MHz, 500mA, SC70 Synchronous Buck Regulator

Power Electronics Lecture -11 Single Phase Controlled Rectifier.

LED MR16 12V, a Glance Where to Use

Presentation transcript:

Test Setup TPS1H100 EVM Supply voltage VS = 13.5V Electronic load The current limit has an overshoot of around 35% higher than the limit set. The CS has a settling time of around 150uS but not deglitch time. If the output voltage decay slowly the CS signal has smooth transition. If the output voltage has fast transition the CS signal has fast transition and 150uS settling time

Current limit 2A and over current of 2 Current limit 2A and over current of 2.1A The output voltage decay slowly

Current limit 2A and over current of 10A The output voltage decay is very fast