FD supports A.Jeremie

V-plate T-plate

FD configuration (T.Okugi’s presentation) Table=2400 IP=> SBPM QC3 FFTB 2.13 S3.00 SF1FF QF1FF 100 450.1 200 180 SD0FF QD0FF 76.2 785 380 2630 Sweeping Honda Shintake S-band BPM slightly outside table on a “light” Sextupole=> how will the S-band BPM be supported? Does this BPM need to be supported?

We must make the S-band BPM support adopter for SF1 and SD0, because the weight of S-band BPMs are heavy. Example of the BPM support This is not the supports for SF1 and SD0

Compensate the height to reach beam height Quadrupole with shims LVDT to measure magnet position for mover control mover T-plate: same as before to keep same angle: only LVDT holes to be drilled Change the way the mover is fixed on the table

sling table room for bolting beeswax 3 plates

Set-up can be moved in the future 3 steel plates bolted to the floor Honeycomb table Bees wax 3 steel plates bolted to the floor Bees wax: can be unglued, stable in time, good transmission of vibrations