Cal DQM Report July 7 – July 14, 2004

July 8th Updated bad channel list using CAL quick-calib 50632 Created version 3653 with 357 bad channels, 0 holes. 6 bad FEC’s, 3 bad ADC’s

B5 UNO

July 9th Updated bad channels using CAL quick-calib 50644 Version 3654 created with 361 b.c’s and 0 holes Same bad FEC’s & ADC’s Checkout runs done: QINJ 18361 UNO 18362 PED 18363 LASER 18364 LED 18365 Created version 3654 by mistake-didn’t use it

July 9th (cont.) Full Electronic Calibration CALIB version 3656 66 b.c’s, 0 holes Trimming: UNO 18375 59(0) 121(0) 29(0) UNO 18380 44(0) 116(0) 27(0) Created version 3657 with 302 b.c’s and 0 holes 3 FEC’s and 2 ADC’s

July 10 Updated bad channel list with CAL quick-calib 50661 Created version 3658 313 b.c’s 0 holes

July 11 Updated bad channel list with CAL quick-calib 50677 Created version 3659 316 b.c’s 0 holes Called by ZCR at 10:30, the hip presenter shows 12 new b.c’s for QINJ during run 50684 Compare QINJ for 50677 and online QINJ histos, bad channels in R5. I told the ZRC to take a CAL quick-calib, and that I would use it to update the b.c’s

Comparison of R5 for 2 runs

July 12 Updated bad channel list using CAL quick-calib 50687 Unfortunately R5 is not bad anymore… Created version 3660 with 321 b.c’s and 0 holes ZCR calls-1 hour break Run auto_adc2volt.sh Creates adc2volt version 2381, cal verison 3662, with 295 b.c’s, 0 holes

R5 revisited, problem gone

July 12 (cont.) Did checkout runs QINJ 18390 UNO 18391 PED 18392 LASER 18393 LED 18394

July 13 Updated b.c’s using CAL quick-calib 50698, version 3663: 303 b.c’s, 0 holes (done the previous night) Took checkout runs QINJ 18395 UNO 18396 PED 18397 LASER 18398 LED 18399 Break in morning but no call from ZCR, instead they did a CAL quick-calib, so I used it to update the b.c’s, version 3664: 306 b.c’s, 0 holes.

Problems No calls from ZCR! (Except for the R5 thing)

DQM Checked all runs taken during the week, all seemed fine, some weird thing in the pull for BCAL.