High-rise Pack Loading

Slides:

Advertisements

Similar presentations

Hose Pulls Shoulder Load ½. 1)Firefighter receives order for shoulder load 100 of 2 ½ with a desired nozzle and repeats it back to the Captain 2)Firefighter.

Advertisements

How To Pull A Pre-Connect

Jennifer Wolfe NAEA CONVENTION Baltimore, MD 2010.

Expand Media Wall & Podium Case Training Video’s & Instructions.

SOF Tactical Tourniquet Components Windlass Buckle Strap Safety Screw Tri-Rings Windlass Strap.

Arborbrace Tree Staking Systems A Simple, Cost - Effective Means of Tree Guying & Palm Bracing Good for the Trees – Profitable for the Installers and Clients.

Wildland Progressive Hose Packs The Original made NEW !

FIREFIGHTER I LESSON 12A. FIRE HOSE TERMS Expansion-ring gasket Expansion-ring gasket — Gasket used at the end of hose where it is expanded into coupling.

Fitting Instructions REHABILITATOR ™ OA - LP For optimal brace fit, the OA REHABILITATOR™ should be worn against the skin. Any garment worn under the.

The Cleveland Load.

Fitting Instructions REHABILITATOR ™ SPORT For optimal brace fit, the SPORT REHABILITATOR™ should be worn against the skin. Any garment worn under the.

Loading the SAC-METRO pack. Coil the hose with the male coupling to the inside. Using a winding table or a Gnass Hose Winder to simplify this operation.

Place nozzle on hose and fold over about 4 to 6 inches past each end of pack. High-rise Pack Loading.

Ropes and Knots Skill Drills.

Used with FILTERS Copyright © 2013 by The S.E.A. Group.

Preparing a Launch Release Device. Gather the required parts 1 – Appropriate sized balloon 1 – Burner coil 1 – Spool 1 – String with small loop on one.

Getting Wet Stuff to the Red Stuff For 300 Years

Six Parts of the Air Brakes We need to identify the Brake Hose, Brake Chamber, Slack Adjuster, Brake Drum, & Brake Linings.Also where the air compressor.

Closed gloving is performed after the surgeon has donned his/her gown, but BEFORE the surgeon pulls his/her hands through the cuffs of the gown.

State of Georgia BASIC FIRE FIGHTER TRAINING COURSE

Pulling working lines. Step up onto the tailboard. Step up onto the tailboard.

SCBA CLEANING Monthly and after use. Use mild detergent (dish soap) or Confidence Plus mixed at ½ ounce per gallon of water. Use a brush if necessary.

The JTC Claw Sling Kit, Assembly Sling Kit includes: One “Quick Release” Sling 2 – 4” adhesive backed Velcro “Loop Tape” 2 – 7” Double Sided Velcro straps.

Hot Air Balloons Watch Hot Air Balloon construction dvd.

Fire Hose, Nozzles, Streams, and Foam

Job Performance Requirement Modified Gasner Bar Pack.

Part C  Accordion load  Lay the first length of hose in the bed on edge against the partition with the coupling at the rear of the bed  At the front.

Ropes and Knots Skill Drills.

Teardrop Closed CoilTight Coil Shaped Marquise / LeafMarquise / EyePetal Arrow / DartTriangleMoon / Crescent SquareStarOpen Heart Closed Coil The tight.

The Hokie Load Releasing Hitch

HOSE ROLLS Straight roll ◦Lay the hose out straight and flat on a clean surface ◦Roll the male coupling over onto the hose to start the roll ◦Form a coil.

Creating a Little Book Using PowerPoint (Windows XP 2003 or above) By Pete Senske & Joan Olson.

SMFR FF Bailout Refresher 6/15 -Setup and storage -Deployment -Maintenance - Training.

Hand Sewing Buttons and Things.

Bumper Line of Engine/tanker ’ Pre-connect of 1-3/4”. 50’ flat racked with flaps and 50’ rolled. The nozzle is attached to the rolled section.

Job Performance Requirement Horseshoe Load.

 Start with class room and cover terminology with PowerPoint provided. S 190  if you click on picture of fire a short video will play. Please try prior.

The Westampton Rolls How to Pack and Pull the Westampton Rolls Hose Load.

CPS MILITARY SOLO SYSTEM DONNING AND ADJUSTING. TLO Given a CPS Military Solo System and combat equipment prepare the CPS Military Solo System for parachuting.

How to Make Bows Modified by the Georgia Agriculture Education Curriculum Office September 2005.

Tent Pitching 1. Materials needed to pitch a tent: Equipment : Quantity : Remarks : 1 Inner Sheet 1-With door flaps at both ends and wall flaps on both.

Making a Bow. Probably the most difficult skill that a beginning florist or other plant retailer must learn is that of bow making. The process looks simple,

Pinhole Camera.

Copyright © 2016 by The S.E.A. Group

Apache FR Class II Harness

Place template on top as guide for cutting

How to make a flik-flak A step-by-step guide.

Making a Bow Georgia Agricultural Education Curriculum Office

How to tie a tie. How to tie a tie Did you know…? The Eldredge Knot The Trinity knot The Rose knot The Ellie knot The Truelove knot The Merovingian.

Kendrick Extrication Device (KED)

ARISSat-1 Solar Panel Covers

SAM Pelvic Sling II Read the text..

Meeting In A Box Set Up Guide

Fitting Instructions REHABILITATOR™ SPORT. Fitting Instructions REHABILITATOR™ SPORT.

SOF Tactical Tourniquet Components

Equipment Familiarization

Principles of Art Notes Page.

Job Performance Requirement 10-16

Harwich Fire Department

Fire Hose, Nozzles, Streams, and Foam

2. Engage trained observer 3. Disinfect outer gloves

HOW TO MAKE A FROEBEL STAR

Wildland Progressive Hose Packs

1 1/8” 1 1/8” 1 1/8” 3/8 boarder 1 1/8” 1 1/8” 1 1/8”

Job Performance Requirement 10-15

Job Performance Requirement 15-21

Loading the SAC-METRO pack

Job Performance Requirement 10-14

Job Performance Requirement 10-9

The 9 Steps of Shooting ARCHERY.

Presentation transcript:

High-rise Pack Loading Place nozzle on hose and fold over about 4 to 6 inches past each end of pack.

At the half way point, drop down and begin the second tier.

Female coupling should end up toward the brass holder side.

Accordion fold half of hose complement. Drop down and fold the balance. Last section of hose is stacked with female coupling left out.

Cover is pulled into place, on top of pack.

Velcro ring on end straps is placed at corner of pack Belts are secured around pack. Tails secure to Velcro around pack.

Velcro ring on end of straps is placed at corner of pack. Strap is tensioned while holding thumb on strap and using buckle as a jack. Pull strap tight and re-jack if necessary until desired tightness is achieved.

Securing the Gated-Wye The Gated-wye can be pre-connected. Secured by passing one of the black webs loops through the wye then through the other black web. Anchor with the yellow web-Velcro.

The wye can be secured to the pack by itself. Passing the black webs through the wye and then securing with the yellow web-Velcro. To release, rip away the Velcro and pull the Wye loose.