Schematic Presentation

Slides:

Advertisements

Similar presentations

Lecture 2 Review Passive Sign Convention Power Generation, Absorption Power Sources Resistance Related educational modules: –Sections 1.1, 1.2, 1.3.

Advertisements

10 Ways to Ruin Your Mini-Max microcontroller (and lose $69)

Lecture Ten Physics 100 Fall 2012  Series and Parallel Circuits.

EE580 – Solar Cells Todd J. Kaiser Lecture 07 EE Fundamentals 1Montana State University: Solar Cells Lecture 7: EE Fundamentals.

I Q The electric current, I, is the rate of flow of charge Q through a given area in a given amount of time in an electric conductor. Units: Coulomb/second.

P07301 Summary Data Acquisition Module. Team Members.

PWM (Pulse Width Modulation)

Circuits Series and Parallel. Series Circuits Example: A 6.00 Ω resistor and a 3.00 Ω resistor are connected in series with a 12.0 V battery. Determine.

Electricity refers to the presence of electric current in wires, motors, light bulbs, and other devices. Electricity carries power. Power (P)

January Electrical Potential Energy Just as masses can have gravitational potential energy, charges can have electrical potential energy E Electrical.

Use Ohm’s Law to solve the following equations.

1 Electronic Circuits VOLTAGE REGULATION. 2 Electronic Circuits THE ZENER REGULATOR;

January Electrical Potential Energy Just as masses can have gravitational potential energy, charges can have electrical potential energy E.

Ch4 Electronic Components Circuit/Schematic Symbols.

Welcome to Physics Jeopardy Chapter 18 Final Jeopardy Question Equivalent Resistance 100 Complex circuits Misc Parallel.

Introduction to Engineering Lab 4 – 1 Basic Data Systems & Circuit Prototyping Agenda REVIEW OF LAB 3 RESULTS DEFINE a DATA SYSTEM  MAJOR TYPES  ELEMENTS.

Fall CS-EE 480 Lillevik480f04-l1 University of Portland School of Engineering Project Swift Fox Design Review 21 Jan 2005 Peter Brunke Andrew Robinson.

PCB Presentation Group 6 – String Us Up! Matthew Barton Clifford Risley Patrick Nice Seth “Schematic” George.

(c) P.Hsu 2007 SJSU ENGR 10 Electrical Power Sources Prof. Ping Hsu.

x 10,000 5, M Time (min) y t.

EDGE ROUGH DUTY UPS Rough Duty UPS. Power Quality Problems on Rigs Critical Federal Signal loads require clean, regulated, uninterrupted power to operate.Critical.

Aarthi Balachander Daniel Jiang Drew Schuster Ryne Rayburn.

Unit 5 Packet Answers Notes.

Electronic Components Circuit/Schematic Symbols. RESISTOR Resistors restrict the flow of electric current, for example a resistor is placed in series.

603 A DIGITAL PROGRAMMABLE ROBOT OVERVIEW: BASED ON CONCEPT OF PLC. IS PROGRAMMABLE USING A KEYPAD. POWERED BY A 9 VOLT BATTERY. INSTRUCTIONS CAN BE PROGRAMMED.

Electric Circuits. Potential Electric Potential is just like gravitational potential It depends on –The distance from the source –The amount of charge.

2 But what makes the electrons flow? Any electrical circuit requires three things 1.A source 2.A load 3.A means of transmission A definition of a current.

Bully Blue Lock Midterm Presentation 2014 Senior Design II.

Adding SubtractingMultiplyingDividingMiscellaneous.

U3e-L8 1.What does the following schematic symbol represent? 2.What does the following schematic symbol represent? 3.How many volts are typical in a residential.

Objective: 1.You will build a simple circuit - two transistor audio oscillator that will generate an audio tone in a speaker.

U3e-L3 1.Why are the + and – symbols unnecessary when drawing the power source in an electric schematic? 2.A ______ circuit occurs when the positive terminal.

CELLS IN SERIES AND PARALLEL Lesson 9. Cells in Series  The electric potential given to a single electron by a dry cell has an average voltage of around.

Ethical and Environmental Impact Analysis Presentation Group 6 – String Us Up! Matthew Barton Clifford Risley Patrick Nice Seth George.

Virtual Ground Introduction  A virtual ground is no more than a voltage divider where the divided network is the ground and the outer.

TE Module Electric Control Sys. Fan  Control System is largely dependent upon nominal voltage output of TE  Purpose: Provide steady, constant electric.

Team 6. Guitar Audio Amplifier Audio Codec DSP Wireless Adapter Motor Array PC LCD Display LED Arrays Pushbutton or RPG Input Device

DIGITAL SHOWER CONTROLLER BY NATHAN GARNER KASUN KUMARAGE.

+ Electric Circuits Series Circuits. + A Battery and a Bulb A flashlight consists of a reflector cap, a light bulb, batteries, and a barrel-shaped housing.

Introduction to Linear Voltage Regulators Krishna Kishore Reddy K 2010H223084H.

Chapter 22 Electric Current. The Electric Battery A battery transforms chemical energy into electrical energy. Chemical reactions within the cell create.

Ohm’s Law Aim: How does voltage and resistance affect current flow?

Determining Equivalent Resistance

WARM UP Draw a picture of a SERIES Circuit. Show a battery, a switch, and a light bulb in your drawing. Draw a picture of a PARALLEL Circuit. Show a battery,

WIRELESS POWER TRANSFER

WIRELESS POWER TRANSFER

Autonomous Rescue Vehicle (Team 10)

Cordless Electric Nailer

ECE477 Midterm Design Review: Team #8

Analog to Digital Converter

U3e-L3 February 25, 2010 DRILL Why are the + and – symbols unnecessary when drawing the power source in an electric schematic? A ______ circuit occurs.

Introduction to Linear Voltage Regulators

BUILDING CIRCUITS: Schematics.

Circuits & Voltage.

Electrical Circuits.

Team 70: Air Guitar Gloves

Reliability & Safety Analysis

Design Topics IC Applications Amplifier Signal Generator

Series and Parallel Circuits

#3 How to Read the Schematic

Series Circuit.

Adding with 9’s.

Adding with 10’s.

Chapter Twenty One: Electrical Systems

Adding ____ + 10.

Solder two wires as shown to bridge the cuts in the trace

Voltage Regulator Board

Presentation transcript:

Schematic Presentation Group 6 – String Us Up! Matthew Barton Clifford Risley Patrick Nice Seth “Schematic” George

Hardware dsPIC128FJ256GP CS4202-JQZ Audio Codec Parani ESD 100 Bluetooth Module

Power Supply Voltage Requirements Power Supply 5 Volts for A/D Logic 3.3 Volts for Digital Logic 4-6 Volts for Motors Power Supply 9 Volt battery ‘LM7805’ & ‘LM7833’ Regulators for extremely clean 5 and 3.3 Volts ‘78M06’ (Hell-A-Beefy) Regulator for Motor Control Maintains constant power to motors regardless of slight battery voltage drop as the battery depletes

To Motors To Digital Logic +5V to A/D