Examples of IMS 13 for VoLTE course flows MOBILE TELEPHONY EVOLUTION 1/3/2019 Examples of IMS 13 for VoLTE course flows Step 1: Basic Introduction Step 3: Platforms Step 4: Surveillance & Operation and Configuration Interworking Nodes IMS 13 Overview LZU108xxxx * Depends on the network configuration. This course may replace the IS MGW course as well as complement the SBG course. MRS includes functionalities like MGC, BGF, MRFP and ATGW. SBG 13 Operation and Configuration for IMS LZU108xxxx IS 3.1 Overview LZU1087566 IS 3.1 Operation and Configuration LZU1087567 MRS 13 Operation and Configuration* LZU108xxxx VoLTE using MMTel LZU1087966 Additional Prerequisites for Step 4 training: IP Networking, LZU102397 IP Quality of Service and MPLS, LZU1087716 IP Security, LZU1087717 Voice and Video over IP, LZU1087718 MGC 13 Operation and Configuration LZU108xxxx IS MGW 12 Operation and Configuration LZU1088748 IMS Core Nodes CUDB Operation and Service Configuration** LZU1088507 UDC Overview** LZU1088506 IMS Operation and Maintenance Advanced LZU1087209 IP Works 12 Operation and Maintenance for IMS LZU1088751 ** Only required if Data Layered Architecture is applied (HSS-FE + CUDB) EPC HSS 13 Operation and Configuration *** LZU108xxxx TSP 6 Operation and Maintenance LZU1087341 TSP 6 Overview LZU1087339 SAPC Operation and Configuration LZU1089013 IMS Signaling LZU1087193 Step 2: Technical Overview *** Recommended as a part of IMS VoLTE training program if IMS and EPC HSSs are co-located. Covered by Packet Core training program otherwise. CSCF 13 HSS/SLF 13 Operation and Configuration LZU108xxxx Application Servers MMTel 13 Provisioning LZU108xxxx MTAS 13 Operation and Configuration LZU108xxxx Associated Training Programs Prerequisite Optional preparation Mobile Soft Switch (MSS) 13A Training Program Packet Core 2012 Training Program © Ericsson AB 2012