Schematic to Pictorial G3b LINE VOLTAGE Schematic to Pictorial

You will now draw the Pictorial by following the Schematic

The process will be to follow the schematic one wire at a time from one component to another component until you are finished.

The slides that follow will show the wire in RED on the schematic that is going to be wired on the pictorial. Then the pictorial slide will show that wire being ‘installed.’ This is the wire you are to place on your pictorial. Keep advancing through this slide presentation until you are finished with the pictorial.

G3a states that there is NO schematic. But in fact, there is G3a states that there is NO schematic. But in fact, there is. The schematic(s) you will use are the schematics found on pages G1, G2 and G15 for help.

The key to this schematic is to recognize that there is a two speed fan motor and the relay is a SPDT. You may need to refer back to the G15 Power Point Presentation as a refresher on how a 2-spd fan motor and SPDT relay are wired.

Let’s start with the circuit for the indoor section, and then move onto the outdoor section. Please advance to the next slide to get started.

Remember, the FR is SPDT, so POWER MUST be supplied to the single pole BEFORE going to the motor or FS.

Let’s move onto the outdoor section. Please advance to the next slide to get started.

You have finished the LINE VOLTAGE circuit.

The next slide shows your completed PICTORIAL and this is what you need to show your Instructor for credit.

THE END