Multi-Piece Rim Assembly Component Matching

Slides:



Advertisements
Similar presentations
Basic safety rules and procedures for controlling hazardous energy
Advertisements

IS-700.A: National Incident Management System, An Introduction
General Rules Compressed gases and cylinders must be properly stored, transported and used to prevent injury and accidents. Compressed gases and cylinders.
1 ENGINEER EQUIPMENT INSTRUCTION COMPANY MULTI-PIECE RIM.
Heavy Equipment  Addressed under 1926 Subpart O: Heavy Equipment  All equipment left unattended at night, adjacent to a highway in normal use, or adjacent.
OSHA Office of Training and Education
Tire Servicing Program. Agenda WorkSafeBC Requirements Definitions Responsibilities General safety.
3.6.2 Student Book © 2004 Propane Education & Research CouncilPage 1 Many propane marketers receive railcar bulk propane shipments. Well-trained personnel.
UNDERSTANDING THE REQUIREMENTS OF ```````‘s HAZCOM12 What’s changing and how to ensure compliance.
Electrocution 44% Rigging Failure 15% Load Handling 14% Operator Error 7% Overload 7% Dismantling Boom 5% Wire Rope Failure 3% Miscellaneous 3% Struck.
1 Cranes Module 13. 2Objectives After this module you should be able to – identify the most common crane hazards – take the necessary steps to avoid those.
Presented By: SINGLE OFFSET INSTALLING RUBBER GASKETS FOR WATERTIGHT JOINTS O-RING PROFILES.
This presentation is for illustrative and general educational purposes only and is not intended to substitute for the official MSHA Investigation Report.
Vibration Technical Bulletin. Table of Contents Appearance Inspector Stamp.
/0503 Copyright ©2005 Business and Legal Reports, Inc. BLR’s Safety Training Presentations Hazardous Materials Transportation 49 CFR BLR’s.
Fall Hazards.
Most Frequently Cited Serious Violations Construction – FY 2011 OSHA Federal Standards October 1, 2010 – September 30, 2011.
IS-700.A: National Incident Management System, An Introduction
Office of Highway Safety Oversight of Construction Projects George Black.
Conducting Safety Inspection Audits in the Workplace Laura Smith Industrial Safety Consultant Specialist Mansfield Service Office (P) (E)
Electrical Safety.
1a.  Exposed part  Live or energized part  De-energized part 1a.
Most Frequently Cited Serious Violations Construction – FY 2009 OSHA Federal Standards October 1, 2008 – September 30, 2009.
Visual 2.1 ICS Fundamentals Review Unit 2: ICS Fundamentals Review.
IPC Thermal Transfer Components, which for thermal reasons require extensive surface contact with the board or with a heatsink mounted on the.
Proper Use of Extension Cords
Uintah School District Hazardous Materials / MSDS Training
LTI 011 Crushed Finger 13/May/2001 Crew were removing earth from bund wall area using a large metal skip. Position of skip had to be changed to help filling.
Name _____________________________________________ Week of__________________ Find the matching stamp and stamp your letter in the box.
MA1603 – Clean Harbors Environmental Service MA1604 – Veolia ES Technical Solutions.
Biron Mill Contractor Emergency - Take Shelter/Evacuation.
Haul Frames and Corners to the Jobsite Evaluate the Condition of the Jobsite HAZARDS TO WATCH FOR : Overhead Electrical / Power Lines, Weather Conditions,
Workshop on Permanent Closure of Single-Walled USTs and Funding Opportunities For Closure and Cleanup.
Sling Safety (Level 1 Rigger). Objectives Be familiar with regulations regarding slings. Be familiar with regulations regarding slings. Understand safe.
Labrador City Dec 2013 Identifying and Controlling the Hazards Above.
Illness & Injury Prevention Program (IIPP) The Town of Los Gatos’ Updated Illness & Injury Prevention Program (IIPP) A Roadmap to a Safer Organization.
Maintenance and Temporary Traffic Control
Warehousing and Storage Principles Session 11 – Health, Safety and Legislation Day 6 / AM.
Inspection of Launcher and Cartridge, 84mm HE M136 (AT4)
Level 1 Diploma in Electrical Installation © 2014 City and Guilds of London Institute. All rights reserved. 1 of 7 PowerPoint presentation Supporting information.
Problem Statement Supplier attempted to respond to issue with weak countermeasure report.
Contact Us.
Fall Protection for Construction
Most Frequently Cited Serious Violations
Lifting & Rigging Continuing Education Fourth Quarter 2016
OSHA Most Frequently Cited Serious Violations
Fall Hazards.
How To Add A Xerox Printer To Google Chrome
Frio River Cabins - Frio Vacation Homes - Frio Country Resort
Hand and Finger Injuries
Website: Contact No: ID:

Most Frequently Cited Serious Violations
Personal Protective Equipment
Electrical Safety.
Multi-Piece Rim Assembly Component Matching
Fall Hazards.
LOTO(V) Procedures MESH Process Safety, 8.7 Energy Control
Control of Knife and Hand Cutting Tools
Your Safety is our #1 Concern
Multi-Piece Rim Assembly Component Matching
Click anywhere to get started…
THE INTERNAL RESPONSIBILITY SYSTEM
Cranes and Hoists Standard 29 CFR Part
Firebase Vs. MongoDB: Choose the Best Database of 2019
Fall Hazards.
Meet Us
Contact Us
Presentation transcript:

Multi-Piece Rim Assembly Component Matching

DOT Identifications Found on weather side of each component Stamped into components Visually inspect each component to identify markings Ensure component compatibility using markings found on components & OSHA wall chart

Example of Markings I.D. Stampings

OSHA Wall Chart

Mismatched Components Identified Evacuate trajectory zones - do not handle assembly Immediately report to supervisor

Trajectory Zones

Supervisor Actions Ensure trajectory zones are evacuated Barricade effected areas Install temporary barriers Contact tire specialist to mitigate & remove hazard

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2025 SlidePlayer.com. Inc. All rights reserved.