MMS / MBT / 04 – 160 Typical wire diameter from 0.20 to 2.00 mm copper wire. Electric connection by inserting 2 IDCs (after winding) or welding Stack height from 25 to 125 mm or more On the following page you will find the detailed operations of one machine and its layout

Manual coilformer loading and unloading MMS / MBT / 04 – 160 The machine is based on the Sipro multishuttle transport system® with rotating spindles and independent IDC insertion Winding Manual coilformer loading and unloading

MMS / MBT / 04 – 160 Manual parts loading and unloading Tool design keeps these operations and specification change over simple

MMS / MBT / 04 – 160 Winding 4 spindle heavy duty tag wrapping winding machine Coilformer transfer via shuttle Programmable tensioners

MMS / MBT / 04 – 160 IDC insertion Bandoleer support Stepping mechanism Insertion device Automatic stack height tolerance compensation

S/TBF/2 Specialized in pole chains flyer winding head for 2 motors wound in parallel using programmable tensioners modular design to suit higher production rates with additional winding heads tool transfer to allow fully automatic motor assembly and wire connection and easy change over phase 1 phase 2 phase 3 phase 1

S/TBF/2 Parts are fed and removed with their winding tool programmable shuttle transfer between the loading station and the winding unit

S/TBF/2 The winding process is fully automatic and uses 4 programmable axes, wire holding clamps and pneumatic cutters for the winding start and finish. Also the wire tension can be changed in any point of the winding in order to optimize the final result.

Production line Plastic hinges Cutting Winding 36 Stations S/TBF/2 1 milion motors per Year. Plastic hinges Cutting Winding 36 Stations S/TBF/2 Taper Control Faston Insertion Quality Vison Controls

interpolating Path Winder iPW interpolating Path Winder

interpolating Path Winder iPW interpolating Path Winder Motor geometries represent a challenging task for winding machine designers. Sipro has faced this challenge with a machine suitable for different motor designs just by changing its configuration to use a different winding technique: A) segmented stators (single or pole chains) B) inner or outer slot stators

interpolating Path Winder iPW 02- HP interpolating Path Winder High Power High speed Z-axis winding Tilting of wire-guide tubes Tooling X-axis for layering Tooling Y-axis for wrapping Tooling J-rot for tilting Tooling W-rot for z rotation Heavy Duty Applications

interpolating Path Winder iPW 02- FW interpolating Path Winder Flat Wire The coil turns around the wire. Centre of rotation with controlled shifting Flat Wire Applications

SIPRO SRL - Via priv. G. Natta 3, 20030 Lentate sul Seveso - MI (Italia) - Tel +39 0362 542252 - Fax +39 0362 542424 – www.siprosrl.com