Common-Collector Amplifier

Slides:



Advertisements
Similar presentations
Lecture 4 Operational Amplifiers—Non-ideal behavior
Advertisements

Operational Amplifier
Operational Amplifiers
MULTISTAGE AMPLIFIERS
Common-Collector Amplifier Section Topics Emitter Follower as a power amplifier Push and Pull Output Stage.
Common Emitter Amplifier. Design Rules V RE should be > 100 mV.
Op-Amp- An active circuit element designed to perform mathematical operations of addition, subtraction, multiplication, division, differentiation and.
ENTC 4350 HOMEWORK SET 3 Chapter 5.
Transformer Coupling.
RF Amplifier Analysis and Design Critical Specifications:  Input impedance: Z in  Load Impedance: Z L  Frequency of operation (upper and lower 3 dB.
BJT Differential Pair Transistors Q1, Q2 are matched
Class A Operating Mode Time I out One device conducts for the whole of the a.c. cycle. Conduction angle = 360 .
Radio Frequency Amplifiers In this section of the course: Why do common emitter amplifiers often have a disappointingly low upper cut-off frequency ? Where.
Chapter 2 Problems ECET 214 Prof. Park NJIT.
1 Electronic Circuits COMMON EMITTER CIRCUITS. 2 Electronic Circuits AMPLIFIERS CAN BE CLASSIFIED AS EITHER: VOLTAGE AMPS POWER AMPS AMPLIFIERS CAN BE.
 The output from a single amplifier is generally insufficient to drive an output device. In other words, the gain of a single amplifier is inadequate.
SPP FIELDS Preamp Power Requirements 01DEC2012 D. Seitz.
If V in is 1.6 V, what is V out for the emitter follower stage below? R E = 1 kΩ, R C = 3 kΩ, h FE = 200 A)1 V B)0 V C)14 V D)0.6 V E) 3 V.
© 2012 Pearson Education. Upper Saddle River, NJ, All rights reserved. Electronic Devices, 9th edition Thomas L. Floyd Electronic Devices Ninth.
© 2013 The McGraw-Hill Companies, Inc. All rights reserved. McGraw-Hill 9-1 Electronics Principles & Applications Eighth Edition Chapter 9 Operational.
Electronics Principles & Applications Fifth Edition Chapter 9 Operational Amplifiers ©1999 Glencoe/McGraw-Hill Charles A. Schuler.
St Columba’s High School Electricity and Electronics Op-amps.
ECE 342 – Jose Schutt-Aine 1 ECE 342 Solid-State Devices & Circuits 18. Operational Amplifiers Jose E. Schutt-Aine Electrical & Computer Engineering University.
1 Electronic Circuits MULTI STAGE AMPLIFIERS. 2 Electronic Circuits There are several different multi-stage amp circuits that function as dc-amps. 1)COMPLIMENTARY.
Push Pull Amplifiers ET5. Emitter Followers We have seen Emitter Followers being used with Voltage Followers to give us a good balance between Power Transfer.
Output stages & Chapter 8.
1 Op-Amp Imperfections in The Linear Range of Operations Gain and Bandwidth Limitations  Ideal op amps have infinite open-loop gain magnitude (A oL is.
Basic Electronics Ninth Edition Basic Electronics Ninth Edition ©2002 The McGraw-Hill Companies Grob Schultz.
Trey Morris Dwalyn Morgan. Requirements 3 stage design gain load impedance input impedance max peak input voltage Maintain harmonic distortions below.
Midterm 2 performance Full points is 48. Average is
Second part is the oscillator itself. Hardware circuit that converts a DC signal to an AC signal. Frequency of the oscillator.
Common-Collector Amplifier Section A note about Human Ear Human can hear between 12 Hz and 20 KHz. The range begins to shrink at the age of.
Audio Systems. Introduction Audio systems are designed to give an output frequency within the audible range for a human being (20 Hz to 20KHz). Below.
Ref:080114HKNOperational Amplifier1 Op-Amp Properties (1)Infinite Open Loop gain -The gain without feedback -Equal to differential gain -Zero common-mode.
ET5 June 2007 model answers. A.B A + C S 6 ( 1 0 0) and S 7 ( 1 0 1)
LARGE SIGNAL AMPLIFIERS CLASS A , B AND C POWER AMPLIFIERS
Chapter 8: FET Amplifiers
PUSAT PENGAJIAN KEJURUTERAAN KOMPUTER & PERHUBUNGAN
Power amplifiers EL= IxRL
Quiz: Determining a SAR ADC’s Linear Range when using Instrumentation Amplifiers TIPL 4102 TI Precision Labs – ADC Hello, and welcome to the TI Precision.
Each D type is initiated simultaneously by means of a common clock line.
Operational Amplifier
I/O CARD DL 444 MIDAS NAME MODEL 제조사
Lets Design an LNA! Anurag Nigam.
Electronic Devices Ninth Edition Floyd Chapter 12.
The open loop gain of this op-amp is 105 and the bandwidth is 10 Hz
Chapter 12 Power Amplifiers
DMT 231/3 Electronic II Power Amplifiers Class C
Bipolar Junction Transistor
FET Amplifiers.
POWER AMPLIFIER Concept of Power Amplifier Power BJTs Power MOSFETs
Principles & Applications Operational Amplifiers
DIGITAL POWER AMP Xib4 [LINEA RESEARCH]
DA-275 Features Models Available Product Specifications
ac Load Line Analysis Maximum Symmetrical Swing
Electronic Circuit-II
POWER AMPLIFIERS.
Difference Between Voltage Amplifier and Power Amplifier
Amplifiers Classes Electronics-II
Amplifiers Classes Electronics-II
Classification of power amplifiers
Chapter 8: FET Amplifiers
Introduction to Small Signal Model
Department of CNET Electronic Circuit II
Department of CNET Electronic Circuit II
Electronic Circuit-II
10k 20k Vin Vout H3 What is the gain?
MALVINO Electronic PRINCIPLES SIXTH EDITION.
Common-Collector Amplifier
CHAPTER 60 SINGLE TRANSISTOR AMPLIFIERS
Presentation transcript:

Common-Collector Amplifier Section 13.1-13.4

A note about Human Ear Human can hear between 12 Hz and 20 KHz. The range begins to shrink at the age of 8 with high frequency fading.

Vs,pp=100 mV, Freq=1 KHz VB1/VS Matlab 0.7304 ADS 0.73 Measurement 0.734

Vs,pp=100 mV, Freq=1 KHz mV VB2/VS Matlab -13.963 ADS -14.9 Measurement -14

Vs,pp=100 mV Slight mismatch Bias current of Q2=13 mA 13 mA x 8 Ohms=104 mV

Apply a small Signal (Vpp=30 mV) VB1/VS Matlab --11.17 ADS -8.266 Measurement -8

Increase the Input Frequency Vout/Vs 1 K -8 1 MHz -7.21 2 MHz -5.26 3 MHz -4.32 3dB BW=1.9 MHz

Typical Audio Signal Limited output Swing

Audio Plug

Power Dissipation of Q1 Assumption: The instantaneous power dissipated by Q1:ICVCE Average Power

Power Dissipation of the Current Source

Efficiency

Efficiency of Emitter Follower Pdiss of Q1: Pdiss of I1: Total power wasted in Q1 and I1: Output power:

Improved Push-Pull Stage

DC Bias

Voltage Gain

Output Impedance