Review of Dynamics.

Slides:



Advertisements
Similar presentations
Physics 111: Mechanics Lecture 5
Advertisements

Review Chap. 5 Applying Newton’s laws
Laws of Motion Review.
T101Q7. A spring is compressed a distance of h = 9.80 cm from its relaxed position and a 2.00 kg block is put on top of it (Figure 3). What is the maximum.
Centripetal Acceleration 13 Examples with full solutions.
Newton’s Laws of Motion
Unit 2 1D Vectors & Newton’s Laws of Motion. A. Vectors and Scalars.
Newton’s Laws of Motion
Centripetal Force and Acceleration
Chapter 4 Dynamics: Newton’s Laws of Motion
AP Physics C I.B Newton’s Laws of Motion. The “natural state” of an object.
Copyright © 2009 Pearson Education, Inc. Chapter 5 Using Newton’s Laws: Friction, Circular Motion, Drag Forces.
Bellwork Pick up a free-body diagram sheet and begin working on it.
Unit 2 1D Vectors & Newton’s Laws of Motion. A. Vectors and Scalars.
Circular Motion and Gravitation
Chapters 5, 6 Force and Motion. Newtonian mechanics Describes motion and interaction of objects Applicable for speeds much slower than the speed of light.
AP Physics C I.B Newton’s Laws of Motion. Note: the net force is the sum of the forces acting on an object, as well as ma.
Uniform Circular Motion Physics 12. Uniform Circular Motion object is moving at a constant speed but changing directions acceleration occurs due to direction.
Chapters 5, 6 Force and Laws of Motion. Newtonian mechanics Describes motion and interaction of objects Applicable for speeds much slower than the speed.
Thursday, June 7, 2007PHYS , Summer 2007 Dr. Jaehoon Yu 1 PHYS 1443 – Section 001 Lecture #7 Thursday, June 7, 2007 Dr. Jaehoon Yu Application.
Chapter 4 Dynamics: Aim: How can we describe Newton’s Laws of Motion? © 2014 Pearson Education, Inc.
Forces and Motion Chapter 5 and 6. Focus  Force: a push or a pull  Acts on objects to change its velocity.
Weight = mass x acceleration due to gravity
Physics and Forces Dynamics Newton’s Laws of Motion  Newton's laws are only valid in inertial reference frames:  This excludes rotating and accelerating.
Newton’s Laws.
NEWTON'S LAWS OF MOTION Philosophiae Naturalis Principia Mathematica (1686)
Chapter 4 Forces and Newton’s Laws of Motion. Newtonian mechanics Describes motion and interaction of objects Applicable for speeds much slower than the.
Forces and Newton’s Laws of Motion
Uniform Circular Motion
C H A P T E R 6 Dynamics of Uniform Circular Motion
Applications of Newton’s Laws of Motion
Centripetal Acceleration
Physics 2 – April 20, 2017 P3 Challenge – A kg block with an initial speed of 3.5 m/s is sliding on a level surface with a kinetic coefficient of.
PHYS 1441 – Section 002 Lecture #11
Friction.
Instructor: Dr. Tatiana Erukhimova
Force and Newton’s Laws
Forces & Laws of Motion Ch 4 Physics.
Forces and Newton’s Laws
Forces and Free Body Diagram Notes
Vertical Circular Motion
Aim: How do we explain centripetal motion?
PHYS 1441 – Section 002 Lecture #11
FORCES.
Newton’s Second Law 1.
APC -Unit 2.
More Centripetal Force Problems
What causes UCM?.
Still talking about things with constant velocities
Newton’s Laws of Motion Chapters 2,3,6,7
PHYS 1443 – Section 003 Lecture #9
Figure 6.1  Overhead view of a ball moving in a circular path in a horizontal plane. A force Fr directed toward the center of the circle keeps the ball.
Newton’s Second Law 1.
Vertical Circular Motion
Example Problems for Newton’s Second Law Answers
Gravitation.
Gravitational & Rotational Forces
Introduction to Forces
Force Problems.
Uniform Circular Motion
What do we want to do today?! Thursday:
Forces and Free Body Diagram Notes
Three masses are connected by light strings as shown in the figure
Three masses are connected by light strings as shown in the figure
Textbook: 5.5 Homework: WS - Friction
Coverage of the 1st Long test
Introduction to Forces
The study of why objects move.
Circular Motion.
Presentation transcript:

Review of Dynamics

Forces and FBDs A force (F) is a push or a pull, it is a vector quantity Units are N = 1 kg•m/s2 Ex. Tension, Gravity, Normal Force … A Free Body Diagram (FBD) is a diagram of a single object that shows all the forces acting on the object The vector sum of the force is called the net force (Fnet) Ex. Pg. 73 #4 Ex. Pg. 75 #9 Net force equals sum of all forces

Name of forces Fg = force of gravity Fa = applied force Fk = force of kinetic friction Fs = force of static friction T = force of tension FN = normal force

Drawing FBDs Ex 1. Draw a FBD of a car speeding up Ex 2. Draw a FBD of a skateboarder coasting to a stop Ex 3. Draw a FBD of a plane taking off from a runway Ex 4. Draw a FBD of a person falling at their terminal velocity

Practice Problems Ex. Determine the net force: 15 N 21 N 1 N 4 N 8 N 40º

2D Forces & Applications of Newton’s Laws Warm up: pg. 92 #6 Textbook: 2.2 & 2.3 Homework: WS – 2D Forces Pg. 87 # 3, 4, 6, 8 Pg. 92 - 93 # 5, 9 Pg. 95 # 3 – 5

Simple Machines (Pulleys) A pulley is a simple machine that changes the direction of the force A pulley system is a group of pulleys working together to provide a mechanical advantage EX. Two identical bags of gumballs, each of mass 0.200 kg, are suspended as shown below. Determine the reading on the spring scale. Pg. 80 #1, 2 Pg. 83 #13 Pg. 86 #20

Ex 1. A 6. 0 kg mass is attached to a 8 Ex 1. A 6.0 kg mass is attached to a 8.0 kg mass over a frictionless pulley. Determine the acceleration of the masses, and the tension in the string.

The Normal Force The normal force (FN) is the reaction force provided by a surface to resist an object moving through it A scale does not measure Fg! It measures FN, also called your apparent weight

Ex. A 0. 22 kg mice stands on a scale in an elevator Ex. A 0.22 kg mice stands on a scale in an elevator. What does the scale read when: The elevator is at rest/constant velocity? Accelerating up at 2.0 m/s2? The elevator cable breaks?

Review Friction: Friction is a force that opposes motion Friction is caused by microscopic imperfections in surfaces moving across each other Friction depends on: The Surfaces (Ff  ) How much surfaces are pressed together (FfFN) Ff = Fn

Kinds of Friction Static friction is the frictional force that must be overcome to start something moving Fsf = sFn Kinetic friction is the frictional force that must be overcome to keep an object moving Fkf = kFn In general s > k

Ex 1. A traveler pulls a suitcase of mass 8 Ex 1. A traveler pulls a suitcase of mass 8.00 kg across a level surface by pulling on the handle 20.0 N at an angle of 50.0° relative to horizontal.  Friction against the suitcase can be modeled by μk = 0.100.  (a) Determine the acceleration of the suitcase.  (b) What amount of force applied at the same angle would be needed to keep the suitcase moving at constant velocity? 

Textbook: 4.5 Homework: WS pg. 206 #2 - 5 Hooke’s Law Textbook: 4.5 Homework: WS pg. 206 #2 - 5

Hooke’s Law

Hooke’s Law Robert Hooke (1635 – 1703) published his law in 1678. An ideal spring exerts a force (restoring force) proportional to distance the spring is moved from equilibrium FS = kx k is the spring constant (N/m) x is the stretched/compressed distance from equilibrium (m) Pg. 219 #6 Pg. 219 #5 Pg. 219 #7

Pg 219 # 6. What magnitude of force will stretch a spring of force constant 78 N/m by 2.3 cm from equilibrium? # 5. A student of mass 62 kg stands on an upholstered chair containing springs, each of force constant 2.4 x 103 N/m. If the student is supported equally by six springs, what is the compression of each spring?

Inclined Planes - Ramps Warm up: pg. 92 #6 Textbook: 2.2 & 2.3

Ramps A ramp is a simple machine. It reduces the apparent weight of an object, providing a mechanical advantage. Ex. Draw a FBD for an object on a ramp.

Ex 1. Determine the acceleration of the block as it’s sliding down a frictionless ramp. 3 kg 30º

Ex 2. Determine the acceleration of the blocks 2 kg 25º 4 kg Uk = 0.1

Ex 3. A rollercoaster ride is shown in the diagram below Ex 3. A rollercoaster ride is shown in the diagram below.  The mass of the car and rider is 700.0 kg and the coefficient of friction is 0.0500.  (a) Determine the force that must be applied to the car as it is pulled up the hill at a constant speed of 1.00 m/s.  (b) The car is released at point A with speed 1.00 m/s. Find the speed at point B.

Inertial/Non-inertial Frame of Reference & Uniform Circular Motion Textbook: 2.5 & 3.1

Frame of reference: The point of view from which we observe motion It is the stationary “platform” from which we measure all other motion Inertial frame of reference: Where Newton’s first law applies Non-inertial frame of reference: Where Newton’s first law doesn’t apply

Uniform Circular Motion An object moving at a constant speed v (m/s), in a circle of radius r (m), experiences a centripetal acceleration Pg. 126 #5, 6

Circular Motion If an object moves in a circle with a period, T (s); at a frequency, f (Hz): Pg. 126 #8, 10

Graph the relationship between the magnitude of centripetal acceleration and the radius of rotation (at a constant frequency) Two balls at the ends of two strings are moving at the same speed in horizontal circular paths. One string is three times as long as the other. Compare the magnitudes of the two centripetal accelerations.

Calculate the magnitude of the centripetal acceleration: A coin is placed flat on a vinyl record, turning at rpm. The coin is 8 cm from the centre of the record.

Forces in Circular Motion (Part 1) Textbook: 3.2

Forces in circular motion

Forces in circular motion

Ex. A 2. 00-kg stone attached to a rope 4 Ex. A 2.00-kg stone attached to a rope 4.00 m long is whirled in a circle horizontally on a frictionless surface, completing 5.00 revolutions in 2.00 s. Calculate the magnitude of tension in the rope. [1.97 x 103 N]

A 0. 2 kg mass is spinning at a rate of 66 rpm A 0.2 kg mass is spinning at a rate of 66 rpm. The length of the rope is 0.3 m. Determine the angle that the rope makes with the vertical.

An 82-kg pilot flying a stunt airplane pulls was doing a loop de loop at a constant speed of 540 km/h. (a) What is the minimum radius of the plane’s circular path if the pilot’s acceleration at the lowest point is not to exceed 7.0g ? (b) What force is applied on the pilot by the plane seat at the lowest point in the pullout? (c) What is the apparent weight of the pilot at the top of the loop

Forces in Circular Motion (Part 2) Textbook: 3.2

Leveled Curve As objects travel around leveled curves, it is static friction that keeps the objects from skidding.

Banked Curve Banked curves are used to reduce the reliance on friction and reduce the radius of curvature. No friction

Banked Curve With Friction

Ex. Determine the minimum radius needed to round a leveled curve at 100 km/h with a coefficient of static friction, [r = 606 m]

Ex. Determine the minimum radius needed to round a frictionless banked curve at 100 km/h. The curve is banked at 20o. r = 216 m