Exercise 1-1: Generate p-T diagram for C1, CO2 and C8.

Slides:



Advertisements
Similar presentations
Properties of a Pure Substance
Advertisements

SELECTING THERMODYNAMIC PROPERTY METHODS
PVT Short Course for Cairo University SPE Student Chapter Ahmed Muaz Khalda Petroleum Company April 23, 2011.
Properties of Reservoir Fluids Fugacity and Equilibrium Fall 2010 Shahab Gerami 1.
Phase Behavior Solid Organic Precipitation and Mobility Characterization Studies in Support of Enhanced Viscous Oil Recovery On Alaska North Slope
Chapter 12 Gas-Liquid Equilibrium
PETE 310 Lectures # 32 to 34 Cubic Equations of State …Last Lectures.
Chemstations, Inc – Houston, TX – – An Overview of Process Simulation What is needed? What are the steps?
The Advanced Chemical Engineering Thermodynamics The retrospect of the science and the thermodynamics Q&A -1- 9/16/2005(1) Ji-Sheng Chang.
Q&A_ /17/2005(10) Ji-Sheng Chang
Chapter 3 Properties of a Pure Substance
Advanced Thermodynamics Note 9 Vapor/Liquid Equilibrium: Introduction
Three & Multicomponent Mixtures…
MEL140 Properties of pure substances. Pure substance A pure substance has the same chemical composition throughout. Are the following confined in a fixed.
TOPIC : Introduction to Functional Modeling UNIT 1: Modeling Digital Circuits Module 1 : Functional Modeling.
Calculation BIM Curriculum 07. Topics  Calculation with BIM  List Types  Output.
Evaluation of Wax Deposition and Its Control During Production of Alaska North Slope Oils Annual Report Jan – Dec, 2006 University of Alaska Fairbanks.
SURFACE PRODUCTION OPERATIONS - INTRODUCTION TO SURFACE PROCESSING2 min - THERMODYNAMIC PHASE EQUILIBRIUM5 min - UNIT OPERATIONS8 min - FLOW OPTIMISATION5.
Department of Mechanical Engineering ME 322 – Mechanical Engineering Thermodynamics Lecture 5 Thermodynamic Properties.
Physical and chemical equilibrium of CO2-Water-Mineral system using Aspen Plus process simulator Technical University of Delft Ali Akbar Eftekhari Hans.
Advance Chemical Engineering Thermodynamics By Dr.Dang Saebea.
1 S. OLADYSHKIN, M. PANFILOV Laboratoire d'Énergétique et de Mécanique Théorique et Appliquée Ecole Nationale Supérieure de Géologie Institut National.
TransAT Tutorial Separation of Oil, Gas & Water July 2015 ASCOMP
PETE 310 Lecture # 26 Chapter 12 Gas-Liquid Equilibrium Non-ideal VLE.
1 CHEM-E7130 Process Modeling Exercise Multicomponent mass transfer.
공정 열역학 Chapter 3. Volumetric Properties of Pure Fluids
TransAT Tutorial Backward Step May 2015 ASCOMP
Advanced PVT Course Curtis Hays Whitson Organized by HOT Engineering Vienna, Austria May 9–13, 2016.
Day 4 – Part 1: Lumping and De-lumping
Heptanes-Plus Characterization
Day 2 – Part 2: Equation of State Models.
Day1 – Part2 PVT measurements Fluid sampling methods
RESERVOIR ENGINEERING
Process Design Course Using the NIST, DIPPR and DDBSP databases for Finding Physical, Chemical and Thermodynamic Properties Process Design Course.
Gas Condensate PVT – What’s Really Important and Why?
Saudi Aramco – Course in Advanced Fluid PVT Behavior
공정 열역학 Chapter 6. Thermodynamic Properties of Fluids
BTS430 Systems Analysis and Design using UML
Gas Properties & PVT Tests
Tasks Collecting samples. Which PVT lab tests to use.
Equations of State for Gas Condensates
Understanding Hydrocarbon Fluid Properties and Behavior
QC checks on composition
STA 282 Introduction to Statistics
Gas Condensate PVT A worked example to estimate
Accurate fluid samples are needed to define fluids in place, especially condensate volume. Separator samples should almost always be used for gas condensate.
Gas Condensate PVT C7+ fraction in CVD Liquid saturation in CVD
CCE and CVD results The usual PVT measurements on gas condensates are
Global Component Lumping for EOS Calculations
Gas Condensate Reservoirs
Gas Condensate Blockage
Lecture # 26 Chapter 12 Gas-Liquid Equilibrium Non-ideal VLE
CCE and CVD results The usual PVT measurements on gas condensates are
Use Quality-Controlled PVT data to set up an EoS model of the reservoir. Ensure that gas Z-factors and C7+ content of the gas are matched accurately.
Gas Condensate Blockage
Chapter 12 Gas-Liquid Equilibrium
Gas Condensate PVT C7+ fraction in CVD Liquid saturation in CVD
Gas Condensate Blockage
Gas Condensate Reservoirs
CALCULATING EQUATION OF LEAST SQUARES REGRESSION LINE
Liquid saturation in CVD
Rate of Change The rate of change is the change in y-values over the change in x-values.
Software Effort Estimation
Use Quality-Controlled PVT data to set up an EoS model of the reservoir. Ensure that gas Z-factors and C7+ content of the gas are matched accurately.
Gas Condensate PVT A worked example to estimate
ADVANCED THERMODYNAMICS 8th semester
QC checks on composition
Liquid saturation in CVD
Gas Condensate Reservoirs
QC checks on composition
Presentation transcript:

Exercise 1-1: Generate p-T diagram for C1, CO2 and C8. Course in Advanced Fluid Phase Behavior. © Pera A/S

Exercise 1-1: p-T diagram for C1, CO2 and C8. Course in Advanced Fluid Phase Behavior. © Pera A/S

PVT Simulators - Introduction Equation of State Calculations Input Component description (critical properties) Fluid composition Thermodynamic conditions (p, T) Output Equilibrium calculations (phase split & compositions) Fluid PVT properties (e.g. density, viscosity, etc.) PVT Simulator Course in Advanced Fluid Phase Behavior. © Pera A/S

PVT Simulators - Introduction Generation of Fluid Characterizations Input Component description (critical properties) Fluid compositions PVT Measurements: DLE CCE CVD SEP VISCOSITY Result EOS characterization model (compositional model). Black oil PVT models (black oil tables). PVT Simulator Tuning (Regression) Updated component properties. Modified compositions. Course in Advanced Fluid Phase Behavior. © Pera A/S

PVT Simulators – PhazeComp PhazeComp User Interaction PhzGUI.xls MS Excel Input File (Ascii) Characterization Compositions Experiments Result File (Ascii) Sim results EOS properties PVT properties etc. PhazeComp PhazeComp.exe *.phz *.out Course in Advanced Fluid Phase Behavior. © Pera A/S