Always stay out of the line of fire

Slides:



Advertisements
Similar presentations
Always start a vehicle correctly
Advertisements

Always use the correct lifting equipment
PDO Second Alert What happened? Your learning from this incident..
Always ensure travelling block is stationary during DM changeover
Always use mechanical handling aids when carrying out a heavy lift
Always use 3 points of contact when using ladders
Never intervene to correct obstacles without stopping the activity
Always ensure the right tools are used for the task
PDO Second Alert Date: Incident : LTI What happened?
Comply with Safe Operating Procedures
PDO Second Alert Valves open Valve closed Valves open Valve open
Don’t pull a twisted sling
Always stay out of the line of fire
Never place yourself in line of fire
PDO Second Alert Date: Incident title: Fall from Height
PDO Second Alert Stay out of the line of fire What happened:
Drive with appropriate speed to road conditions
Identify Pinch Points and keep your Hands & Fingers away
Use right tools for the job and use them correctly
Do not work at height without fall protection
PDO Second Alert Date: Incident type: LTI What happened?
Follow Management of Change for an activity which is not in permit
Keep away form ‘line of fire’
Keep away from “Line of Fire”
Always use the correct tools for the job
Always use the right equipment for the task !!!!
Check & avoid potential Pinch points
Ensure OHL Clearance required for your lifting activity
PDO Second Alert Date: Incident Type: LTI What happened?
No hands on elevator while delivering pipe
Never put your Hands in line of fire
LTI: Finger Crush Injury Hands off suspend loads “Use Tagline”
Ensure cat line are under tension before removing elevator bolts
PDO Second Alert Date: Incident title: Fatality What happened?
PDO Second Alert Date: Incident title: LTI What happened?
Adequate tethered tools
PDO Second Alert Always follow the PTW procedures
Pay attention to your footing
Unsecured pup joint falling
PDO Second Alert Date: Incident: LTI What happened?
PDO Second Alert Use Hands Free Lifting Aids What happened?
Always report Near Misses
Keep your hands in a safe position
Never place yourself in “line of fire”
Always keep your hands away from crush points (Line of Fire)
Always use your hands to set the slips
Always assess the risks, Stop and think.
Always stay away from line of fire
Tubing hanger must always be assembled in horizontal position.
PDO Second Alert What happened? Your learning from this incident..
When operating the Tongs under tension, make sure all crew keep clear
Injury : fractured finger Keep your hands out of the line of fire
PDO Second Alert Date: Incident title: HiPo What happened?
Always ensure “no go” zone are in place
Check equipment prior to start the job
Always be vigilant while moving across well site location
Seek assistance of Banksman while reversing the vehicle
PDO Safety Advice Date: 23/08/2015 Injury: Fractured fingers
PLAN AND DOCUMENT CHANGES TO THE OPERATION
Always keep your hands and fingers away from the Line of Fire
Always keep your equipment maintained
Always isolate equipment before beginning maintenance tasks
Check Level Setup prior Lifting & Lowering Operation
Always adhere to Red/No Go zones
Use the correct lifting device for the load
Keep away from “Line of Fire”
Always position the crane boom correctly before slinging the casing
Keep away from the line of fire
Keep hands out of the line of fire
Use hands-off where possible
Presentation transcript:

Always stay out of the line of fire PDO Second Alert Date: 13-02-2018 Finger Crush Injury What happened? While installing a new winch line a Roustabout (RA) was helping the Derrick man to guide the sling into place. As the RA moved into position the fall arrestor post failed resulting it in folding down crushing his left hand index finger. Your learning from this incident.. Always ensure you keep hands away from pinch point area Ensure effective preventive maintenance in place for all the equipment Ensure SOP available for all non-routine tasks Always ensure adequate supervision Ensure all hazards are identified prior to the task Ensure using proper and required PPE for the task (use empowerment to STOP work if the required PPE is not available) Do not stand in line of fire or in between moving parts (Fall arrestor post in upright position) Always ensure fall arrestor post in folded position before working in mast and stay away from line of fire Always stay out of the line of fire

Management self audit Date: 13/02/2018 Finger Crush Injury As a learning from this incident and to ensure continual improvement all contract managers must review their HSE HEMP against the questions asked below Confirm the following: Do you have PMS in place related to all equipment or moving parts (Fall Arrestor Damping unit)? Do you have pre-Rig/Down checklist which includes function test of damping unit? Do you have SOP for installation of new winch line in rig down position? Do you ensure your teams are aware of all the hazards and risk mitigation during your Tool Box Talks? Do you have right procedure for working at height and emergency evacuation from height? Do you have enough full body harness at site and maintained in good condition? Do you ensure pinch point register is kept up to date? Make a list of closed questions (only ‘yes’ or ‘no’ as an answer) to ask other contractors if they have the same issues based on the management or HSE-MS failings or shortfalls identified in the investigation. Pretend you have to audit other companies to see if they could have the same issues.