Injection mold specification Client fuji Model Name Fuji-xerox Part Name Cover under r Part No. 802b086500_k001 DFM Ming L.

Integral Corrective Action List ICAL Page OPEN POINTS SOLUTIONS/ACTION WHO 1 2 3 4 Plastic Flow Analysis Ok? Parting _ line-1 Please confirm. 5 Parting _ line-2 6 Parting _ line-3 7 SLIDE 8 SLANT 9 MODIFY1 Waiting for reply. 10 MODIFY2 11 MODIFY3 12 MODIFY4 13 MODIFY5 14 15 I C A L Integral Corrective Action List 1-Date of opening (all dates in2005) 2-Date of beginning of action 3-Date foreseen for validation 4-Date of validation (closing) DFME Follow-up issue

Plastic Flow Analysis SIDE GATE

Parting _ line-1 cavity core cavity Parting-surface core

Parting _ line-2 (right&left)

Parting _ line-3

SLIDE

SLANT

Slide steel is too thin,suggest modify it as view A.(RIGIG&LEFT) 0.5 SLIDE Slide steel is too thin,suggest modify it as view A.(RIGIG&LEFT) (REDUCE PLASTIC) View A MODIFY ORIGINAL

MODIFY2 Reduce plastic 3mm. Steel is too thin. 1.8 3 16.5

The grid surface(all around) has no draft.suggest reduce MODIFY3 The grid surface(all around) has no draft.suggest reduce plastic 2º to release mold.

All of green surface have no draft.suggest reduce plastic MODIFY4 All of green surface have no draft.suggest reduce plastic to release mold as VIEW A. REDUCE PLASTIC VIEW A

These red surfaces can’t texture because MODIFY5 These red surfaces can’t texture because of it just have 1º draft on slide side.